VOGT SWITCHI Search Results
Documents mentioning VOGT SWITCHI
| Document | Partial File Text | Tags | Type | |||
|---|---|---|---|---|---|---|
| COMPONENTS | MODULES | CORES 2011 SUMIDA | COMPONENTS | MODULES | CORES 2011 SUMIDA Components & Modules GmbH Dr. Hans-Vogt-Platz 1 | D-94130 Obernzell Phone: ++49/85 91/937-100 Fax: ++49/85 91/937-103 E-Mail: contact@sumida-eu.com Internet: www.sumida-eu.com COMPONENTS | MODULES | CORES -2- INTRODUCTION |
Original | ||||
| i SIEM EN S TCA 440 AM Receiver Circuit AM | i SIEM EN S TCA 440 AM Receiver Circuit AM receiver circuit for LW, MW, and SW in battery and line operated radio receivers. It includes an RF prestage with AGC, a balanced mixer, separate oscillator, and an IF amplifier with AGC. Because of its internal stabilization, all characteristics are largely independent of the |
OCR Scan | ||||
| tca 440 | i S IE M E N S TCA 440 AM Receiver Circuit AM receiver circuit for LW, MW, and SW in battery and line operated radio receivers. It includes an RF prestage with AGC, a balanced mixer, separate oscillator, and an IF amplifier with AGC. Because of its internal stabilization, all characteristics are largely independent of the |
OCR Scan | ||||
| SIEM ENS Dual Sound FM IF Amplifier TBA 229-2 | SIEM ENS Dual Sound FM IF Amplifier TBA 229-2 Bipolar 1C The component contains two separate limiter amplifiers with FM demodulators and separate AF outputs. Features • High AM suppression over a very wide input voltage range • High sensitivity • Very high symmetry |
OCR Scan | ||||
| FPS TM Fairchild’s Power Switch Analog Discrete | FPS TM Fairchild’s Power Switch Analog Discrete Interface & Logic Optoelectronics For Switch Mode Power Supply Building Block Solutions for Multi-Market Applications Across the board. Around the world™ FPS ™ Design Guide Table Of Contents What is Fairchild Power Switch FPS™…5 |
Original | ||||
| SIEM ENS FM Sound IF for Television Applications | SIEM ENS FM Sound IF for Television Applications with I 2C Bus and SCART Preliminary Data TBA 130-2 Bipolar IC Features • I 2C bus control for the functions volume, muting, voice/music switching, as well as SCART recording/playback switching • Integrated deemphasis resistor |
OCR Scan | ||||
| AC/DC Switch Mode Power Supply Design Guide | AC/DC Switch Mode Power Supply Design Guide www.fairchildsemi.com AC/DC Switch Mode Power Supply Design Guide Table Of Contents Product Information Total Solutions…3 |
Original | ||||
| TBA 229-5 Dual Sound FM IF Amplifier TBA 229-5 | TBA 229-5 Dual Sound FM IF Amplifier TBA 229-5 Bipolar IC Features High AM suppression over a very wide input voltage range High sensitivity Very high symmetry P-DIP-16 The component contains two separate limiter amplifiers with FM demodulators and separate |
Original | ||||
| SIEM ENS FM Sound IF with SCART Switch and Volume | SIEM ENS FM Sound IF with SCART Switch and Volume Control TBA 121 Bipolar 1C Features • Outstanding limiting qualities Few external components Integrated deemphasis resistor Low harmonic distorsion factor Type Ordering Code Package TBA 121 Q67000-A8252 |
OCR Scan | ||||
| ® AN1546 - APPLICATION NOTE VIPower: | ® AN1546 - APPLICATION NOTE VIPower: SELF–OSCILLATING CONVERTER USING VK05CFL FOR COMPACT FLUORESCENT LAMPS N. Aiello - S. Messina ABSTRACT This application note introduces a new self–oscillating converter based on VK05CFL device to drive “SE”, “DE”, and “TE” fluorescent tubes. The design is intended for 5 to 23W fluorescent lamps and 110V, |
Original | ||||
AN1546 - APPLICATION NOTE VIPower: SELF–OSCILLATING CONVERTER USING VK05CFL FOR COMPACT FLUORESCENT LAMPS N. Aiello - S. Messina ABSTRACT This application note introduces a new self–oscillating converter based on VK05CFL device to drive “SE”, “DE”, and “TE” fluorescent tubes. The design is intended for 5 to 23W fluorescent lamps and 110V, |
Original | |||||
| Bill of Materials Q-SMINTO Q/T SMINTO | Bill of Materials Q-SMINTO Q/T SMINTO Evaluationboard Revised: Thursday, March 29, 2001 Top Sheet by R. Froese Revision: 1.0a Infineon Technologies AG COM A1 AE Balanstr. 73 - 81541 Munich - Germany Bill Of Materials Item March 29,2001 Quantity Reference 18:27:32 |
Original | ||||
| Bill of Materials T-SMINTO Q/T SMINTO | Bill of Materials T-SMINTO Q/T SMINTO Evaluationboard Revised: Thursday, March 29, 2001 Top Sheet by R. Froese Revision: 1.0a Infineon Technologies AG COM A1 AE Balanstr. 73 - 81541 Munich - Germany Bill Of Materials Item March 29,2001 Quantity Reference 18:27:32 |
Original | ||||
| vk05cfl | AN1694 - APPLICATION NOTE ® VIPower: ELECTRONIC BALLAST FOR REMOVABLE CFL N. Aiello – S. Messina ABSTRACT This technical note describes how a High Frequency ballast based on VK05CFL is able to drive removable fluorescent tubes. The design is intended for 5 to 13W fluorescent lamps and 110V or 230V |
Original | ||||
|
|
||||||
| universal motor speed control | AN2263 Application note Universal motor speed control and light dimmer with Triac and ST7ULTRALITE microcontroller 1 Introduction This application note describes a traditional design solution for controlling a monophase motor or any AC load based on phase angle adjusting with a Triac or AC switch and |
Original | ||||
| AN2263 Application note Universal motor speed | AN2263 Application note Universal motor speed control and light dimmer with TRIAC and ST7LITE microcontroller Introduction This application note describes a traditional design solution for controlling a mono phase motor or any AC load based on phase-angle adjusting with a TRIAC or AC switch and a |
Original | ||||
| b10011 | Temic B10011S Semiconductors CAN Transceiver Description The device B10011S is a transceiver for CAN bus systems with high transmission levels according to ISO WD 11992-1 (point-to-point interface between trucks and trailers). The special features of a circuit |
OCR Scan | ||||
| irs2530 | IRPLDIM5E 4 Level Switch Dim Fluorescent Ballast using the IRS2530D DIM8TM Table of Contents Page 1. Features…2 2. Overview…2 |
Original | ||||
| an2018 | AN2018 - APPLICATION NOTE ® VIPower: 18 - 23W ELECTRONIC BALLAST FOR REMOVABLE TUBES ABSTRACT This application note describes electronic high frequency ballast based on VK05CFL designed to drive from 18 to 23W TC DEL and T5 removable fluorescent tubes. The design was performed for 185÷265 Vac main voltage. |
Original | ||||
| steval-isa019v1 | STEVAL-ISA019V1 80 W ESBT® quasi-resonant wide range SMPS evaluation board with L6565 for 3-phase applications Data Brief Features ■ 3-phase 80 W auxiliary output SMPS ■ Quasi-resonant SMPS ■ Input: 180 VAC 600 VAC ■ Output voltage 24 V, 3.3 A ■ |
Original | ||||
| calex | CALEX MANUFACTURI NG Special Products CO 2ÖE D 1011250 00^0^44 a ■ CEX T-s-y-t/ 3355 Vincent Road, Pleasant Hill, CA 94523-4389 Telephone (415) 932-3911 Telex; 269 888 Telefax: (415) 932-6017 12Q15,050 DC/DC CONVERTER Quad Output Power Source DESCRIPTION |
OCR Scan | ||||
| irpldim4e | IRPLDIM4E Miniature Dimmable 26W Ballast Using IRS2530D DIM8TM Control IC Table of Contents Page 1. Overview…2 2. Features…2 |
Original | ||||
| b10011s | B10011S CAN Transceiver Description The device B10011S is a transceiver for CAN bus systems with high transmission levels according to ISO WD 11992-1 (point-to-point interface between trucks and trailers). The special features of a circuit containing this device allow transmission which is |
Original | ||||
| b1001 | Tem ic B10011S S e m i c o n d u c t o r s CAN Transceiver Description The device B lO O llSisa transceiver for CAN bus systems with high transmission levels according to ISO WD 11992-1 (point-to-point interface between trucks and trailers). The special features of a circuit |
OCR Scan | ||||
| B10011S CAN Transceiver Description The device | B10011S CAN Transceiver Description The device B10011S is a transceiver for CAN bus systems with high transmission levels according to ISO WD 11992-1 (point-to-point interface between trucks and trailers). The special features of a circuit containing this device allow transmission which is |
Original | ||||