BLM550 Search Results

BLM550R

Abstract: BLM550RA01 MURATA BLM blm550
Contextual Info: BLM 550 MOUNT EMI FILTERS The BLM550R molded ferrite chip features high impedance in the 100MHz to 300MHz to provide substantial noise reduction in high frequency signal lines. They are also maqnetically shielded to reduce flux leakage on compact PC boards.

BLA81B01

Abstract: BLM550R NFM52R BLM550 BLM32 BLM41P03 NFM52 NFM51
Contextual Info: •mwifíntn Copper Foil Pattern BLM11 BLM21 BLM32 BLM31 BLM41 BLM550R EMI FILTERS As shown below, one side of the PCB is used for chip mounting, and the other is used for grounding. Small diameter feedthrough holes are then used to connect the grounds on each side of the PCB. This reduces the highfrequency impedance of the grounding and maximizes the

BLM32

Abstract: blm550 BLA81 emi FILTERS murata
Contextual Info: SURFACE MOUNT EMI FILTERS Murata Electronics’ surface mount ferrite beads provide impedances from several 10’s of ohms to more than 2000 ohms at frequencies of 10MHz or more. This effectively dampens the noise element when connected in series with a noise conducting circuit. The ferrite bead has virtually no

Contextual Info: EMI SUPPRESSION FILTERS SURFACE M O U N T FERRITE CHIPS m u F fn fa BLM SMT F e rrite B e a d s This new series of solid, ferrite chips for surface mount applica­ tions is designed to reduce the possibility of spurious oscillation in high frequency amplifying circuits and operate effectively from

tzbx4n100bc110

Abstract: MA2810-1 tz03p450fr LQH3NR27M92 kf 470 replacements transistors RPE110COG2R2C100V LQH3N220K04 DE1410E 1022R DE7100F222MVA1-KC
Contextual Info: DESIGN ENGINEERING KITS ★ KIT-GRM39 CAPACITORS— CHIB M O N O LITH IC • ■ ■ ■ ■ ■ muFfntn Part No. Miniature size Wide capacitance, TC, voltage and tolerance range Industry standard sizes 8mm and 12mm tape and reel for auto-placements Barrier layer termination systems for wave, reflow or vapor phase solder

tic 41

Abstract: tic 105 BLM550R blm550 BLM11 VFM41 BLM32
Contextual Info: REEL DIMENSIONS mtiffntn STORAGE REQUIREMENTS Be sure to observe the following storage requirements to prevent damage to the soldering of exposed electrode. 1. The maximum ambient tem perature and relative humidity in which these parts can be stored are 40°C and 70%,