Part Number
    Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    VENABLE TECHNICAL PAPER Search Results

    VENABLE TECHNICAL PAPER Result Highlights (5)

    Part ECAD Model Manufacturer Description Download Buy
    TPS65180BRGZT
    Texas Instruments PMIC for E Ink Vizplex Enabled Electronic Paper Display 48-VQFN -10 to 85 Visit Texas Instruments
    TPS65186RGZR
    Texas Instruments PMIC for E-Ink® Vizplex™ Enabled Electronic Paper Display 48-VQFN -40 to 85 Visit Texas Instruments Buy
    TPS65182BRGZT
    Texas Instruments PMIC for E Ink Vizplex Enabled Electronic Paper Display. 48-VQFN -10 to 85 Visit Texas Instruments Buy
    TPS65181BRGZR
    Texas Instruments PMIC for E Ink Vizplex Enabled Electronic Paper Display 48-VQFN -10 to 85 Visit Texas Instruments Buy
    TPS65180BRGZR
    Texas Instruments PMIC for E Ink Vizplex Enabled Electronic Paper Display 48-VQFN -10 to 85 Visit Texas Instruments Buy

    Documents mentioning VENABLE TECHNICAL PAPER

    Document Partial File Text Tags Type PDF
    mcp18480
    M MCP18480 -48V Hot Swap Controller Features Description • Allows safe board removal and insertion from a live backplane • Accurate (<1.5%) internal voltage reference for fault detection and precision timing • Programmable foldback current limiting • Programmable circuit breaker current limiting
    Original PDF
    MCP18480 -48V Hot Swap Controller Features
    MCP18480 -48V Hot Swap Controller Features Description • Allows safe board removal and insertion from a live backplane • Accurate (<1.5%) internal voltage reference for fault detection and precision timing • Programmable foldback current limiting • Programmable circuit breaker current limiting
    Original PDF
    l64020
    ® L64015 VMI Bridge Advance Datasheet The L64015 VMI Bridge chip is a companion chip of LSI Logic’s L64020 Digital Video Decoder (DVD). The L64015 serves as an interface between a notebook computer with a VMI (Video Module Interface) ready graphics device and the decompressed video and audio bitstream output
    Original PDF
    Preliminary Data Sheet September 1996
    Preliminary Data Sheet September 1996 microelectronics group Lucent Technologies Bell Labs Innovations W2013 Indirect Quadrature Modulator with Gain Control Features Description ■ Wide supply range: 2.7 V to 5.5 V The W 2013 is a monolithic integrated circuit that
    OCR Scan PDF
    and8321
    AND8321/D Compensation of a PFC Stage Driven by the NCP1654 Prepared by Joel Turchi ON Semiconductor http://onsemi.com Circuits for power factor correction have to shape the line current that is a low frequency signal. Hence, they are in essence extremely slow systems. That is why, the
    Original PDF
    ata5756
    Features • PLL Transmitter IC with Single-ended Output • High Output Power (6 dBm) at 8.1 mA (315 MHz) and 8.5 mA (433 MHz) Typical Values • Divide by 24 (ATA5756) and 32 (ATA5757) Blocks for 13 MHz Crystal Frequencies and for Low XTO Start-up Times
    Original PDF
    and8327
    AND8327/D Stability Analysis in Multiple Loop Systems Prepared by Christophe Basso, Stéphanie Conseil, Nicolas Cyr http://onsemi.com Loop stability analysis usually starts from an open-loop Bode plot of the plant under study, e.g. the power stage of a buck or a flyback converter. From this diagram, the designer
    Original PDF
    Can ESR Be Too Low? Erik Reed KEMET Electronics
    Can ESR Be Too Low? Erik Reed KEMET Electronics Corporation, 2835 KEMET Way, Simpsonville, SC 29681 Phone: +1-864-963-6300, Fax: +1-864-228-4081 e-mail: erikreed@kemet.com Abstract Tantalum and aluminum polymer capacitors with 7343 EIA footprint can now be manufactured with ESR
    Original PDF
    National Semiconductor Application Note 1677 Tim
    National Semiconductor Application Note 1677 Tim Hegarty January 14, 2008 Introduction sible. Consequently, the overall power dissipation is application dependent and conditioned by ratios of static and dynamic power loss components. Additionally, Xilinx defines
    Original PDF
    POWER designer Expert tips, tricks, and
    POWER designer Expert tips, tricks, and techniques for powerful designs national.com/powerdesigner No. 121 Power Supply Design Considerations for Modern FPGAs — By Dennis Hudgins, Low Voltage Applications Manages, Tucson Design Center Introduction Today’s FPGAs tend to operate at lower voltages and higher currents than their predecessors. Consequently,
    Original PDF
    ■ndS *»«* ^ 0<Tl59® DeSsuPP«es Wi,h P°wer „
    ■ndS *»«* ^ 0<Tl59® DeSsuPP«es Wi,h P°wer „ Report Applicatfon Bep Te x a s In s t r u m e n t s IMPORTANT NOTICE Texas Instrum ents (Tl) reserves the right to make changes to its products or to discontinue any sem iconductor product or service w ithout notice, and advises its
    OCR Scan PDF
    AND8143/D A General Approach for Optimizing
    AND8143/D A General Approach for Optimizing Dynamic Response for Buck Converter http://onsemi.com Prepared by: W.H. Lei, T.K. Man ON Semiconductor APPLICATION NOTE Abstract modulator is shown in Figure 2 and the model of its power switches is shown in Figure 3. That represents the low
    Original PDF
    and8314
    AND8314 Key Steps to Design a Post-regulator Driven by the NCP4331 Prepared by: Joël Turchi, ON Semiconductor http://onsemi.com This paper proposes the key steps to rapidly design a post regulator driven by the NCP4331, in a systematic manner. The process is illustrated by a practical 3V3 / 20 A design
    Original PDF
    mag amp cores and materials
    ® Division of Spang & Company Technical Bulletin BULLETIN SR-4 Mag Amp Cores and Materials The best choice for tightly regulated outputs in switching power supplies Proper regulation is an important consideration in specifying and designing switching power supplies. In multiple
    Original PDF
    cs51021a
    CS51021ADEMO/D Demonstration Note for CS51021A/CS51022A A 36–72 V In, 5 V/5 A Out, Forward Converter Using the CS51021A/22A Enhanced Current Mode Controller http://onsemi.com DEMONSTRATION NOTE Features • Forward Convertor Topology • Undervoltage and Overvoltage Shutdown
    Original PDF
    an1792
    AN1792 APPLICATION NOTE DESIGN OF FIXED-OFF-TIME-CONTROLLED PFC PRE-REGULATORS WITH THE L6562 by C. Adragna Beside Transition Mode (TM) and fixed-Frequency Continuous Conduction Mode (FF-CCM) operation of PFC pre-regulators a third approach is proposed that couples the simplicity and affordability of TM
    Original PDF
    mcp1623
    MCP1623/24 Low-Voltage Input Boost Regulator for PIC® Microcontrollers Features: General Description: • Up to 96% Typical Efficiency • 425 mA Typical Peak Input Current Limit: - IOUT > 50 mA @ 1.2V VIN, 3.3V VOUT - IOUT > 175 mA @ 2.4V VIN, 3.3V VOUT
    Original PDF
    mcp1623
    MCP1623/24 Low-Voltage Input Boost Regulator for PIC® Microcontrollers Features General Description • Up to 96% Typical Efficiency • 425 mA Typical Peak Input Current Limit: - IOUT > 50 mA @ 1.2V VIN, 3.3V VOUT - IOUT > 175 mA @ 2.4V VIN, 3.3V VOUT - IOUT > 175 mA @ 3.3V VIN, 5.0V VOUT
    Original PDF
    mcp73853
    MCP73853/55 USB Compatible Li-Ion/Li-Polymer Charge Management Controllers Features Description • Linear Charge Management Controllers - Integrated Pass Transistor - Integrated Current Sense - Reverse Blocking Protection • High-Accuracy Preset Voltage Regulation: + 0.5%
    Original PDF
    mcp1623
    MCP1623/24 Low-Voltage Input Boost Regulator for PIC® Microcontrollers Features: General Description: • Up to 96% Typical Efficiency • 425 mA Typical Peak Input Current Limit: - IOUT > 50 mA @ 1.2V VIN, 3.3V VOUT - IOUT > 175 mA @ 2.4V VIN, 3.3V VOUT
    Original PDF