840MW Search Results

Applications Note U-137

Contextual Info: y UNITRODE UCC1776 UCC2776 UCC3776 PRELIMINARY Quad FET Driver FEATURES DESCRIPTION • High Peak Output Current Each Output - 1.5A Source, 2.0A Sink • W ide Operating Voltage Range 4.5V to 18V • Thermal Shutdown • CMOS Compatible Inputs • Outputs Are Active Low

diode d07

Abstract: 685V
Contextual Info: TS5214 300mA Low Noise LDO Voltage Regulator SOT-23 Pin Definition: SOT-89 SOT-223 1. Output 2. Input 3. Ground Pin Definition: TS5214 TS5214A 1. Output 1. Ground 2. Ground 2. Input 3. Input 3. Output SOP-8 Pin Definition: 1. Input 8. Output 2. Ground 7. Ground

Contextual Info: UCC1776 UCC2776 UCC3776 UNITRODE Quad FET Driver PRELIMINARY FEATURES DESCRIPTION • High Peak Output Current Each Output - 1 .5A Source, 2.0A Sink The UCC3776 is a four output BCDMOS buffer/driver designed to drive highly capacitive loads such as power MOSFET gates at high speeds. The

airpax M82102-P2

Abstract: M82102-P2 tc4469 brushless 4266V Airpax stepper motor 48volt power supply applications Airpax motor airpax stepper 12v M82102-P2
Contextual Info: ie lw o m Tradfi7 Semiconductor, Inc. iU 4 4 o / TC4468 TC4469 LOGIC-INPUT CMOS QUAD DRIVERS FEATURES GENERAL DESCRIPTION • ■ ■ ■ ■ ■ The TC446X family of four-output CMOS buffer/drivers are an expansion from our earlier single- and dual-output

transistor C 5386

Contextual Info: leluom Semiconductor, Inc. TC4467 TC4468 TC4469 LOGIC-INPUT CMOS QUAD DRIVERS FEATURES • ■ ■ ■ ■ ■ ■ High Peak Output C urrent. 1.2A Wide Operating Range. 4.5 to 18V Symmetrical Rise and Fall Times.25nsec

pms 01c

Abstract: BQ20Z65-R1
Contextual Info: bq20z65-R1 www.ti.com SLUS990 – DECEMBER 2009 SBS 1.1-COMPLIANT GAS GAUGE AND PROTECTION ENABLED WITH IMPEDANCE TRACK Check for Samples: bq20z65-R1 FEATURES APPLICATIONS • • • • 1 2 • • • • • • • • • • • Next Generation Patented Impedance Track™

EEPROM 64K x 16

Abstract: DP645
Contextual Info: 005402 Hm t p‘ Dense-Pac 'Microsystems, Inc. EEPROM DPE1124A 64K X 16 DESCRIPTION: The DPE1124-200, -250, -300, -350 is a 65,536 X 16 or 131,072 X 8 bit E le ctrically Erasable Programmable Read-Only Memory EEPRO M ). This memory sub­ system is a 56 pin D IP w hich contains sixteen 8 K X 8

Contextual Info: EVALUATION KIT AVAILABLE MAX2667/MAX2669 GPS/GNSS Ultra-Low-Noise-Figure LNAs General Description Features The MAX2667/MAX2669 high-gain, low-noise amplifiers LNAs are designed for GPS L1, Galileo, and GLONASS applications. Designed in Maxim’s advanced SiGe process, the devices achieve a high gain and our lowest

BQ20Z65-R1

Abstract: SLUS990
Contextual Info: bq20z65-R1 www.ti.com SLUS990 – DECEMBER 2009 SBS 1.1-COMPLIANT GAS GAUGE AND PROTECTION ENABLED WITH IMPEDANCE TRACK Check for Samples: bq20z65-R1 FEATURES APPLICATIONS • • • • 1 2 • • • • • • • • • • • Next Generation Patented Impedance Track™

ISL3221

Abstract: EIA-232 IEC1000-4-2 MAX3221E SP3220 SP3220E SP3220EB SP3220EU SP3220EET sp3220b
Contextual Info: SP3220E/EB/EU +3.0V to +5.5V RS-232 Driver/Receiver Pair • Meets All EIA-232 and ITU V.28 Specifications from a wide +3.0V to +5.5V power supply EN ● Interoperable with RS232 and V.28 at 2.7V C1+ ■ Supports High Serial DataRates: ● 120 kbps SP3220E

b93 02 diode

Abstract: 02 b93 diode ABG TRANSISTOR ACB SOT23-6 MAXIM AMP DIODE B93 DUAL NPN SOT23-6 MAX6471 MAX6474 MAX6477 MAX6479
Contextual Info: 19-2532; Rev 6; 2/11 KIT ATION EVALU E L B AVAILA 300mA LDO Linear Regulators with Internal Microprocessor Reset Circuit The MAX6469–MAX6484 are low-dropout linear regulators with a fully integrated microprocessor reset circuit. Each is available with preset output voltages from +1.5V

op amp ua 745

Abstract: ua 745 op amp dual op-amp reference tc431 2N2222 dip 2N2222 TC43 TC43COR TC43CPR TC43EOR
Contextual Info: LINEAR BUILDING BLOCK – VOLTAGE REFERENCE, DUAL OP AMP, EVALUATION DUAL COMPARATOR WITH SHUTDOWN MODE PRELIMINARY INFORMATION KIT AVAILABLE TC43 TC43 LINEAR BUILDING BLOCK – VOLTAGE REFERENCE, DUAL OP AMP, DUAL COMPARATOR WITH SHUTDOWN MODE FEATURES GENERAL DESCRIPTION

Contextual Info: MAX44284 36V, Input Common-Mode, High-Precision, Low-Power Current-Sense Amplifier General Description The MAX44284 is a high-side, current-sense amplifier that operates with a 1.7V to 5.5V single supply and is optimized for very low power operation with only 21µA of

Contextual Info: 19-5708; Rev 0; 12/10 KIT ATION EVALU E L B A IL AVA Ultra-Low Power Op Amp in a Tiny 6-Bump WLP The MAX44264 is an ultra-small 6-bump WLP op amp that draws only 750nA of supply current. It operates from a single +1.8V to +5.5V supply and features ground-sensing inputs and rail-to-rail output. The ultralow supply current, low-operating voltage, and rail-torail output capabilities make these operational

SP3221E

Contextual Info: SP3220E | SIGNAL PROCESSING EXCELLENCE +3.0V to +5.5V RS-232 Driver/Receiver Pair • Meets True RS-232 Protocol Operation From A +3.0V to +5.5V Power Supply ■ 235kbps Data Rate Under Load ■ 1jaA Low-Power Shutdown With Receivers Active ■ Interoperable With RS-232 Down To

Contextual Info: reluom PRELIMINARY INFORMATION Semiconductor, Inc. TC43 LINEAR BUILDING BLOCK-VOLTAGE REFERENCE, DUAL OP AMP, DUAL COMPARATOR WITH SHUTDOWN MODE FEATURES GENERAL DESCRIPTION • The TC43 is a mixed-function device combining two general purpose op amps, two general purpose compara­

Contextual Info: Low phase noise, Dual 1-to-6, 3.3V, 2.5V LVPECL Output Fanout Buffer IDT8SLVP2106I DATASHEET General Description Features The IDT8SLVP2106I is a high-performance differential dual 1:6 LVPECL fanout buffer. The device is designed for the fanout of high-frequency, very low additive phase-noise clock and data signals.

Contextual Info: CMOS Video Multiplexer/Amplifier G en eral Description ♦ ♦ ♦ ♦ ♦ ♦ ♦ The MAX452 is a unity-gain stable, 50MHz video amplifier capable of driving a 75 ohm load directly. The MAX453, MAX454, and MAX455 combine the 50MHz video ampli­

Airpax stepper motor

Abstract: airpax stepper 12v M82102-P2 M82102-P2 airpax stepper 12v airpax step motor 7.5 airpax 5 volt stepper motor airpax M82102-P2 7.5 stepper motor airpax 12v airpax stepper motor 17 volts TC4469
Contextual Info: TC4467 TC4468 TC4469 LOGIC-INPUT CMOS QUAD DRIVERS 2 FEATURES GENERAL DESCRIPTION • ■ ■ ■ ■ ■ The TC446X family of four-output CMOS buffer/drivers are an expansion from our earlier single- and dual-output drivers. Each driver has been equipped with a two-input

SLUS878

Contextual Info: bq20z65 www.ti.com. SLUS878 – JULY 2009 SBS 1.1-Compliant Gas Gauge and Protection Enabled With Impedance Track

TS5204CX33

Abstract: 36 V INPUT LOW-DROPOUT LINEAR REGULATOR marking 43 sot-89 RF transistor marking IN SOT-89 TS5204
Contextual Info: TS5204 150mA Low Noise LDO Voltage Regulator SOT-23 Pin Definition: 1. Output 2. Input 3. Ground SOT-89 Pin Definition: 1. Output 2. Ground 3. Input General Description The TS5204 series is an efficient linear voltage regulator with ultra low noise output, very low dropout voltage

Contextual Info: 19-2021; Rev 4; 7/11 Single/Dual/Quad, +1.8V/750nA, SC70, Rail-to-Rail Op Amps Features ♦ ♦ ♦ ♦ ♦ ♦ ♦ Ultra-Low 750nA Supply Current Per Amplifier Ultra-Low +1.8V Supply Voltage Operation Ground-Sensing Input Common-Mode Range Outputs Swing Rail-to-Rail

Contextual Info: 19-2532; Rev 6; 2/11 KIT ATION EVALU E L B AVAILA 300mA LDO Linear Regulators with Internal Microprocessor Reset Circuit Features The MAX6469–MAX6484 are low-dropout linear regulators with a fully integrated microprocessor reset circuit. Each is available with preset output voltages from +1.5V

TS5204

Abstract: TS5204CX33 voltage regulator SOT-23 RF transistor marking IN SOT-89
Contextual Info: TS5204 150mA Low Noise LDO Voltage Regulator SOT-23 Pin Definition: 1. Output 2. Input 3. Ground SOT-89 Pin Definition: 1. Output 2. Ground 3. Input General Description The TS5204 series is an efficient linear voltage regulator with ultra low noise output, very low dropout voltage