JOSEPH Search Results

Contextual Info: REVISIONS LTR DESCRIPTION DATE YR-MO-DA APPROVED A Update drawing to the latest requirements. -sld 07-07-30 Joseph Rodenbeck B Table II, add note to Group C end-point test parameters. Update boilerplate paragraphs. -gz 09-12-08 Charles F. Saffle C Corrected dimensions for symbols D, D2, and L1 for case outline U.

Contextual Info: For Immediate Release Joseph Liu Chief Financial Officer Diodes Incorporated 805 446-4800 Philip Bourdillon Silverman Heller Associates (310) 280-2550 DIODES ANNOUNCES FOURTH QUARTER AND YEAR-END RESULTS Westlake Village, California - February 27, 1997 - Diodes Incorporated (ASE: DIO) today

Net Send Lite

Abstract: mr 582
Contextual Info: For Immediate Release Joseph Liu Chief Financial Officer Diodes Incorporated 805 446-4800 Philip Bourdillon Silverman Heller Associates (310) 208-2550 DIODES ANNOUNCES THIRD-QUARTER RESULTS - Revenues and Net Income at Record Levels - Westlake Village, California - October 17, 1997 - Diodes Incorporated (ASE: DIO) today

heller

Contextual Info: For Immediate Release Joseph Liu Chief Financial Officer Diodes Incorporated 805 446-4800 Philip Bourdillon Silverman Heller Associates (310) 208-2550 DIODES ANNOUNCES APPOINTMENT OF MICHAEL A. ROSENBERG AS PRESIDENT Westlake Village, California - October 9, 1997 - Diodes Incorporated (ASE: DIO)

DDR PHY ASIC

Abstract: ddr ram memory ic CP-01024-1 FLEX10K DDR2-800
Contextual Info: DesignCon 2007 Calibration Techniques for HighBandwidth Source-Synchronous Interfaces Manoj Roge, Altera Corporation Andy Bellis, Altera Corporation Phil Clarke, Altera Corporation Joseph Huang, Altera Corporation Mike Chu, Altera Corporation Yan Chong, Altera Corporation

CD4011AF

Abstract: schematic e.m.p CD4011F TVS 100V 300A
Contextual Info: Application Note Vishay Semiconductors formerly General Semiconductor Effect of Lead Wire Lengths on Protector Clamping Voltages By O. Melville Clark and Joseph J. Pizzicaroli Electrostatic Discharge ESD failures of MOS microcircuits have been measured by Gallace and Pujol2. Comparisons among

5962-9752701Q3A

Abstract: qml-38535
Contextual Info: REVISIONS LTR DESCRIPTION DATE YR-MO-DA APPROVED REV SHEET REV SHEET 15 16 REV STATUS OF SHEETS PMIC N/A REV SHEET 1 2 3 5 4 6 7 8 9 10 11 12 13 PREPARED BY DEFENSE SUPPLY CENTER COLUMBUS Joseph A. Kerby STANDARD MICROCIRCUIT DRAWING THIS DRAWING IS AVAILABLE

qml-38535

Abstract: 54ABT244 GDFP2-F20 smd "vhz"
Contextual Info: REVISIONS i DATE DESCRIPTION LTR APPROVED YR-MO-DA REV SHEET REV 15 SHEET 16 17 19 20 REV REV STATUS OF SHEETS 1 SHEET 2 Joseph A. Kerby STANDARDIZED MILITARY DRAWING THIS DRAWING IS AVAILABLE FOR USE BY ALL DEPARTMENTS AND AGENCIES OF THE DEPARTMENT OF DEFENSE

QML-38535

Abstract: 54LCX16244 GDFP1-F48
Contextual Info: REVISIONS LTR DESCRIPTION DATE YR-MO-DA APPROVED REV SHEET REV SHEET 15 16 REV STATUS OF SHEETS PM 1C N/A REV SHEET 1 2 3 4 5 PREPARED BY Joseph A. Kerby STANDARD MICROCIRCUIT DRAWING CHECKED BY Charles F. Saffle, Jr. THIS DRAWING IS AVAILABLE FOR USE BY ALL

qml-38535

Abstract: GDFP1-F48
Contextual Info: REVISIONS LTR DESCRIPTION DATE YR-MO-DA APPROVED REV SHEET REV SHEET 15 16 17 REV STATUS OF SHEETS PMIC N/A 18 19 REV SHEET 1 2 3 4 5 6 7 8 9 10 11 12 13 14 PREPARED BY DEFENSE SUPPLY CENTER COLUMBUS Joseph A. Kerby STANDARD M ICROCIRCUIT DRAW ING THIS DRAWING IS AVAILABLE

qml-38535

Abstract: CDFP2-F14 CQCC1-N20 GDFP1-F14 54AHC02
Contextual Info: REVISIONS LTR DESCRIPTION DATE YR-MO-DA APPROVED REV SHEET REV SHEET 15 16 17 REV STATUS OF SHEETS PMIC N/A REV SHEET 1 2 3 4 5 6 7 8 9 10 11 12 13 PREPARED BY DEFENSE SUPPLY CENTER COLUMBUS Joseph A. Kerby STANDARD MICROCIRCUIT DRAWING THIS DRAWING IS AVAILABLE

types of sensor

Abstract: lm35 to 4-20ma LM35 application circuits op-amp with 4-20ma ADC INPUT LMV521 4-20ma interface WITH ADC 4-20ma to digital ADC 4-20ma spi lm7332 Data Acquisition
Contextual Info: Data Acquisition in Factory Automation Harold Joseph and Jason Seitz 08/20/09 Panelists • Harold Joseph – Sr. Marketing Manager • Jason Seitz – Staff Applications Engineer 2 Objectives • Discuss National’s Factory Automation Campaign

AN1358

Abstract: 8p8c jack filter DF01S 1A 100V LM5070 12v output MODS-A-8P8C-X-C PA1269 RJ 45 8p8c RJ45 datasheet 8P8C 8P8C RJ45 CRCW0805
Contextual Info: National Semiconductor Application Note 1358 Joseph DeNicholas January 2005 Introduction Classification Mode The LM5070 AE Area Efficient evaluation board is designed to provide an IEEE802.3af compliant, Power over Ethernet (PoE) power supply. The power supply features the

Contextual Info: Sondra Sang 03/15/05 Ken Lin 03/15/05 Joseph Hsu 03/15/05 Co E U 20 pl ia nt C HS m Ro an A mp n ol Ta iw he 02/95 /E

zvs in buck converter design and implementation

Abstract: Power ZVS Buck Regulator ZVS boost converter transistor crossover P045F048T32AL V048F015T100 "FET based feedback" gain control amplifier
Contextual Info: Dual-Stage Feedback Technique for Single-Pole Feedback Compensation Joseph Aguilar, V•I Chip, Inc., USA Abstract This paper proposes and studies the effects of a dual-stage compensation technique for achieving greater than 100 kHz crossover frequency of a single pole system converting from 48 V to 1.2 V. By

Contextual Info: µ µ LINEAR ±0.1 ANGULAR ±1° "This product meets European Union Directives and other country regulations as described in GS-22-008" George V Joseph George V Joseph The housing will withstand exposure to 260°C peak temperature for 30 seconds in a convection,infra-red or vapor reflow oven solder application.

Am9513

Contextual Info: ADVANCED M ICRO DEVICES Am9513 SYSTEM TIMING CONTROLLER DETAILED FUNCTIONAL DESCRIPTION By Joseph H. Kroeger INTRODUCTION General Manipulation and coordination of timing param eters and event sequences are universal system attributes. At the most funda­ mental levels of control, time sequences are intimately em ­

Bode Plotter

Abstract: C1608X7R1H104K GRM188R71A105KA61D GRM31CR60J107ME39L TSW-102-07-G-S TSW-103-07-G-S CRCW06031M00JNEA TSW10508LD AN-2176
Contextual Info: National Semiconductor Application Note 2176 Joseph Wu July 29, 2011 LM10010 Overview ation board allows for control of the LM21215A-1 output voltage from 0.7V to 1.1V in 6.4mV steps. The evaluation board also includes a 10-pin header used for communication with

Contextual Info: REVISIONS LTR DESCRIPTION DATE YR-MO-DA APPROVED A Update drawing to the latest requirements. -sld 07-07-31 Joseph Rodenbeck B Table II, add note to Group C end-point test parameters. Update boilerplate paragraphs. -gz 09-12-08 Charles F. Saffle C Corrected dimensions for symbols D, D2, and L1 for case outline U.

5962-0255301HXC

Contextual Info: REVISIONS LTR DESCRIPTION DATE YR-MO-DA APPROVED A Update drawing to the latest requirements. -sld 07-07-25 Joseph Rodenbeck B Table II, add note to Group C end-point test parameters. Update boilerplate paragraphs. -gz 09-12-02 Charles F. Saffle C Correct dimensions for symbols D, D2, and L1 for case outline U.

N mos 100v 100A

Contextual Info: EFFECT OF LEAD WIRE LENGTHS ON PROTECTOR CLAMPING VOLTAGES by O. M elville Clark and Joseph J. Pizzicanti Originally presented at the Federal Aviation Adnninistration-Ftoriria Institute of Technology Workshop on Grounding and Lightning Technology March, 1979 - Melbourne, Florida

GL41A-Y

Contextual Info: SUPERECTIFIER DESIGN BRINGS NEW LEVEL OF RELIABILITY TO SURFACE MOUNT COMPONENTS Joseph M. Beck, Senior Applications Engineer COMPLETELY ENCAPSULATED BRAZED COWSTÎÎUCTtOM Surface Mount technology is here to stay. After years of plodding through cautious experimen­

SURFACE MOUNT SILICON RECTIFIER 3a

Contextual Info: SUPERECTIFIER DESIGN BRINGS NEW LEVEL OF RELIABILITY TO SURFACE MOUNT COMPONENTS by. Joseph M. Beck, Sr. Applications Engineer Surface Mount technology Is here to stay. After years of plodding through cautious ex­ perimentation, many manufacturers now have

D0213AB

Contextual Info: SUPERECTIFIER DESIGN BRINGS NEW LEVEL OF RELIABILITY TO SURFACE MOUNT COMPONENTS By: Joseph M. Beck, Senior Applications Engineer Surface Mount technology is here to stay. After years of plodding through cautious ex­ perimentation, many manufacturers now have