CL68 Search Results

CL680 C-Cube

Abstract: CL680 0x246
Contextual Info: 16 CL680 DRAM Configuration Reference This chapter describes the DRAM configuration reference, a collection of locations in local DRAM that the host may use to monitor and configure the operation of the CL680VCD and CL680CD-G modules. Note: Newer releases of microcode may contain values which differ from this chapter.

CL680 C-Cube

Contextual Info: 10 Clocking Considerations The clocking mechanism on the CL680 has been simplified considerably from the CL48x series to reduce the number of required clock circuits on the VCD board design. At the same time, the scheme provides substantial flexibility for system designers to cater to a wide variety of

CL680 C-Cube

Abstract: CL480 c-cube CL-480
Contextual Info: 1 Introduction Designed for VideoCD players, the CL680 is C-Cube’s third generation MPEG-1 audio/video decoder chip based on the CL480/484 architecture. Like all C-Cube VideoCD decoders, the CL680 integrates a CD-ROM decoder, MPEG system stream demultiplexer, MPEG-1 audio and video decoders and high-resolution still picture decoder on a single chip.

XFRV

Abstract: XFRV 13 CL680 C-Cube C-Cube microsystems
Contextual Info: 15 Interrupts The CL680’s 16 host interrupts are produced by the CL680 microcode, which monitors internal conditions while the decode and display processes execute. The host can enable each of the 16 interrupts independently through the INT_MASK configuration parameter.

C-Cube microsystems

Abstract: CL680 C-Cube
Contextual Info: 3 Signal Descriptions This chapter describes the signals that comprise the external physical interface to the CL680. The information presented for each signal includes the signal mnemonic and name, type input, output, or bidirectional , and description. (Note: The overbar symbol denotes active

CL680 C-Cube

Abstract: C-Cube microsystems
Contextual Info: 5 DRAM/ROM Interface This chapter describes the local DRAM/ROM interface bus. It details all of the signals necessary to connect the CL680 to a DRAM array and to the required ROM. The memory controller in the CL680 interacts directly with external memory and generates the control signals required to access external

C-Cube microsystems

Abstract: CL680 C-Cube
Contextual Info: BACK CL680 VideoCD MPEG-1 Audio/Video Decoder User’s Manual C-Cube Microsystems C-CUBE MICROSYSTEMS C-Cube Microsystems reserves the right to change any products described herein at any time and without notice. C-Cube Microsystems assumes no responsibility or liability arising from the use of the products described herein, except as expressly agreed to in writing by CCube Microsystems. The use and purchase of this product does not

CL680 C-Cube

Contextual Info: 7 Video Display Interface This chapter discusses the operation of the CL680 video display unit. The purpose of the CL680 video display unit is to output analog video that can either be displayed on a television or video monitor, or mixed with computer-generated graphics to provide a video signal within a

C-Cube microsystems

Abstract: CL680 C-Cube
Contextual Info: 11 Registers HOST_int is the only CL680 register used to configure and communicate with the CL680 and its microcode, although not all applications will use this register. This register can be accessed by setting the G/M bit to 1 see Section 4.2.4 . In the detailed definition given for the HOST_int register on the next

CL680 C-Cube

Contextual Info: 4 Host Interface Functional Description The CL680’s host interface, shown in Figure 4-1, provides a simple serial interface to the host. The 8-bit parallel interface of the CL48x has been replaced with a three-pin serial interface: HCK, HD-IN, and HDOUT. The host interface is intended to be used by a bring-up board or

CL480 c-cube

Abstract: CL680 C-Cube
Contextual Info: 1 Introduction Designed for VideoCD players, the CL680 is C-Cube’s third generation M PEG -1 audio/video decoder chip based on the CL480/484 architecture. 1.1 Overview Like all C-Cube VideoCD decoders, the CL680 integrates a CD-ROM de­ coder, MPEG system stream demultiplexer, MPEG-1 audio and video de­

CL680 C-Cube

Contextual Info: 14 Macro Commands The VideoCD-player host microprocessor software uses macro commands as its primary method of communication with the CL680. Macro commands are command IDs and argument values written into local DRAM by the host as described in Section 4.2.3 . Each command has

C-Cube microsystems

Abstract: CL680 C-Cube
Contextual Info: 8 Audio Interface DA-XCK This interface is designed to output audio samples in bit-serial format directly from the CL680 to the audio DACs, as shown in Figure 8-1. 8.1 General Description DA-DATA DA-LRCK Audio Interface DA-BCK Audio DACs DA-EMP CL680 Figure 8-1

CL680 C-Cube

Abstract: singing machine
Contextual Info: 12 Microcode Features The CL680 performs its higher-level functions by executing microcode on its internal CPU. A summary of the features of CL680 microcode is contained in this chapter. When the input bitstream is either a CD-DA or CD-ROM bitstream, the CL680 microcode can be enabled to either auto-detect the input bitstream or expect bitstreams of one type only.

CL484

Abstract: C-Cube CL680 karaoke rh10 CL680 C-Cube
Contextual Info: CL680 VIDEO-CD DECODER SINGLE-CHIP AUDIO/VIDEO/CD-ROM DECODER WITH INTEGRATED NTSC/PAL ENCODER The CL680 VideoCD Decoder is a highly integrated MPEG-1 system decoder for VideoCD players. • Higher Integration: The CL680 has an integrated digital NTSC/PAL encoder, eliminating

Intel MCS-86

Abstract: 0x00180 C-Cube microsystems CL680 C-Cube
Contextual Info: 13 Initialization The host processor executes an initialization sequence for the CL680 by interacting with the microcode either macro commands or the Configuration Area . For initialization to occur, the microcode must be loaded from ROM by issuing a pulse on the RESET pin.

Contextual Info: 8 MOO .19 LOC coot OF FO * REVISIONS P zone LrTR RLSE/NPR 90-137 REV PER EC DF-4866 A OATS APPO 5-22-90 dm dm s ft* s 5085 *!0K T 9 flCStftVED. OIST ¡ 0RAWIM6 M A O e IN THIRD A M GLC PROJECTION THIS DRAWING 15 UNPUBLISHED. RELEASEO FOR PUBLICATION OOPVftfOMT I t

Contextual Info: The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information. All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.

AP105-DF19S

Abstract: Hirose DF 59 CL901-4571-3 CL550-0284-7 CL902-4513-3 3032SCF DC100V DF19 connector header hrs df19kr
Contextual Info: NEW 1 mm-Pitch Low Profile Connector System for Wire to PCB Applications Suitable for use with Discrete Wire, FPC or Fine Coaxial Cable. DF19 Series Drawing of mated connectors on a DF19G - *P-1H board , , , , , , , , , , , ,

RIGHT ANGLE HEADER CONNECTOR SINGLE ROW 20 POS 5A

Abstract: UL1007 AWG18 CL680 UL1007 AWG20 UL1007 AWG22 AWG20 AWG22 AWG16 AWG18 3.5mm Pitch female header
Contextual Info: 3.96 mm Pitch Miniature Connectors for Internal Power Supplies UL,C-UL and TÜV Listed DF7 Series Complete Locking Function Completely enclosed locking system Full barrier between adjacent contacts. Prevention of Incorrect Connections •Features 1. Complete Locking Function

HASU05F

Abstract: touch screen 3M magtek 3M Touch Systems M150 multimedia card reader pin config microtouch CH1234 MAG-TEK MAGNETIC HEAD in card readers
Contextual Info: M150 Flat Panel Display Touch Monitor User Guide 3M Touch Systems, Inc. Read and understand all safety information contained in this document before using this product. 3M Touch Systems, Inc. Proprietary Information 2 M150 FPD Monitor User Guide The information in this document is subject to change without notice. No part of this document may be reproduced or transmitted

touch screen connector

Contextual Info: EX II USB Controllers Reference Guide EX II 5710UC EX II 5750UC EX II 7710UC 3M Touch Systems Read and understand all safety information contained in this document before using this product. 3M Touch Systems Proprietary Information 2 EX II USB Controllers Reference Guide

DF30

Abstract: Cl684 HRS DF30FC-40DP-0.4V
Contextual Info: 0.4 mm Pitch, 0.9 mm Height, Board-to-Board / Board-to-FPC Connectors DF30 Series Extremely small size Header 0 0.4 (0.90) (3 (4 22) .76 .56 ) (10. ) Receptacle 40 positions shown •Overview Continuous miniaturization and increased component density on PCB created demand for extremely low profile

B266

Abstract: DF20 anvil crimp drawing
Contextual Info: The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information. All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.