630101 Search Results

Contextual Info: FHC6 SERIES The FHC6 series of active hybrid filters have been designed for oversampled NTSC, PAL or 601 pre and post applications. All FHC6 filters have the same tightly specified passband, transition and stopband characteristics and provide access for DC offset control. Sinx/x correction if required and gain are

bt601

Abstract: BT601-5
Contextual Info: CCIR REC.601 FILTERS SINGLE IN LINE Designed to meet the full requirements of REC ITU-R BT601-5 Part A for 4:2:2 studio systems, these CCIR Rec.601 filters are for use in Y.U.V. format Component processing. Using specially written software and careful attention to component layout, the very stringent parameters for pre and

ccir 624

Abstract: filter ccir 624
Contextual Info: GROUP DELAY PRE-CORRECTION The specifications for a number of television systems state that the transmitted signal must be precorrected in terms of group delay to allow for the distortion produced by the IF filters in television receivers. CCIR Rep.624 recommends three curves which apply variously to the following systems: B/PAL,

2 way audio splitter circuit

Abstract: audio splitter circuit
Contextual Info: SERIAL DIGITAL AUDIO PASSIVE SIGNAL SPLITTER AS400M The AS400M Serial Digital Audio Passive Signal Splitter answers a demand from systems engineers for an economical way of dividing a single serial digital audio signal between two destinations. The modules are designed for in line use and, having no powered components, are as

CCIR601

Abstract: TRW2242
Contextual Info: VIDEO OVERSAMPLING SMD FILTERS RA SERIES • Reflowable • Surface mount compatibility • Flat or Sinx/x versions • Washable • Small size, low cost • Luminance and Chrominance versions With reduced analogue filter costs resulting from oversampling techniques, there is an increased

DF16B0010

Abstract: DF28B0030 DF28B0050 DF36B0075 DF40B0100 DF40B0200 DP28B0020 DP36B0050
Contextual Info: HDTV DELAY LINES 30 MHz Bandwidth This range of video delay lines is designed to delay 30 MHz bandwidth video signals with minimum distortion. This range is fully phase equalised and give excellent time and frequency domain response. They may be cascaded to give a wider range of delay times. Other delay times

FE218

Abstract: FE216 BNC connectors INSERTION LOSS FE217
Contextual Info: CABLE EQUALISERS Long runs of cable often require equalisation for loss in signal amplitude with frequency. This range of cable equalisers is designed to correct this loss to within 0.1 dB when using the length of cable specified. The module will produce a total insertion loss of 3 dB when linked to the cable so that

by 260-200

Abstract: CCIR601 TRW2242
Contextual Info: VIDEO OVERSAMPLING SMD FILTERS RE SERIES • Reflowable • Surface mount compatibility • Flat or Sinx/x versions • Washable • Small size, low cost • Luminance and Chrominance versions With reduced analogue filter costs resulting from oversampling techniques, there is an increased

CCIR601

Abstract: FL676 FL677 FL714 FL715 TRW2242
Contextual Info: VIDEO OVERSAMPLING FILTERS SIL RANGE Features Space saving SIL package Sinx/x Selectable or Flat versions Small size, low cost Luminance and Chrominance versions This range of analogue filters has been designed for use in conjunction with a half band interpolating/decimating filter such as the TRW2242 or with the many encoder chips available which employ

TMC22190

Abstract: FL453 FL454 FL546 FL713 TMC2242
Contextual Info: RECONSTRUCTION FILTER LOW COST With the increasing use of High quality video techniques in applications outside the professional broadcast field such as Multimedia, engineers are looking to include a degree of filtering in the A/D and D/A processing while avoiding the use of large and expensive filters.

74250

Contextual Info: HK SERIES LOW COST HDTV FILTERS These filters are specifically designed for antialiasing and reconstruction in low cost analogue to digital and digital to analogue conversions operating at HDTV sampling rates, they are typically used in HDTV monitors, television sets and monitor quality interface products.

AH830

Contextual Info: AH830 FULLY BUFFERED COLOUR DIFFERENCE PREFILTER The AH830 has been designed to provide colour difference signal filtering with a flat shape for pre A/D applications sampling at 6.75 MHz. Interfacing to the system is simplified with high input and low output impedance op-amp buffer stages.

AH852

Contextual Info: AH852 NEAR 601 FULLY BUFFERED OVERSAMPLED UV PRE-FILTER The AH852 is a tightly specified anti-aliasing filter for use in oversampled colour difference applications. The filter has been optimised with an accurate factory-set gain of 6dB. Use of the latest operational amplifiers results in low current consumption and good differential phase and gain

Contextual Info: BFB SERIES ANTIALIASING FILTERS These very small, low cost, filters are intended for use with A-D and D-A composite NTSC video converters using a sample rate of 4 x sub-carrier frequency. The cut off rate is slower than often recommended to reduce time domain ringing.

din 42802

Abstract: AMP,simel insulated crimp lugs raychem catalog termination kit and splicing kit cma 10024 531220-2 simel AMP 2-520128-2 7483 Raychem 55A CATALOG 42770-2
Contextual Info: Catalog 296642 Focused Product Guide Revised 3-99 Input/Output Connectors Index Table of Contents Section One: Input/Output Connector Click Below Subminiature D, HDP-20 Crimp, Snap-In Connector AMPLIMITE Crimp, Snap-In Contacts and Solder Contacts, Size 20 D

smpte 274m

Abstract: realization of Passive filters datasheet HF7425SPA SMPTE274M 54200
Contextual Info: LOW COST HDTV FILTERS HF SERIES The HF range of low cost HDTV filters are available in a choice of miniature packages and give near SMPTE 274M performance suitable for single pass or monitor applications. • • • • • • Aqueous washable Ideal for monitor outputs

Jun-99

Abstract: AH844 AH842
Contextual Info: AH844 FULLY BUFFERED NTSC POST FILTER The AH844 is a low cost post D/A filter designed to complement the AH842 pre filter for NTSC applications using the 4 x fsc oversampled format. Interfacing to the system is simplified with high input and low output impedance op-amp buffer stages.

AH855

Contextual Info: AH855 FULLY BUFFERED HYBRID PRE/POST PAL FILTER The AH855 has been designed to filter PAL or full bandwidth RGB signals. The filter can be employed in either pre A/D or post D/A applications with user selection of the passband shape thereby simplifying the system inventory and ordering procedure.

TCD075B02

Contextual Info: TCD DELAY LINES ULTRA HIGH SPEED - WIDE BANDWIDTH The TCD range are ultra high speed balanced delay lines for wideband applications. Various impedances can be supplied with delay times up to a possible 10 ns. Delay lines can be cascaded to increase delay time. The

Contextual Info: FF….M SERIES LOW PASS VIDEO FILTER STEEPNESS FACTOR 1.14 This range of Elliptical Function Low Pass filters is intended for bandwidth limitation where a fast rate of cut off is required. It is especially useful in removing sound sub-carriers from a video signal while maintaining essential

BT601-5

Contextual Info: CCIR REC.601 FILTERS SINGLE IN LINE Designed to meet the full requirements of REC ITU-R BT601-5 Part A for 4:2:2 studio systems, these filters are for use in Y.U.V. format Component processing. Using specially written software and careful attention to component layout, the very stringent parameters for pre and

HF7425SPA

Abstract: smpte 274m 54200
Contextual Info: HF SERIES LOW COST HDTV FILTERS The HF range of low cost HDTV filters are available in a choice of miniature packages and give near SMPTE 274M performance suitable for single pass or monitor applications. • • • • • • Aqueous washable Ideal for monitor outputs

PAL 011a

Abstract: 400C DES-011A
Contextual Info: DES-011 SERIAL DIGITAL TO PARALLEL TTL MODULE • • • • • Auto 144,177,270, 360 mb/s Operation • Automatic Cable equalisation • + 5V DC power Small compact design for pcb mounting Composite or Component digital inputs 8 or 10 bit data Reclocked SD outputs available.

CMX5SM09G

Abstract: RG6 coaxial cable SMA pcb footprint Connector sma straight pcb mount RG174A/U rg6 f connector RG402/U RG405/U sma connector footprint pcb MOUNT JACK CONNECTOR
Contextual Info: CONNECTORS COAXIAL, SMA CO-TRON SMA A range of precision sub-miniature connectors giving repeatable electrical performance from DC to 12.4GHz 18GHz with semi-rigid cabling . The connectors offer a broadband performance with low reflection and constant 50Ω impedance. This, combined with minimum attenuation and