SPLIT Search Results

Contextual Info: u 1J POWER SPLITTER .19 MAX 7 1 TRAK MICROWAVE POWER SPLITTER .3 5 S P L /2 E F - 0 1 / 7 5 SPECIFICATIONS: FREQUENCY LOSS VSWR AMP BALANCE PHASE BALANCE ISOLATION POWER IMPEDANCE 5 0 0 - 2 0 0 0 MHz 0 .8 dB TYP, 2 .0 dB MAX 1.5:1 MAX ± 0 .1 dB TYP, ± 0 .3 dB MAX

Contextual Info: TRKMS001 ★T R K M S 0 0 1 * POWER SPLITTER STYLE - 3 2 30 PACKAGE 3X .15 SPECIFICATIONS Ô FREQUENCY INSERTION LOSS VSWR s AMP BALANCE PHASE BALANCE ISOLATION POWER IMPEDANCE 12 ± 0 .2 GHz 1.0 dB MAX 1.4:1 MAX ± 0 .5 dB MAX ± 5 ‘ MAX 2 0 dB MIN

P8085AH

Abstract: TMP8085AP TMP8085AP-2 TMP8085 TMP8156P MPU85-9
Contextual Info: TO SHIBA TMP8085A TMP8085AP-2/TMP8085AHP-2 8-BIT MICROPROCESSOR 1. GENERAL DESCRIPTION The TMP8085AP-2/TMP8085AHP-2, hereafter on referred to as TMP8085A, is a 8 bit micro processing unit MPU . TMP8085A uses a multiplexed data bus. The address is split between the 8 bit address bus and the 8 bit data bus. The on-chip address latches of

Contextual Info: GaA«As IRED a PHOTO-IC 6N138,139 6N138 CURRENT LOOP DRIVER. U n it in mm LO W INPUT CURRENT LINE RECEIVER. C M O S LOGIC INTERFACE. The T O S H IB A 6N138 and 6N139 consists of a G a A fA s infrared em itting diode coupled w ith a split-Darlington output configuration.

Contextual Info: TPS70145, TPS70148, TPS70151, TPS70158, TPS70102 DUAL-OUTPUT LOW-DROPOUT VOLTAGE REGULATORS WITH POWER UP SEQUENCING FOR SPLIT VOLTAGE DSP SYSTEMS SLVS222A – DECEMBER 1999 – REVISED FEBRUARY 2000 D D D D D D Dual Output Voltages for Split-Supply Applications

DST-3-10

Abstract: 16VCT Transformer 115V 24V DST-5-48 ST712 ST6120 ST-5-20 TRANSFORMER DST-4-36 dst-4-2 dst-7-36
Contextual Info: Split/Tran , Specialty Purpose & Class 2 Transformers • Printed Circuit Mount SM Split Bobbin with High Isolation Signal’s ST and DST transformers utilize split bobbin construction that provides superior isolation and low capacitive coupling. General Specifications

Contextual Info: SN74VMEH22501AĆEP 8ĆBIT UNIVERSAL BUS TRANSCEIVER AND TWO 1ĆBIT BUS TRANSCEIVERS WITH SPLIT LVTTL PORT, FEEDBACK PATH, AND 3ĆSTATE OUTPUTS SCES625 − FEBRUARY 2005 D Controlled Baseline D D D D D D D D D D D D D D D D D D DGG OR DGV PACKAGE TOP VIEW

TL244

Abstract: QSOP44
Contextual Info: UCC5621 y UNITRO DE 27 - Line SCSI Terminator With Split Reverse Disconnect FEATURES DESCRIPTION • Complies with SCSI, SCSI-2, SCSI-3, SPI and FAST-20 Ultra Standards UCC5621 provides 27 lines of active termination for a SCSI (Small Com­ puter Systems Interface) parallel bus. The SCSI standard recommends ac­

1011B2C

Abstract: 1011J7C 1011B7C TDC1011B2C
Contextual Info: TDC1011 TRww Variable-Length Shift Register Features 8-Bit, 18MHz • • • • • • The TR W TDC1011 is a high-speed, byte-wide shift register w hich can be programmed to any length between 3 and 18 stages. It operates at a 56ns cycle time 18MHz shift ratej. A special split-word mode is

SAC405

Abstract: FAN2560 FAN2560UC13X FAN2560UC15X JESD22-A114 J-STD-020B
Contextual Info: FAN2560 350mA Low-VIN LDO with Fast Transient Response Features Description ƒ ƒ ƒ ƒ ƒ ƒ ƒ ƒ ƒ The FAN2560 is a linear low-dropout LDO regulator with a split-supply architecture. Separate bias and supply inputs allow bias to be taken directly from the

Contextual Info: Data Sheet AS324 LOW POWER QUAD OPERATIONAL AMPLIFIERS General Description Features The AS324 consists of four independent, high gain and internally frequency compensated operational amplifiers. It is specifically designed to operate from a single power supply. Operation from split power

Contextual Info: Data Sheet AS324 LOW POWER QUAD OPERATIONAL AMPLIFIERS General Description Features The AS324 consists of four independent, high gain and internally frequency compensated operational amplifiers. It is specifically designed to operate from a single power supply. Operation from split power

AZ324M-E1

Abstract: az324m
Contextual Info: Data Sheet LOW POWER QUAD OPERATIONAL AMPLIFIERS General Description Features The AZ324 consists of four independent, high gain and internally frequency compensated operational amplifiers. It is specifically designed to operate from a single power supply. Operation from split power supply is

Contextual Info: B2 - 0.6 to 1 Watt Isolated DC-DC Converter DIL Series Dual Split Regulated Output 1. Features : n 14 Pin DIL Package n Low Ripple and Noise n Input / Output Isolation 1K Vdc or 3K Vdc n 100 % Burn-In n Input Filter with Internal Capacitor n Custom Design Available

Contextual Info: Comparator series Automotive Ground Sense Comparators BA2903Yxxx-C, BA2901Yxx-C ●Key Specifications  Wide operating supply voltage single supply : split supply :  Very low supply current BA2903Yxxx-C BA2901Yxx-C  Low input bias current :  Low input offset current :

BA8522RFV

Contextual Info: Datasheet Operational Amplifiers Low Noise Operational Amplifiers BA8522Rxxx General Description Key Specifications  Operating Supply Voltage split supply : ±2V to ±16V  Temperature Range: -40°C to +105°C  Input Offset Voltage: ±1.5mV(Max)  Slew Rate:

Contextual Info: QJD1210011 Preliminary Powerex, Inc., 173 Pavilion Lane, Youngwood, Pennsylvania 15697 724 925-7272 www.pwrx.com Split Dual SiC MOSFET Module 100 Amperes/1200 Volts Y A AA D AC AB F Z DETAIL "B" Q Q Q P 1 2 3 U 4 5 6 7 8 9 Description: Powerex Silicon Carbide MOSFET

Capacitive voltage transformer

Abstract: mouser transformer 006 EC bobbin transformer 230v fs120
Contextual Info: P OWER TRANSFORMER P C M O U N T : SPLIT PACK FS120-02 Description: The FS120-02 is a dual primary and dual secondary, split bobbin design which operates with either a parallel input of 115V or a series input of 230V. The output voltage will be either 120.0V with a center-tap under a 0.02A load with the

25va transformer

Contextual Info: P OWER TRANSFORMER P C M O U N T : SPLIT PACK F10-250 Description: The F10-250 is a single primary and dual secondary, split bobbin design which operates with an input of 115V. The output voltage will be either 10.0V with a center-tap under a 0.25A load with the secondaries wired in series, or 5.0V under

Contextual Info: Ultra-Small Ceramic QCN-27+ QCN-27 Power Splitter/Combiner 2 Way-90° 50Ω 1700 to 2700 MHz Maximum Ratings Features Operating Temperature -55°C to 100°C Storage Temperature -55°C to 100°C Power Input as a splitter 15W* max. * Derate linearly to 7W at 100°C ambient.

Contextual Info: Engineering Development Model Power Splitter/Combiner LRPS-ED3620A/1 3 Way-0° Important Note This model has been designed, built and tested in our engineering department. Performance data represents model capability. At present it is a non-catalog model. On request, we can supply a

Contextual Info: Coaxial Power Splitter/Combiner 6 Way-0° 50Ω ZC6PD-960W 700 to 1000 MHz Maximum Ratings Features Operating Temperature -55°C to 100°C Storage Temperature -55°C to 100°C Power Input as a splitter 10W max. Internal Dissipation 0.875W max. • low insertion loss, 0.4 dB typ.

Contextual Info: Coaxial ZAPD-900-5W+ ZAPD-900-5W Power Splitter/Combiner 2 Way-0° 50Ω 100 to 900 MHz Maximum Ratings Features Operating Temperature -55°C to 100°C Storage Temperature -55°C to 100°C Power Input as a splitter 5W max. Internal Dissipation 1W max. N-Type version shown

Contextual Info: Surface Mount Power Splitter/Combiner 2 Way-90° 50Ω 940 to 1130 MHz Maximum Ratings Operating Temperature Features -40°C to 85°C Storage Temperature HPQ-12W -55°C to 100°C Power Input as a splitter 1W max. • low insertion loss, 0.3 dB typ. • excellent input & output VSWR, 1.2:1 typ.