Part Number
    Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    WIDLA Search Results

    Documents mentioning WIDLA

    Document Partial File Text Tags Type PDF
    urm Application Note 16 TECHNOLOGY August 1985
    urm Application Note 16 TECHNOLOGY August 1985 Unique 1C Buffer Enhances Op Amp Designs, Tames Fast Amplifiers Robert J. Widlar a bstract: A unity gain 1Cpower buffer that uses NPN out­ put transistors while avoiding the usual problems of quasi-compiementary designs is described. Free of para­
    OCR Scan PDF
    widlar
    National Semiconductor Linear Brief 6 May 1969 Robert J Widlar Apartado Postal 541 Puerto Vallarta Jalisco Mexico Monolithic voltage comparators are available today which are both fast and accurate They can detect the height of a pulse with a 5 mV accuracy within 40 ns However these
    Original PDF
    widlar
    New Op Amp Ideas National Semiconductor Application Note 211 Robert J. Widlar Robert C. Dobkin Mineo Yamatake December 1978 New Op Amp Ideas Abstract An op amp and voltage reference capable of single supply operation down to 1.1V is introduced. Performance is uncompromised and compares favorably with standard,
    Original PDF
    widlar
    Robert J Widlar Apartado Postal 541 Puerto Vallarta Jalisco Mexico A feedforward compensation method increases the slew rate of the LM101A from 0 5 ms to 10V ms as an inverting amplifier This extends the usefulness of the device to frequencies an order of magnitude higher than the standard
    Original PDF
    widlar
    Robert J Widlar Apartado Postal 541 Puerto Vallarta Jalisco Mexico Abstract An op amp and voltage reference capable of single supply operation down to 1 1V is introduced Performance is uncompromised and compares favorably with standard state-of-the-art devices In a departure from conventional approaches the circuit can operate in a floating
    Original PDF
    widlar
    National Semiconductor Application Note 4 Robert J. Widlar April 1968 Introduction Operational amplifiers are undoubtedly the easiest and best way of performing a wide range of linear functions from simple amplification to complex analog computation. The cost of monolithic amplifiers is now less than $2.00, in large
    Original PDF
    446b
    National Semiconductor Application Note 446B April 1998 Robert J. Widlar Apartado Postal 541 steady-state conditions increases guaranteed power ratings by several times when compared to older techniques. At the same time, it dramatically lowers the peak junction temperature with worst-case fault conditions.
    Original PDF
    Robert J. Widlar Apartado Postal 541 Puerto
    Robert J. Widlar Apartado Postal 541 Puerto Vallarta, Jalisco, Mexico sistor array. The turn-on characteristics are controlled by keeping the output open-circuited until the total supply voltage reaches 15V. The output is also opened should the case temperature exceed 150˚C or as the supply voltage approaches the BVCEOof the output transistors. The IC withstands overvoltages to 100V.
    Original PDF
    widlar
    National Semiconductor Application Note 29 December 1969 Robert J Widlar Apartado Postal 541 Puerto Vallarta Jalisco Mexico abstract A monolithic operational amplifier having input error currents in the order of 100 pA over a b55 C to 125 C temperature range is described Instead of FETs the circuit used
    Original PDF
    widlar
    National Semiconductor Application Note 446 March 1986 Robert J Widlar Apartado Postal 541 Puerto Vallarta Jalisco Mexico Mineo Yamatake National Semiconductor Corp Santa Clara California Abstract A power op amp capable of driving g35V at g10A has been fabricated on a single silicon chip Peak
    Original PDF
    widlar
    Low Voltage Techniques Low Voltage Techniques National Semiconductor Technical Paper 14 December 1978 Robert J Widlar Apartado Postal 541 Puerto Vallarta Jalisco Mexico Abstract A micropower operational amplifier is described that will operate from a total supply voltage of 1 1V The
    Original PDF
    widlar
    National Semiconductor Application Note 42 February 1971 Robert J Widlar Apartado Postal 541 Puerto Vallarta Jalisco Mexico introduction Because of the relatively high current requirements of digital systems there are a number of problems associated with using one centrally-located regulator Heavy power busses
    Original PDF
    widlar
    Robert J Widlar Apartado Postal 541 Puerto Vallarta Jalisco Mexico Abstract An IC op amp design that reduces bias currents below 100 pA over a b55 C to a125 C temperature range is discussed Super-gain bipolar transistors with on-wafer trimming are used providing low offset voltage and drift
    Original PDF
    widlar
    National Semiconductor Linear Brief 12 January 1970 Robert J Widlar Apartado Postal 541 Puerto Vallarta Jalisco Mexico The IC voltage comparators available in the past have been designed primarily for low voltage high speed operation As a result these devices have high input error currents which
    Original PDF
    widlar
    Precision IC Comparator Runs from a 5V Logic Supply Precision IC Comparator Runs from a 5V Logic Supply National Semiconductor Application Note 41 October 1970 Robert J Widlar Apartado Postal 541 Puerto Vallarta Jalisco Mexico introduction In digital systems it is sometimes necessary to convert low
    Original PDF
    widlar
    National Semiconductor Application Note 446A 446A February 1987 Robert J Widlar Apartado Postal 541 Puerto Vallarta Jalisco Mexico Mineo Yamatake National Semiconductor Corporation Santa Clara California Abstract Safe-area protection can be provided for a large
    Original PDF
    widlar
    National Semiconductor Application Note 41 Robert J. Widlar October 1970 Introduction and the signal on the other. Clearly, an op amp can be used as a comparator, except that its response time is in the tens of microseconds which is often too slow for many applications.
    Original PDF
    Robert J Widlar Apartado Postal 541 Puerto
    Robert J Widlar Apartado Postal 541 Puerto Vallarta Jalisco Mexico Abstract New developments have dramatically reduced the error currents of IC op amps especially at high temperatures The basic techniques used to obtain this peformance are briefly described Some of the problems associated with
    Original PDF
    widlar
    National Semiconductor Application Note 242 April 1980 Robert J Widlar Apartado Postal 541 Puerto Vallarta Jalisco Mexico Bob Pease and Mineo Yamatake National Semiconductor Corporation Santa Clara California USA Abstract A new bipolar op amp design has advanced the
    Original PDF
    widlar
    National Semiconductor Application Note 42 Robert J. Widlar February 1971 Introduction transistor, there is no convenient way to sense junction temperature so it is much more difficult to provide thermal limiting. Thermal protection is, in itself, a very good reason
    Original PDF
    National Semiconductor Application Note 242
    National Semiconductor Application Note 242 Robert J. Widlar Bob Pease Mineo Yamatake April 1980 Abstract: A new bipolar op amp design has advanced the state of the art by reducing offset voltage and bias current errors. Its characteristics are described here, indicating an
    Original PDF
    widlar
    The Monolithic Op Amp Monolithic Op Amp Universal Linear Component National Semiconductor Application Note 4 April 1968 Robert J Widlar Apartado Postal 541 Puerto Vallarta Jalisco Mexico C1995 National Semiconductor Corporation TL H 7357 TL H 7357 – 1 Figure 1 Free-running multivibrator
    Original PDF
    national semiconductor application note 29
    National Semiconductor Application Note 29 Robert J. Widlar September 2002 Note: National Semiconductor recommends replacing 2N2920 and 2N3728 matched pairs with LM394 in all application circuits. mance is often limited by leakages in capacitors, diodes, analog switches or printed circuit boards, rather than by the
    Original PDF
    widlar
    Robert J Widlar Apartado Postal 541 Puerto Vallarta Jalisco Mexico There are quite a few applications where op amps are used as voltage followers These include sample and hold circuits and active filters as well as general purpose buffers for transducers or other high-impedance signal sources The
    Original PDF
    widlar
    National Semiconductor Application Note 23 January 1969 Robert J Widlar Apartado Postal 541 Puerto Vallarta Jalisco Mexico introduction IC voltage regulators are seeing rapidly increasing usage The LM100 one of the first has already been widely accepted Designed for versatility this circuit can be used as a
    Original PDF