TB32 Search Results

HIP4080

Abstract: hip4081 Harris Semiconductor hip4080 2N3906 pin diagram Datasheets ALI C 2N3906 HARRIS SEMICONDUCTOR bhs19 zener 1.7v TB321
Contextual Info: Harris Semiconductor No. TB321 Harris Intelligent Power August 1993 HIP4080 AND HIP4081 HIGH FREQUENCY H-BRIDGE DRIVERS Author: George Danz HIP4080 and HIP4081 Power-up Application The HIP4080 and HIP4081 H-Bridge Driver ICs require external circuitry to assure reliable start-up conditions of the

n2 Diode Zener

Abstract: TB323 HI5701 6.2v zener MP7682
Contextual Info: Harris Semiconductor No. TB323 Harris Data Acquisition October 1993 REPLACING AN MP7682 WITH AN HI5701 Author: Phil Louzon occurs 1.5 cycles after the input is actually sampled. The data for the MP7682 is valid 0.5 cycles after the input is sampled. If a user’s application needs to keep track of what data

HP2810

Abstract: CA358A es 7240 HP2-810 HA2841 HA-2841 HI5800
Contextual Info: Clamping the Analog Input of the HI5800 Technical Brief January 1994 TB324 Author: Phil Louzon Figure 2 shows a photograph of the input to the converter with a 1MHz overdriven signal being clamped to 2.7V. The circuit was also tested with various power supply sequences

Contextual Info: Using the HSP45116/HSP45116A as a Complex Multiplier Accumulator Technical Brief July 1998 TB327.1 Introduction [ /Title TB32 7 /Subject (Using the HSP45 116/H SP451 16A as a Complex Multiplier Accumulator) /Autho r () /Keywords (Intersil Corporation, semiconductor)

es 7240

Abstract: nyquist nyquist plot TB326 HI5721
Contextual Info: Measuring Spurious Free Dynamic Range in a D/A Converter Technical Brief January 1995 TB326 Authors: Juan Garcia, Stephen G. LaJeunesse, Douglas Bartow Introduction As high speed DACs migrate into digital receivers and transmitters, spectral specifications become more important to

ADC calibration

Abstract: converter diagram sigma-delta TB329 HI718X
Contextual Info: Harris Semiconductor No. TB329 Harris Data Acquisition May 1995 Harris Sigma-Delta Calibration Technique Author: John Kornblum Introduction input voltages and a “negative full scale” input is used to generate a gain correction coefficient for negative input voltages.

A1013

Abstract: 302B HSP45116 IMIN018 G13-15 a15 harris c914
Contextual Info: Harris Semiconductor No. TB327 December 1994 Harris Digital Signal Processing USING THE HSP45116 AS A COMPLEX MULTIPLIER ACCUMULATOR Authors: John Fakatselis Introduction ond complex vector being input through the C0-15 port follows before it lines up with the first complex vector internal to the

TB325

Abstract: HI5721
Contextual Info: Harris Semiconductor No. TB325.1 Harris Data Acquisition January 1995 UNDERSTANDING GLITCH IN A HIGH SPEED D/A CONVERTER Authors: Juan Garcia and Stephen G. LaJeunesse Introduction V Today’s high speed D/A converters are used in communications applications such as:

ADC calibration

Abstract: TB329
Contextual Info: Intersil Sigma-Delta Calibration Technique Technical Brief May 1995 TB329 Author: John Kornblum Introduction input voltages and a “negative full scale” input is used to generate a gain correction coefficient for negative input voltages. While the analog modulator is critically important in determining

Contextual Info: HSL Terminal Boards 1 HSL-TB32-MD Software & Utilities 32-CH Separate I/O Terminal Base 2 Specifications General Description DAQ Separate I/O wiring connection for HSL I/O modules Every I/O points uses 3-pin connector Pin definition is signal/ground/power from left to right

MP7684

Abstract: MP7684A MICRO POWER SYSTEMS
Contextual Info: Semiconductor No. TB322.1 NEW D FOR NDE OMME May 1997 EC NOT R NS DESIG Harris Data Acquisition Replacing an MP7684/MP7684A with an HI5700 Author: Phil Louzon The HI5700 is a pin compatible device to the MP7684 and MP7684A from Micro Power Systems. The DIP version of

MP7684

Abstract: MP7684A TB322
Contextual Info: Harris Semiconductor No. TB322.1 NEW D FOR NDE OMME May 1997 EC NOT R NS DESIG Harris Data Acquisition Replacing an MP7684/MP7684A with an HI5700 Author: Phil Louzon The HI5700 is a pin compatible device to the MP7684 and MP7684A from Micro Power Systems. The DIP version of

TB32301M Controller Module

Abstract: Product Brief
Contextual Info: Product Brief TB32301M Controller Module Highlights Description • Simplifies the test and The TB32301M Controller Module uses the Toshiba TMP86FM48F 8-bit microcontroller with built-in 32K Flash and 2K RAM. The microcontroller with help of the on-board status LEDs and DIP

HSP45116A harris

Abstract: "multiplier accumulator" TB327 Numerically Controlled Oscillator
Contextual Info: semiconductor i Using the HSP45116/HSP45116A as a Complex Multiplier Accumulator T e ch n ica l B rie f J u ly 1998 TB327.1 Introduction The Harris HSP45116/HSP45116A Numerically Controlled Oscillator/Modulator can be also used as a high speed 16-Bit Multiplier/Accumulator CMAC . This technical brief­

RX2 ic

Abstract: RX2 DIAGRAM RX2 pin DIAGRAM TB32301AFL ic RX2 Marl
Contextual Info: Product Brief TB32301AFL 2.4 GHz Radio Communication IC Highlights Features • Delivers the utmost • BiCMOS process • Super heterodyne receiver: No IF SAW filter is needed due to linear demodulator. • Digital output on demodulator and digital input on modulator:

diagram for 3 bits binary multiplier circuit

Abstract: mod 132-145 a1013 HSP45116 HSP45116A Numerically Controlled Oscillator F13-15 c.mac
Contextual Info: TM Using the HSP45116/HSP45116A as a Complex Multiplier Accumulator Technical Brief July 1998 TB327.1 Introduction The exact timing relationships between inputs, outputs, control signals, and clocks are shown on Figure 2. Given the timing diagram of Figure 2 and the external interface circuit

hip4081

Abstract: HIP4080 2N3906 pin diagram 2N3906 bhs19 8 pin AHB
Contextual Info: HIP4080 and HIP4081 High Frequency H-Bridge Drivers Technical Brief August 1993 TB321 Author: George Danz HIP4080 and HIP4081 Power-up Application level of 1.7V while VDD/VCC is ramping up, so that shoot through is avoided. After power is up the chip can be

RX2 ic

Abstract: RX2 pin DIAGRAM RX2 DIAGRAM rx2 receiver ic remote control Communication Products TB32301AFL rf communication rx2 remote rx-2 ic RX2
Contextual Info: Product Brief TB32301AFL 2.4 GHz Radio Communication IC Highlights Features • Delivers the utmost • BiCMOS process • Super heterodyne receiver: No IF SAW filter is needed due to linear demodulator. • Digital output on demodulator and digital input on modulator:

AD9721

Abstract: HI5721
Contextual Info: Setup and Hold Considerations When Using the HI5721 Technical Brief February 1995 TB328 Authors: Stephen G. LaJeunesse, Juan C. Garcia, Doug Bartow Introduction Handling Long Hold Times High Speed D/A converters put great demands on the system designer when integrating them into a system. Logic timing

HI5701

Abstract: MP7682
Contextual Info: Replacing An MP7682 With An HI5701 Technical Brief October 1993 TB323 Author: Phil Louzon In all but one case, the HI5701 is a pin compatible device to the MP7682 from Micro Power Systems. Pin 4 of the Micro Power part provides an internal zener diode that can be

multiplier using CARRY SELECT adder

Abstract: HSP45116 HSP45116A 133137
Contextual Info: Using the HSP45116/HSP45116A as a Complex Multiplier Accumulator Technical Brief July 1998 TB327.1 Introduction The Intersil HSP45116/HSP45116A Numerically Controlled Oscillator/Modulator can be also used as a high speed 16-Bit Multiplier/Accumulator CMAC . This technical briefing details the part configuration to perform such functions; it

td 880

Abstract: 82C585 dp8025 EPT7029 smd diode 7 7 7 EPT7011 SMD diode CA 6 toshiba smd diode DST700
Contextual Info: Token Ring Applications Selection Table Standard Filter 802.5 = FLT DC = Diode Clamping Isol = Isolation PHTM = Phantom EMI = EMI Control UTP/STP = Cable tAlternate Package Available Controller Vendor Chips & Tech. 82C585 Toshiba TB32044F Nat'l Semiconductor

TB310

Contextual Info: Bridge Rectifiers Part No. KBP005 KBP01 KBP02 KBP04 KBP06 KBP08 KBP10 TB305 TB31 TB32 TB34 TB36 TB38 TB310 PB305 PB31 PB32 PB34 PB36 PB38 PB310 RS401L RS402L RS403L RS404L RS405L RS406L RS407L KBL005 KBL01 KBL02 KBL04 KBL06 KBL08 KBL10 TL400 TL401 TL402 TL404

hp2810

Abstract: harris opamp HP2-810 CA358A schottkey "negative clamp" HA2841 HA-2841 HI5800 TB3-24
Contextual Info: Harris Semiconductor No. TB324 Harris Data Acquisition January 1994 CLAMPING THE ANALOG INPUT OF THE HI5800 Author: Phil Louzon Figure 2 shows a photograph of the input to the converter with a 1MHz overdriven signal being clamped to 2.7V . The circuit was also tested with various power supply sequences