Part Number
    Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    AN2033 Search Results

    Documents mentioning AN2033

    Document Partial File Text Tags Type PDF
    an2033
    AN2033 APPLICATION NOTE Soldering Resistance and Moisture Sensitivity Level (MSL) Classification of STMicroelectronics Lead-Free Devices The reliability of electronic components is validated using Moisture Sensitivity Level (MSL) tests because board mounting processes, especially solder reflow (for Surface Mount Devices - SMD), involve a highmoisture vapor pressure inside plastic packages and high temperatures.
    Original PDF
    an2034
    Current Sharing with Digital-DC™ Devices May 01, 2009 Application Note AN2034.0 Introduction This application note describes the features and setup procedure for Digital-DC devices configured in current sharing groups. These latest products employ an interdevice communication Bus called the Digital- DC bus
    Original PDF
    an2031
    Writing Configuration Files for Zilker May 01, 2009 Application Note AN2031.0 Introduction Zilker Labs Digital-DC™ devices must be configured through pin-strap settings or by using PMBus™ commands. A configuration file is a human-readable text file that contains a sequence of PMBus commands
    Original PDF
    zl9101m
    Digital DC/DC PMBus 12A Module ZL9101M Features The ZL9101M is a 12A variable output step-down PMBus-compliant digital power supply. Included in the module is a high performance digital PWM controller, power MOSFETs, an inductor, and all the passive components required for a
    Original PDF
    zl2008
    ZL2008 Features The ZL2008 is a digital DC/DC controller with integrated MOSFET drivers. Current sharing allows multiple devices to be connected in parallel to source loads with very high current demands. Adaptive performance optimization algorithms improve power conversion efficiency. Zilker
    Original PDF
    st72324
    ST72324 5V RANGE 8-BIT MCU WITH 8 TO 32K FLASH, 10-BIT ADC, 4 TIMERS, SPI, SCI INTERFACE ■ Memories – 8 to 32K dual voltage High Density Flash (HDFlash) with read-out protection capability. InApplication Programming and In-Circuit Programming for HDFlash devices
    Original PDF
    st7lite3
    ST7LITE3 8-bit MCU with single voltage Flash, data EEPROM, ADC, timers, SPI, LINSCI™ Features ■ Memories – 8 Kbytes program memory: single voltage extended Flash (XFlash) Program memory with read-out protection, In-Circuit Programming and In-Application programming (ICP and
    Original PDF
    ST7LITE1xB 8-BIT MCU WITH SINGLE VOLTAGE FLASH
    ST7LITE1xB 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, 5 TIMERS, SPI Memories – up to 4 Kbytes single voltage extended Flash (XFlash) Program memory with read-out protection, In-Circuit Programming and In-Application programming (ICP and IAP). 10K write/
    Original PDF
    st7267
    ST7267 USB 2.0 HIGH SPEED MASS STORAGE MICROCONTROLLER PRELIMINARY DATA ■ USB 2.0 Interface compliant with Mass Storage Device Class – Integrated USB 2.0 PHY – Supports USB High Speed and Full Speed – 1 control endpoint with two 64-byte buffers
    Original PDF
    st7lite3
    ST7LITE3 8-BIT MCU WITH SINGLE VOLTAGE FLASH, DATA EEPROM, ADC, TIMERS, SPI, LINSCI™ ■ Memories – 8 Kbytes program memory: single voltage extended Flash (XFlash) Program memory with read-out protection, In-Circuit Programming and In-Application programming (ICP and
    Original PDF
    st72324bl
    ST72324BLxx-Auto 3.3V range 8-bit MCU for automotive with 16/32 Kbyte Flash or 16 Kbyte ROM, 10-bit ADC, 4 timers, SPI and SCI interfaces Features Memories ■ 16/32 Kbyte dual voltage high density Flash (HDFlash) or 16 Kbyte ROM with readout protection capability (in-application
    Original PDF
    st72325
    ST72325 8-BIT MCU WITH 16 TO 60K FLASH/ROM, ADC, CSS, FIVE TIMERS, SPI, SCI, I2C INTERFACE PRELIMINARY DATA ■ Memories – 16K to 60K dual voltage High Density Flash (HDFlash) or up to 32K ROM with read-out protection capability. In-Application Programming and In-Circuit Programming for HDFlash
    Original PDF
    ST7232A 8-BIT MICROCONTROLLER WITH 8K FLASH/ROM,
    ST7232A 8-BIT MICROCONTROLLER WITH 8K FLASH/ROM, ADC, 4 TIMERS, SPI, SCI INTERFACE ■ Memories – 8K dual voltage High Density Flash (HDFlash) or ROM with read-out protection capability. InApplication Programming and In-Circuit Programming for HDFlash devices
    Original PDF
    st7lnb1y0
    ST7LNB1Y0 DiSEqC™ slave microcontroller for SaTCR based LNBs and switchers Features ■ Clock, reset and supply management – Reduced power consumption – Safe power on/off management by low voltage detector (LVD) – Internal 8 MHz oscillator ■ Communication interface
    Original PDF
    ZL6100 S DESIGN R NEW O T F R D A P E END EMENT
    ZL6100 S DESIGN R NEW O T F R D A P E END EMENT Data Sheet C O MM EPLAC R D N OT R E E D M EN ZL6105 R E C OM August 29, 2012 FN6876.3 Adaptive Digital DC/DC Controller with Drivers and Current Sharing Features ZL6100 is a digital power controller with integrated MOSFET
    Original PDF
    Digital DC/DC PMBus 17A Module ZL9117M Features
    Digital DC/DC PMBus 17A Module ZL9117M Features The ZL9117M is a 17A, variable output, step-down PMBus-compliant digital power supply. Included in the module is a high-performance digital PWM controller, power MOSFETs, an inductor, and all the passive components required for a
    Original PDF
    zl6100
    Application Note 1493 ZL6100EVAL1Z Evaluation Board The ZL6100 is an integrated mixed-signal power conversion and management IC that combines an efficient step-down DC/DC converter with key power and thermal management functions in a single package. The ZL6100 incorporates current sharing and adaptive
    Original PDF
    st7l15
    ST7L15 ST7L19 8-bit MCU for automotive with single voltage Flash/ROM memory, data EEPROM, ADC, 5 timers, SPI Features ■ Memories – 4 Kbytes program memory: Single voltage extended Flash (XFlash) or ROM with readout protection capability. In-application
    Original PDF
    st6215c
    ST6215CM-Auto ST6225CM-Auto 8-BIT MCUs WITH A/D CONVERTER, TWO TIMERS, OSCILLATOR SAFEGUARD & SAFE RESET Memories – 2K or 4K bytes Program memory (OTP, EPROM, FASTROM or ROM) with read-out protection – 64 bytes RAM Clock, Reset and Supply Management – Enhanced reset system
    Original PDF
    qst101
    QST101 Capacitive touch sensor device single key with individual key state output Preliminary Data Features ■ Patented charge-transfer design ■ Single QTouch™ key ■ Individual key state output ■ Fully “debounced” results ■ Self-calibration and drift compensation
    Original PDF
    ST7LITE1xB 8-BIT MCU WITH SINGLE VOLTAGE FLASH
    ST7LITE1xB 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, 5 TIMERS, SPI Memories – up to 4 Kbytes single voltage extended Flash (XFlash) Program memory with read-out protection, In-Circuit Programming and In-Application programming (ICP and IAP). 10K write/
    Original PDF
    ST72325 8-bit MCU with 16 to 60K Flash/ROM, ADC,
    ST72325 8-bit MCU with 16 to 60K Flash/ROM, ADC, CSS, 5 timers, SPI, SCI, I2C interface Features ■ Memories – 16K to 60K dual voltage High Density Flash (HDFlash) or up to 32K ROM with read-out protection capability. In-Application Programming and In-Circuit Programming for HDFlash
    Original PDF
    ST7LITE0x, ST7LITESx 8-BIT MICROCONTROLLER WITH
    ST7LITE0x, ST7LITESx 8-BIT MICROCONTROLLER WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, TIMERS, SPI ■ Memories – 1K or 1.5K bytes single voltage Flash Program memory with read-out protection, In-Circuit and In-Application Programming (ICP and
    Original PDF