REMEZ Search Results
Documents mentioning REMEZ
| Document | Partial File Text | Tags | Type | |||
|---|---|---|---|---|---|---|
| gc1115 | GC1115 www.ti.com SLWS144 – FEBRUARY 2005 Crest Factor Reduction Processor FEATURES APPLICATIONS • Significantly Reduces Signal Peaks to ≥ 6 dB PAR One 20-MHz or 2 Independent 10-MHz Channels Programmable Output PAR Down to 6 dB |
Original | ||||
| gc1115 | GC1115 www.ti.com SLWS144 – FEBRUARY 2005 Crest Factor Reduction Processor FEATURES APPLICATIONS • Significantly Reduces Signal Peaks to ≥ 6 dB PAR One 20-MHz or 2 Independent 10-MHz Channels Programmable Output PAR Down to 6 dB |
Original | ||||
| Application Note 091 G Math – A New Paradigm for | Application Note 091 G Math – A New Paradigm for Mathematics Mahesh Chugani and John Hanks Introduction LabVIEW from its inception has been developed primarily for the purpose of improving measurement tasks. Until recently, it was not clear that LabVIEW or the graphical programming technology could deal with |
Original | ||||
| ad7225 | LC2MOS Quad 8-Bit DAC with Separate Reference Inputs AD7225 FUNCTIONAL BLOCK DIAGRAM VREF A VREFB VREF C VREFD DB7 DATA (8-BIT) DB0 WR A1 A2 DATA BUS Four 8-bit DACs with output amplifiers Separate reference input for each DAC Microprocessor compatible with double-buffered inputs |
Original | ||||
| ANALOG DEVICES 65 MSPS Digital Receive Signal | ANALOG DEVICES 65 MSPS Digital Receive Signal Processor AD6620 FEATURES High In p u t S a m p le R ate 65 M S P S S in g le C h an n el Real 3 2 .5 M S P S D iv e rs ity C hannel Real 3 2 .5 M S P S S in g le C h an n el C o m p lex NCO Freq u en cy T ran sla tio n |
OCR Scan | ||||
| TDA7572 200W mono bridge PWM amplifier with | TDA7572 200W mono bridge PWM amplifier with built-in step-up converter Preliminary Data Features ■ Input stage and gain compressor ■ Over-modulation protection and current limiting ■ Modulator ■ DAC ■ Step-up ■ Mode control ■ Diagnostics / safety |
Original | ||||
| Analog and Digital Products Design/Selection | Analog and Digital Products Design/Selection Guide TABLE OF CONTENTS Introduction to Frequency Devices Pages 2 ANALOG & DIGITAL FILTER DESIGN GUIDE Analog Filter Design 3 Available Filter Technology 20 Digital Filter Design 22 Signal Reconstruction 28 Choosing a Filter Solution |
Original | ||||
| tda7572 | TDA7572 200W mono bridge PWM amplifier with built-in step-up converter Preliminary Data Features ■ Input stage and gain compressor ■ Over-modulation protection and current limiting ■ Modulator ■ DAC ■ Step-up ■ Mode control ■ Diagnostics / safety |
Original | ||||
| gc1115 | Application Report SLWA045 – May 2005 Configuring the GC1115 for 3G Air Interfaces Al Wegener… Wireless Infrastructure Business Unit ABSTRACT The GC1115 crest factor reduction (CFR) processor reduces the peak-to-average ratio |
Original | ||||
| analog devices data-acquisition databook 1984 | General Information ANALOG DEVICES DATA-ACQUISITION DATABOOK 1984 VOLUME I INTEGRATED CIRCUITS Table of Contents Ordering Guide Q Operational Amplifiers Instrumentation & Isolation Amplifiers c Analog Signal Processing Components m a Voltage References Temperature Measurement Components |
OCR Scan | ||||
| LabVIEW Tools for Digital Filter Design and | LabVIEW Tools for Digital Filter Design and Implementation NI Digital Filter Design Toolkit • Interactive and programmatic design, analysis, and implementation of FIR/IIR digital filters within LabVIEW • More than 30 filter types backed by more than 25 classical and modern |
Original | ||||
| ANALOG DEVICES LC2M0S Quad 8-Bit DAC with | ANALOG DEVICES LC2M0S Quad 8-Bit DAC with Separate Reference Inputs AD7225 FEATURES Four 8-Bit DACs w ith Output Amplifiers Separate Reference Input for Each DAC liP Compatible w ith Double-Buffered Inputs Simultaneous Update of All Four Outputs Operates w ith Single or Dual Supplies |
OCR Scan | ||||
| MIXED-SIGNAL AND DSP DESIGN TECHNIQUES a ANALOG | MIXED-SIGNAL AND DSP DESIGN TECHNIQUES a ANALOG DEVICES TECHNICAL REFERENCE BOOKS PUBLISHED BY PRENTICE HALL Analog-Digital Conversion Handbook Digital Signal Processing Applications Using the ADSP-2100 Family (Volume 1:1992, Volume 2:1994) Digital Signal Processing in VLSI |
Original | ||||
| an-344 | r a ANALOG U AN-344 APPLICATION NOTE D EVICES ONE TECHNOLOGY WAY • P.O. BOX 9106 • NORWOOD, MASSACHUSETTS 02062-9106 • 617/329-4700 Digital FIR Filters Without Tears by Bill Windsor and Paul Toldalagi Digital filters once required specialized design techniques, highperformance costly hardware, and complicated software to imple |
OCR Scan | ||||
|
|
||||||
| a FEATURES High Input Sample Rate 65 MSPS Single | a FEATURES High Input Sample Rate 65 MSPS Single Channel Real 32.5 MSPS Diversity Channel Real 32.5 MSPS Single Channel Complex NCO Frequency Translation Worst Spur Better than –100 dBc Tuning Resolution Better than 0.02 Hz 2nd Order Cascaded Integrator Comb FIR Filter |
Original | ||||
| a FEATURES High Input Sample Rate 67 MSPS Single | a FEATURES High Input Sample Rate 67 MSPS Single Channel Real 33.5 MSPS Diversity Channel Real 33.5 MSPS Single Channel Complex NCO Frequency Translation Worst Spur Better than –100 dBc Tuning Resolution Better than 0.02 Hz 2nd Order Cascaded Integrator Comb FIR Filter |
Original | ||||
| gc1115 | GC1115 www.ti.com SLWS144B – FEBRUARY 2005 – REVISED OCTOBER 2005 Crest Factor Reduction Processor FEATURES APPLICATIONS • Significantly Reduces Signal Peaks to ≥ 6 dB PAR One 20-MHz or 2 Independent 10-MHz |
Original | ||||
| gc1115 | GC1115 www.ti.com SLWS144 – FEBRUARY 2005 Crest Factor Reduction Processor FEATURES APPLICATIONS • Significantly Reduces Signal Peaks to ≥ 6 dB PAR One 20-MHz or 2 Independent 10-MHz Channels Programmable Output PAR Down to 6 dB |
Original | ||||
| ad7225 | LC2MOS Quad 8-Bit DAC with Separate Reference Inputs AD7225 FUNCTIONAL BLOCK DIAGRAM VREF A VREFB VREF C VREFD DB7 DATA (8-BIT) DB0 WR A1 A2 DATA BUS Four 8-bit DACs with output amplifiers Separate reference input for each DAC Microprocessor compatible with double-buffered inputs |
Original | ||||
| hsp43220 | Designing With the HSP43220 Using the DECIMATE™ Software Tool Technical Brief April 1998 TB309.1 Operation and Programming Data_in Bus Typical operation of the part using DECI•MATE software is as follows. RESET is held low long enough to satisfy the specification of 4 clocks for the slowest clock. Coming out of |
Original | ||||
| Disclaimer: This document was part of the First | Disclaimer: This document was part of the First European DSP Education and Research Conference. It may have been written by someone whose native language is not English. TI assumes no liability for the quality of writing and/or the accuracy of the information contained herein. |
Original | ||||
| gc1115 | GC1115 www.ti.com SLWS144C – FEBRUARY 2005 – REVISED JUNE 2006 Crest Factor Reduction Processor FEATURES APPLICATIONS • Significantly Reduces Signal Peaks to ≥ 6 dB PAR One 20-MHz or 2 Independent 10-MHz |
Original | ||||