Part Number
    Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    TRANSFORMER 1A 12V Search Results

    TRANSFORMER 1A 12V Result Highlights (5)

    Part ECAD Model Manufacturer Description Download Buy
    TA75W01FU
    Toshiba Electronic Devices & Storage Corporation Operational Amplifier, Bipolar (358) type Dual Op-Amp, 3V to 12V, SOT-505 Datasheet
    TA75S01F
    Toshiba Electronic Devices & Storage Corporation Operational Amplifier, Bipolar (358) type, 3V to 12V, SOT-25 Datasheet
    10131125-Z0300YYLF
    Amphenol Communications Solutions 10131125-Z0300YYLF-POWER USB(12V) SINGLE PDF
    10127528-Z0300YYLF
    Amphenol Communications Solutions 10127528-Z0300YYLF-PWRUSB(12V) DOUBLE ENDED PDF
    10125141-Z0075YYLF
    Amphenol Communications Solutions 10125141-Z0075YYLF-PWRUSB(12V) TO LNL2X4 PDF

    Documents mentioning TRANSFORMER 1A 12V

    Document Partial File Text Tags Type PDF
    lt3439
    Final Electrical Specifications LT3439 Ultralow Noise 1A Isolated DC/DC Transformer Driver U FEATURES ■ DESCRIPTIO The LT®3439 is a push-pull DC/DC transformer driver that reduces conducted and radiated electromagnetic interference (EMI). Ultralow noise and EMI are achieved by
    Original PDF
    Final Electrical Specifications LT3439 Ultralow
    Final Electrical Specifications LT3439 Ultralow Noise 1A Isolated DC/DC Transformer Driver U FEATURES ■ DESCRIPTIO The LT®3439 is a push-pull DC/DC transformer driver that reduces conducted and radiated electromagnetic interference (EMI). Ultralow noise and EMI are achieved by
    Original PDF
    aee25-4019
    RoHS Flyback Transformer AEE25-4019 EE25 form factor Desgined for use with Power Integrations tiny switch-111, TNY278, RDR-91 12V, 1A Primary Electrical Specifications @ 25°C INDUCTANCE F=100KHZ,4Vrms, 25ºC 3 - 1 1050uH ± 10% LEAKAGE INDUCTANCE F= HZ, VRMS, 25ºC
    Original PDF
    ap3710
    BCD Demo Board Series DB-AP3710-A -12W Adapter Solution with AP3710 Ser No: V1.1-001 2007-9-7 12V/1A Demo Board with AP3710 + AZ431 +APT13003 Technical Specification ‰ Board Schematic ‰ Board PCB ‰ Bill of Components ‰ Transformer Spec ‰ Test Results of Electrical Characteristics
    Original PDF
    td351
    TD351 Advanced IGBT/MOSFET Driver ■ 1A sink / 0.75A source min. gate drive Active Miller clamp feature Adjustable and accurate two steps turn-off level and delay Input compatible with pulse transformer or optocoupler UVLO protection 2kV ESD protection
    Original PDF
    12va
    DAGNALL ELECTRONICS LIMITED Shuttleworth Road, Elms Industrial Estate, Bedford. MK41 0EP UK TEL +44(0)1234 330077 FAX +44(0)1234 330088 E-mail sales@dagnall-electronics.com Iss 1 13/05/03 • 1 of 3 P R O D U C T D A T A S H E E T 12VA PCB MOUNTED TRANSFORMER
    Original PDF
    top234y
    Title Engineering Prototype Report 7 12V @30W Universal Input Engineering Prototype (EP7) Recipients Customer Author R.H. Date 21-December-99 Abstract This document details the specification and actual operation of a 12V, 30W universal input supply using the TOP234Y.
    Original PDF
    an1765
    AN1765 - APPLICATION NOTE ® LCD MONITOR POWER SUPPLY WITH VIPer53 J. Augustoni - A. Bailly INTRODUCTION LCD monitors are replacing aging CRT type in today’s desktop PCs. The typical power supply requirement in this application is a 12V rail for the backlight and a 5V rail to supply processing ICs and
    Original PDF
    tny267p
    Design Example Report Title 11W Power Supply using TNY267P Specification Input: 200 – 264 VAC Output: 3.3V/0.7A, 5V/1.6A, 12V/0.4A, -12V/0.1A Application DVD Player Author Power Integrations Applications Department Document Number DER-5 Date February 4, 2004
    Original PDF
    an1765
    AN1765 - APPLICATION NOTE ® LCD MONITOR POWER SUPPLY WITH VIPer53 J. Augustoni - A. Bailly INTRODUCTION LCD monitors are replacing aging CRT type in today’s desktop PCs. The typical power supply requirement in this application is a 12V rail for the backlight and a 5V rail to supply processing ICs and
    Original PDF
    aa-98021
    Sida 1(3) Customer: Transf. No. Designed: ELFA AB 56-132-60 yellow AA-98021 1999-04-13 / ts green U = 12V Uo = 14,9V External fuse: S1 10 VA 1A red 230V 48-60Hz P1 brown U = 12V Uo = 14,9V External fuse: 1A S2 blue yellow Classification Protection against electrical shock:
    Original PDF
    max796
    19-0221; Rev 3a; 11/97 MAX796 Evaluation Kit The MAX796 evaluation kit (EV kit) is a preassembled and tested demonstration board that generates 5V and 15V. It features a flyback transformer rather than a simple inductor, providing the extra 15V output with very little added cost. This loosely regulated 15V output is normally post-regulated to 12V with a linear regulator such
    Original PDF
    dc230
    Quick Start Guide for Demo Board DC230 Description DC230 demonstrates the LT1533CS in a bipolar-output DC/DC converter. Four versions of the demo board are available, covering the most common output requirements. For example, version A generates +12V and –12V from a 5V input with a total output power of 1.8W.
    Original PDF
    lnk304
    Design Example Report Title 3W Wide Range Flyback Power Supply using LNK304P Specification Input: 57-580VAC Output: 12V / 250mA Application Utility Meter Author Power Integrations Applications Department Document Number DER-58 Date May 4, 2005 Revision 1.0
    Original PDF
    Application Note 1062 High Voltage Green Mode PWM
    Application Note 1062 High Voltage Green Mode PWM Controller AP3105 Prepared by Wu Qikun System Engineering Dept. 1. Introduction the PCB layout, and methods for reducing the standby power loss, and finally presents a demo design of a 12V 1A adaptor. The AP3105 is a low start-up current, current mode
    Original PDF
    12vsb
    Design Example Report Title 17W (25W peak) DVD Recorder Power Supply using TOP245P Input: 90 – 265 VAC Output: 3.4V/2.55A, 5.1V/1.5A, 5.1Vsb/0.85A, Specification 12V/2.8A, 12Vsb/0.4A, -5.3V/0.3A, -5.3Vsb/20mA, -22Vsb/10mA, +33Vsb/2mA, 3.5V VFD/165mA Application
    Original PDF
    max1630
    19-1211; Rev 0; 3/97 MAX1630/MAX1631/MAX1632 Evaluation Kits ____________________________Features ♦ Battery Range: 5.2V to 20V (MAX1630) 5.2V to 28V (MAX1631) 6.5V to 28V (MAX1632) ♦ Outputs: 3.3V at 3A 5V at 3A 12V at 120mA 5V at 30mA Keep-Alive ♦ 1:4 Transformer (MAX1630)
    Original PDF
    AP1695EV4 User Guide 120VAC Triac Dimmable GU10
    AP1695EV4 User Guide 120VAC Triac Dimmable GU10 LED Driver with Integrated MOSEFT General Description  This  AP1695  Triac  Dimmable  GU10  12V/400mA  Buck  LEDs  driver  EV  board  use  tapped  transformer  to  increasing  power  conversion  turn  on  duty  cycle,  boost 
    Original PDF
    AP1694AEV10 User Guide 120VAC Triac Dimmable GU10
    AP1694AEV10 User Guide 120VAC Triac Dimmable GU10 LED Driver General Description  This  AP1694A  Triac  Dimmable  GU10  12V/400mA  Buck  LEDs  driver  EV  board  use  tapped  transformer  to  increasing  power  conversion  turn  on  duty  cycle,  boost 
    Original PDF
    AP1694AEV11 User Guide 230VAC Triac Dimmable GU10
    AP1694AEV11 User Guide 230VAC Triac Dimmable GU10 LED Driver General Description  This  AP1694A  Triac  Dimmable  GU10  12V/400mA  Buck  LEDs  driver  EV  board  use  tapped  transformer  to  increasing  power  conversion  turn  on  duty  cycle,  boost 
    Original PDF
    AP1695EV5 User Guide 230VAC Triac Dimmable GU10
    AP1695EV5 User Guide 230VAC Triac Dimmable GU10 LED Driver with Integrated MOSFET General Description  This  AP1695  Triac  Dimmable  GU10  12V/400mA  Buck  LEDs  driver  EV  board  use  tapped  transformer  to  increasing  power  conversion  turn  on  duty  cycle,  boost 
    Original PDF
    lnk304
    Design Example Report 1.6W Dual Output Flyback Converter using LNK304P Title Input: 85-265VAC Specification Output: 15V / 25mA (non-isolated) and 12V / 100mA (isolated) Application Motor Control Author Power Integrations Applications Department Document Number
    Original PDF
    an2097
    AN2097 APPLICATION NOTE VIPower: 10W POWER SMPS USING VIPer22A FOR AIR-CONDITIONER APPLICATION 1. ABSTRCT New air-conditioner systems use two main lowvoltage outputs to supply the internal electronic equipment, respectively these values are +12V and +5V. These low output voltages are generated
    Original PDF
    steval-isa013v1
    STEVAL-ISA013V1 VIPer53 dual output off-line wide range power supply, 24W Output Data Brief Features ■ Switch mode general purpose power supply ■ Input: 85 to 264Vac @ 50/60Hz ■ Output: 12V @ 1A & 5V @ 2.4A ■ Output power (peak) : 24W ■ Switching frequency 100kHz
    Original PDF
    steval-isa013v1
    STEVAL-ISA013V1 Dual output off-line wide range 24W power supply evaluation board for VIPer53 Data Brief Features ■ Switch mode general purpose power supply ■ Input: 85 to 264Vac @ 50/60Hz ■ Output: 12V @ 1A & 5V @ 2.4A ■ Output power (peak) : 24W
    Original PDF