VFLB Search Results

BC490B

Abstract: BC488 BC488A BC488L BC490 BC490A BC556 BC556A BC556B BC557
Contextual Info: TO-92 Plastic Package Transistors PNP Ma* irnum Ratings Type No. BC4S6L ^032 (V) Min 45 V CE0 M Min Electrical C haracteristics (Ta=25’ C, Unless O therw ise Specified) VflBO (W) (V) Min @Tc=25° 45 4 0.625 (A) 1 'cBO ^CB (UÀ) (V Max 0.1 ^C£S V CE

MTV030nxx

Abstract: 20111 mtv030n-xx 150M MTV030 N201 MYSON TECHNOLOGY REG28
Contextual Info: MYSON TECHNOLOGY MTV030 On-Screen Display with Auto-Sizing Controller FEATURES GENERAL DESCRIPTION • Horizontal SYNC input up to 150 KHz. • On-chip PLL circuitry up to 150 MHz. • Minimum timing measurement among HFLB, VFLB, RIN, GIN and BIN for auto sizing.

MTV030N201

Abstract: wh30 12x16 mtv030n MYSON TECHNOLOGY
Contextual Info: MYSON TECHNOLOGY MTV030 On-Screen Display with Auto-Sizing Controller FEATURES GENERAL DESCRIPTION • Horizontal SYNC input up to 150 KHz. • On-chip PLL circuitry up to 150 MHz. • Minimum timing measurement among HFLB, VFLB, RIN, GIN and BIN for auto sizing.

BC488

Abstract: BC488A BC488L BC490 BC490A BC490B BC556 BC556A BC556B BC557
Contextual Info: TO-92 Plastic Package Transistors PNP Ma* irnum Ratings Type No. BC4S6L ^032 (V) Min 45 V CE0 M Min Electrical C haracteristics (Ta=25’ C, Unless O therw ise Specified) VflBO (W) (V) Min @Tc=25° 45 4 0.625 (A) 1 'cBO ^CB (UÀ) (V Max 0.1 ^C£S V CE

WSP-401M

Abstract: BD103 dms-200d bd102 transisTOR C123 2N5401C-Y DG04 rsb7 sk101 S1D2514X01
Contextual Info: S1D2514X01 Preliminary VIDEO AMP MERGED OSD PROCESSOR FOR MONITORS VIDEO AMP MERGED OSD PROCESSOR 32-DIP-600A The S1D2514X01 is a very high frequency video amplifier & wide range OSD processor 1 chip system with I2C Bus control used in monitors. It contains 3 matched R/G/B video

SAA7119

Abstract: saa7154 RSN 309 W 44H SAA7154H SAA7154E SAA7118 An RTCO 7AH SPLPL9 myson mtv048 SAA7154E/V2
Contextual Info: SAA7154E; SAA7154H Multistandard video decoder with comb filter, component input and RGB output Rev. 02 — 6 December 2007 Product data sheet 1. General description The SAA7154E; SAA7154H is a high-quality multistandard video decoder supporting 10-bit Analog-to-Digital Converter ADC , enhanced PAL/NTSC comb filtering, more

2N3904

Abstract: KS2508 S5D2508A
Contextual Info: S5D2508A OSD PROCESSOR FOR MONITOR OVERVIEW 16-DIP-300 The S5D2508A is used to display some characters or symbols on a screen of monitor. Basically, the operation is to control the internal memory on chip and generate the R,G,B signals for some characters or symbols. The R,G,B signals are synchronized with the horizontal sync. Then the R,G,B signals are

WPR20

Abstract: osd font S5D2510
Contextual Info: OSD PRESSOR FOR MONITOR PRELIMINARY S5D2510 PRODUCT SUMMARY INTRODUCTION S5D2510 is a stand-alone OSD Processor, which is used to display monitor adjustment or status information as a certain character or symbol on screen. Its basic operation includes making the R/ G/ B signal for the character or

Contextual Info: JW- 8 9 1993 H a r r is a H I 1Ë 1t 6 6 Ê È È S E M I C O N D U C T O R 8-Bit, 250MSPS Flash A/D Converter ju iy 1993 Features • Description Differential Linearity Error ±0.5 LSB or Less The HI1166 is an 8-bit ultra high speed flash Analog-to-Digital converter IC capable of digitizing analog signals at a max­

16L88

Abstract: PALC20 PALC16R6-20DMB cypress 16R4 PALC16L8-30DMB 16L8 16R4 16R6 16R8 PALC16R6-30DMB
Contextual Info: 256=^2 ooQb^o s d c y p MbE D CYPRESS SEMICONDUCTOR PAL C20 Series ~ SEMICONDUCTOR Features • CMOS EPROM technology for « p ro ­ grammability • High performance at quarter power • — tpo = 25 ns — ts = 20 ns — tco = 15 ns — Ice = 45 mA • High performance at military

Contextual Info: Data Sheet 29319.26 3961 DUAL FULL-BRIDGE PWM MOTOR DRIVER Designed for pulse-width modulated PWM current control of bipolar stepper motors, the A3961S— is capable of continuous output currents to ±800 mA and operating voltages to 45 V. Internal fixed

PA2454NL

Abstract: lt3575 PA2456NL pa2362nl bsc flyback universal flyback snubber GRM32ER71A476 LT3574 PA2364NL PA2455NL
Contextual Info: LT3575 Isolated Flyback Converter without an Opto-Coupler FEATURES DESCRIPTION n The LT 3575 is a monolithic switching regulator specifically designed for the isolated flyback topology. No third winding or optoisolator is required for regulation. The part senses the isolated output voltage directly from the

Tesla aza 055

Contextual Info: NCP1215 Low Cost Variable OFF Time Switched Mode Power Supply Controller The NCP1215 is a controller for low power off−line flyback Switchemode Power Supplies SMPS featuring low size, weight and cost constraints together with a good low standby power performance.

CMZ5934B

Abstract: 750311564
Contextual Info: LT8302 42VIN Micropower No-Opto Isolated Flyback Converter with 65V/3.6A Switch Features Description 2.8V to 42V Input Voltage Range n 3.6A, 65V Internal DMOS Power Switch n Low Quiescent Current: 106µA in Sleep Mode 380µA in Active Mode n Quasi-Resonant Boundary Mode Operation at

Contextual Info: u n _ m m TECHNOLOGY s » Isolated F lyback S w itching R egulator KfìTUlKS DCSCRIPTIOn • No Transformer “Third Winding” or Optoisolator Required ■ ±5% Accurate Output Voltage Without User Trims See Circuit Below

myson mtv

Abstract: HORD5
Contextual Info: MYSON TECHNOLOGY MTV004 On-Screen Display Shrink Version FEATURES • • • • • • • • • • • • • • • • On-chip phase lock loop circuitry for multi-sync operation. Horizontal input up to 100 KHz. 273-byte display registers to control full screen display.

"power injector"

Abstract: MAX5945
Contextual Info: 19-3428; Rev 1; 9/05 KIT ATION EVALU E L B A IL AVA Quad Network Power Controller for Power-Over-LAN Features The MAX5945 quad network power controller is designed for use in IEEE 802.3af-compliant power-sourcing equipment PSE . The device provides power devices (PD) discovery, classification, current-limit, and both DC and AC

Contextual Info: LT1725 General Purpose Isolated Flyback Controller FEATURES • ■ ■ ■ ■ ■ ■ ■ U ■ DESCRIPTIO Drives External Power MOSFET with External ISENSE Resistor Application Input Voltage Limited Only by External Power Components Senses Output Voltage Directly from Primary Side

K1A 494

Contextual Info: LTC4278 IEEE 802.3at PD with Synchronous No-Opto Flyback Controller and 12V Aux Support DESCRIPTION FEATURES n n n n n n n n n n n n n 25.5W IEEE 802.3at Compliant Type 2 PD 10V to 57V Auxiliary Power Input Shutdown Pin for Flexible Auxiliary Power Support

Contextual Info: LT3512 Monolithic High Voltage Isolated Flyback Converter FEATURES n n n n n n n n n DESCRIPTION The LT3512 is a high voltage monolithic switching regulator specifically designed for the isolated flyback topology. No third winding or opto-isolator is required for regulation as the part senses output voltage directly from the

21dq

Contextual Info: DE 1 4 f l 5 5 4 5 5 4855452 0D05041 5 | ~ 55C INTERNATIONAL RECTIFIER 05 04 1 D Data Sheet No. PD-2 .0 5 3 A T - INTERNATIONAL RECTIFIER o 3 - 3 IÖ R 11DQ, S1DQ AND 31DQ SERIES 1 to 3 Amp Schottky Barrier Rectifiers Description/Features Major Ratings and Characteristics

Contextual Info: Panasonic Mobile Communication A N 6 4 1 N F A Pager Direct Conversion FSK Demodulator Base-Band 1C • Overview The A N 6401N FA is a base-band IC supporting direct conversion FSK demodulation for pagers. ■ Features • Low current consumption : Vca current consumption Icci =

cga motorola

Abstract: dancing led circuit microcontroller based dot matrix message display dancing led using microcontroller MC141541 MC141541P MPS2369 Nippon capacitors
Contextual Info: MOTOROLA Order this document by MC141541/D SEMICONDUCTOR TECHNICAL DATA Enhanced Monitor On-Screen Display MC141541 P SUFFIX PLASTIC DIP CASE 648 CMOS The MC141541 is a high performance HCMOS device designed to interface with a microcontroller unit to allow colored symbols or characters to be

Contextual Info: LT1424-5 Isolated Flyback Switching Regulator with 5V Output FEATURES • ■ ■ ■ ■ ■ U ■ DESCRIPTIO The LT 1424-5 is a monolithic high power switching regulator specifically designed for the isolated flyback topology. No “third winding” or optoisolator is required;