Part Number
    Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    L6561B Search Results

    Documents mentioning L6561B

    Document Partial File Text Tags Type PDF
    an1007
    AN1007 APPLICATION NOTE L6561 - BASED SWITCHER REPLACES MAG AMPS IN SILVER BOXES by Claudio Adragna Mag amps (a contraction of "Magnetic Amplifier") are widely used in multi-output switching power supplies to get auxiliary regulated power rails. However, they are expensive, bulky, and require a
    Original PDF
    an1059
    AN1059 APPLICATION NOTE  DESIGN EQUATIONS OF HIGH-POWER-FACTOR FLYBACK CONVERTERS BASED ON THE L6561 by Claudio Adragna Despite specific for Power Factor Correction circuits using boost topology, the L6561 can be successfully used to control flyback converters. Among the various configurations that an L6561-based
    Original PDF
    an2708
    AN2708 Application note 2X36 W digital dimmable ballast with L6574 and ST7FDALI Introduction This document describes a high-efficiency, high power factor, low THD and digital dimming electronic ballast designed to drive 2X36 W T8 tube lamps. The system consists of three main blocks:
    Original PDF
    an1376
    AN1376 APPLICATION NOTE 25W QUASI-RESONANT FLYBACK CONVERTER FOR SET-TOP BOX APPLICATION USING THE L6565 This document describes a reference design of a 25W Switch Mode Power Supply dedicated to Set-Top Box application. The board accepts full range input voltage (90 to
    Original PDF
    an1214
    AN1214 APPLICATION NOTE DESIGN TIPS FOR L6561 POWER FACTOR CORRECTOR IN WIDE RANGE by Cliff Ortmeyer & Claudio Adragna This application note will describe some basic steps to optimize the design of the L6561 PFC for wide range voltage input (105V- 300V) while also having a broad output power range (65W - 105W). Initial
    Original PDF
    an2782
    AN2782 Application note Solution for designing a 400 W fixed-off-time controlled PFC preregulator with the L6562A Introduction In addition to the transition mode (TM) and fixed-frequency continuous conduction mode (FF-CCM) operation of PFC pre-regulators, a third approach is proposed that couples the
    Original PDF
    an1376
    AN1376 APPLICATION NOTE 25W QUASI-RESONANT FLYBACK CONVERTER FOR SET-TOP BOX APPLICATION USING THE L6565 by Claudio Spini This document describes a reference design of a 25W Switch Mode Power Supply dedicated to Set-Top Box application. The board accepts full range input voltage (90 to 265Vrms) and delivers 5 outputs. It
    Original PDF
    an1059
    AN1059 APPLICATION NOTE  DESIGN EQUATIONS OF HIGH-POWER-FACTOR FLYBACK CONVERTERS BASED ON THE L6561 by Claudio Adragna Despite specific for Power Factor Correction circuits using boost topology, the L6561 can be successfully used to control flyback converters. Among the various configurations that an L6561-based
    Original PDF
    an1007
    AN1007 APPLICATION NOTE L6561 - BASED SWITCHER REPLACES MAG AMPS IN SILVER BOXES by Claudio Adragna Mag amps (a contraction of ”Magnetic Amplifier”) are widely used in multi-output switching power supplies to get auxiliary regulated power rails. However, they are expensive, bulky, and require a
    Original PDF
    an2761
    AN2761 Application note Solution for designing a transition mode PFC preregulator with the L6562A Introduction The TM (transition mode) technique is widely used for power factor correction in low and middle power applications, such as lamp ballasts, high-end adapters, flat TVs and monitors,
    Original PDF
    an1089
    AN1089 APPLICATION NOTE ® CONTROL LOOP MODELING OF L6561-BASED TM PFC by Claudio Adragna This paper provides a model and a tool for evaluating and improving the control loop characteristics of L6561-based PFC preregulators in boost topology and operated in Transition Mode (TM).
    Original PDF
    an1059
    AN1059 APPLICATION NOTE ® DESIGN EQUATIONS OF HIGH-POWER-FACTOR FLYBACK CONVERTERS BASED ON THE L6561 by Claudio Adragna Despite specific for Power Factor Correction circuits using boost topology, the L6561 can be successfully used to control flyback converters. Among the various configurations that an L6561-based
    Original PDF
    an1089
    AN1089 APPLICATION NOTE ® CONTROL LOOP MODELING OF L6561-BASED TM PFC by Claudio Adragna This paper provides a model and a tool for evaluating and improving the control loop characteristics of L6561-based PFC preregulators in boost topology and operated in Transition Mode (TM).
    Original PDF
    an1326
    AN1326 APPLICATION NOTE L6565 QUASI-RESONANT CONTROLLER by Claudio Adragna A variable frequency version of flyback converter, commonly known as Quasi-resonant (QR) ZVS flyback, is largely used in certain applications, such as SMPS for TV, though it is well suited for other applications too.
    Original PDF
    an1059
    AN1059 APPLICATION NOTE ® DESIGN EQUATIONS OF HIGH-POWER-FACTOR FLYBACK CONVERTERS BASED ON THE L6561 by Claudio Adragna Despite specific for Power Factor Correction circuits using boost topology, the L6561 can be successfully used to control flyback converters. Among the various configurations that an L6561-based
    Original PDF
    m
    AN966 APPLICATION NOTE  L6561, ENHANCED TRANSITION MODE POWER FACTOR CORRECTOR by Claudio Adragna The TM (Transition Mode) technique is widely used for Power Factor Correction in low power applications, such as lamp ballasts or low-end monitors. The L6561 is the latest ST’s proposal for this
    Original PDF
    an966
    AN966 APPLICATION NOTE  L6561, ENHANCED TRANSITION MODE POWER FACTOR CORRECTOR by Claudio Adragna The TM (Transition Mode) technique is widely used for Power Factor Correction in low power applications, such as lamp ballasts or low-end monitors. The L6561 is the latest ST’s proposal for this
    Original PDF
    an1060
    AN1060 APPLICATION NOTE  FLYBACK CONVERTERS WITH THE L6561 PFC CONTROLLER by C. Adragna & G. Gattavari The L6561, controller specifically designed for Power Factor Correction (PFC) circuits, may be successfully used in flyback converters as well. The excellent performance of the device, along with its characteristics in terms of low current consumption, makes L6561-based flyback converters really attractive in medium-low power applications.
    Original PDF
    an2782
    AN2782 Application note Solution for designing a 400 W fixed off-time controlled PFC pre-regulator with the L6562A Introduction In addition to the transition mode (TM) and fixed-frequency continuous conduction mode (FF-CCM) operation of PFC pre-regulators, a third approach is proposed that couples the
    Original PDF
    an1326
    AN1326 APPLICATION NOTE L6565 QUASI-RESONANT CONTROLLER by Claudio Adragna A variable frequency version of flyback converter, commonly known as Quasi-resonant (QR) ZVS flyback, is largely used in certain applications, such as SMPS for TV, though it is well suited for other applications too.
    Original PDF
    an1616
    AN1616 APPLICATION NOTE THD-OPTIMIZER CIRCUITS FOR PFC PRE-REGULATORS by Claudio Adragna Although THD (Total Harmonic Distortion) is not explicitly considered in IEC 61000-3-2 standards, neither it needs to be very low in order for a piece of equipment to get the presumption of conformity, however it has become established to require an ultra-low THD in some applications such as electronic
    Original PDF
    an1007
    AN1007 APPLICATION NOTE ® L6561 - BASED SWITCHER REPLACES MAG AMPS IN SILVER BOXES by Claudio Adragna Mag amps (a contraction of "Magnetic Amplifier") are widely used in multi-output switching power supplies to get auxiliary regulated power rails. However, they are expensive, bulky, and require a
    Original PDF
    AN1326 APPLICATION NOTE L6565 QUASI-RESONANT
    AN1326 APPLICATION NOTE L6565 QUASI-RESONANT CONTROLLER by Claudio Adragna A variable frequency version of flyback converter, commonly known as Quasi-resonant (QR) ZVS flyback, is largely used in certain applications, such as SMPS for TV, though it is well suited for other applications too.
    Original PDF
    l6561
    AN1214 APPLICATION NOTE DESIGN TIPS FOR L6561 POWER FACTOR CORRECTOR IN WIDE RANGE by Cliff Ortmeyer & Claudio Adragna This application note will describe some basic steps to optimize the design of the L6561 PFC for wide range voltage input (105V- 300V) while also having a broad output power range (65W - 105W). Initial
    Original PDF
    an1060
    AN1060 APPLICATION NOTE  FLYBACK CONVERTERS WITH THE L6561 PFC CONTROLLER by C. Adragna & G. Gattavari The L6561, controller specifically designed for Power Factor Correction (PFC) circuits, may be successfully used in flyback converters as well. The excellent performance of the device, along with its characteristics in terms of low current consumption, makes L6561-based flyback converters really attractive in medium-low power applications.
    Original PDF