5V.1 DIODE Search Results

LM1117MPX-5.0 SOT-223

Abstract: R36 SOT223 0402 resistors HDR jumper led 0805 SOT R23 BAT 9V FEMALE HDR1X5 0402 resistor 1% 13 560
Contextual Info: 5 4 3 2 1 Vadj TP1 VCC TP11 GND Do Not Populate J1 VCC C1 5V 1 2 3 1 2 3 Place test points near edge of board. TP3 0.1 uFd NOTE: TP2 1 VIN TP5 1 5V Vin HEADER 3 0402 Vin VIN 1 5V DEFAULT JUMPER PIN 2 TO 3 5V 27 Vdd XRES 2 P1[0] 300 2 P1[1] P1[2] 300 P1[3]

Contextual Info: 5V, 5V Low Dropout Dual Regulator with RESET/ENABLE Description The CS-8135 is a low dropout, high cur­ rent 5V regulator. Also included is a standby 5V /1 0 m A output for pow ering system s w ith standby m em ory. Q uiescent current drain is less than 3m A w hen supplying 10mA loads from

DSM-5

Contextual Info: DSM/DWR Models www.murata-ps.com Dual Output, 3.3V and 5V, 15Watt DC/DC Converters FEATURES  Regulated 5V and 3.3V outputs  5V @ 2.65Amps/3.3V @ 3 Amps capability  15 Watts total output power  1" x 2" SMT or through-hole package 

TIL 730

Abstract: DSWM5077 RF10 RF9.1
Contextual Info: FEATURES • 0 5 6 GHz ^3 MODEL NO. ■ 400 nSec Switching Speed ■ Surface Mount t • DSWM5077 ' ; Diode SP11T SP11T RF11 20 RF10 19 RF9 18 Ó Ó Ó Tttt 1 GND ftytrc 2 G ND 3 -5V 5 RF COM 4 +5V 6 C3 "0 " 7 C2 "0 " 8 C1 "O" 9 CO „ 0 ’. .0 6 5 - -.1 1 0

MAX751cpa

Contextual Info: 19-0008; Rev 0; 10/92 >1/1 >1X1 >1/1 +5V-Output, Step-Up, Current-M ode PWM DC-DC C onverter The MAX751 is a +5V-output, CMOS, step-up, switch­ mode DC-DC converter. Minimum input start-up voltage is 1.2V. From a 2.7V supply, the output current capability

SN139

Abstract: LT1229 LT1253 LT1396 LT1396CMS8 LT1396CS8 SN1396 LTDY
Contextual Info: Final Electrical Specifications LT1396 Low Cost Dual 400MHz Current Feedback Amplifier October 1999 U FEATURES • ■ ■ ■ ■ ■ ■ ■ DESCRIPTIO 400MHz Bandwidth on ± 5V AV = 1 350MHz Bandwidth on ± 5V (AV = 2, – 1) 0.1dB Gain Flatness: 100MHz (AV = 1, 2 and –1)

74V1T66

Abstract: 74V1T66CTR 74V1T66STR SC-70-5L
Contextual Info: 74V1T66 SINGLE BILATERAL SWITCH • ■ ■ ■ ■ ■ ■ HIGH SPEED: tPD = 0.3ns TYP. at VCC = 5V LOW POWER DISSIPATION: ICC = 1µA(MAX.) at TA=25°C LOW "ON" RESISTANCE: RON = 6.5Ω (TYP.) AT VCC = 5V II/O = 1mA SINE WAVE DISTORTION: 0.04% AT VCC = 5V f = 1KHz

Contextual Info: r r u n LT1424-5 m TECHNOLOGY Isolated Flyback Switching Regulator with 5V O utput F€RTUR€S DCSCRIPTIOn • No Transformer “Third Winding” or Optoisoiator Required ■ Designed for Use with 1:1 Ratio Transformers ■ Fixed, Application Specific 5V Output Voltage

thermal fuse 16 amp

Contextual Info: ® INNOVATION and EXCELLENCE Dual Output Mixed Voltage, DSM/DWR Models SMT or Through-Hole, 3.3V and 5V 15Watt, DC/DC Converters Features • Regulated 5V and 3.3V outputs ■ 5V @ 2.65Amps/3.3V @ 3 Amps capability ■ 15 Watts total output power ■ 1" x 2" SMT or through-hole package

Contextual Info: OPA2691 OPA 269 1 OPA 269 1 SBOS224C – DECEMBER 2001 – REVISED FEBRUARY 2007 Dual Wideband, Current-Feedback OPERATIONAL AMPLIFIER With Disable FEATURES APPLICATIONS ● FLEXIBLE SUPPLY RANGE: +5V to +12V Single Supply ±2.5V to ±6V Dual Supply ● WIDEBAND +5V OPERATION: 190MHz G = +2

74V1T66

Abstract: SC-70-5L 74V1T66C-TR 74V1T66S-TR
Contextual Info: 74V1T66  SINGLE BILATERAL SWITCH • ■ ■ ■ HIGH SPEED: tPD = 0.1 ns TYP. at VCC = 5V LOW POWER DISSIPATION: ICC = 1 µA (MAX.) at TA = 25 oC LOW ”ON” RESISTANCE: RON = 10Ω (TYP.)AT VCC=5V II/O=100µA SINE WAVE DISTORTION 0.04% (TYP.) AT VCC=5V f=1KHz

Contextual Info: OPA2691 OPA 269 1 OPA 269 1 SBOS224C – DECEMBER 2001 – REVISED FEBRUARY 2007 Dual Wideband, Current-Feedback OPERATIONAL AMPLIFIER With Disable FEATURES APPLICATIONS ● FLEXIBLE SUPPLY RANGE: +5V to +12V Single Supply ±2.5V to ±6V Dual Supply ● WIDEBAND +5V OPERATION: 190MHz G = +2

Contextual Info: I j I / I \ 1 IfJ Z S / A d va n ce d L in e a r ALD2702A/ALD2702B ALD2702 D e vices, Inc. DUAL 5V RAIL TO RAIL PRECISION OPERATIONAL AMPLIFIER GENERAL DESCRIPTION FEATURES The ALD2702 is a dual monolithic operational amplifier intended primarily foraw ide range of analog applications in + 5V single powersupply and +5V

ISL83080E

Abstract: ISL83082E ISL83083E ISL83085E ISL83086E ISL83088E ISL8308XE
Contextual Info: ISL83080E, ISL83082E, ISL83083E, ISL83085E, ISL83086E, ISL83088E September 12, 2005 Data Sheet FN6085.6 ±15kV ESD Protected, 5V, Full Fail-Safe, Fractional 1/8 Unit Load, RS-485/RS-422 Transceivers Features The ISL8308XE are BiCMOS, ESD protected, 5V powered,

transistor to1a

Abstract: inductor 100mH to1a transistor ILC6375 ILC6375CP-33 ILC6375CP-50 2SA1213 MA735 to1a capacitor nichicon
Contextual Info: www.fairchildsemi.com ILC6375 1 Amp SOT-89 Step Down PWM Switcher Controller Features Description • Up to 1 Amp output current • 85% to 90% efficiency at 0.5A to1A VIN = 7V, VOUT = 5V • 85% efficiency at 10mA (VIN = 7V, VOUT = 5V) • 100% Duty Cycle for ultra low drop-out

25SV47M

Abstract: FAN5232 FDS6680S FDS6690A
Contextual Info: www.fairchildsemi.com FAN5232 Adjustable PWM Buck Controller for LCD PCs Features Description • Three outputs: Adjustable Buck, 3.3V-Always, 5V-Always • Adjustable synchronous switcher, 5V – 80% Vin • 1% internal reference precision • Current mode with voltage feed-forward

3150Z

Abstract: 3152EIBZ 3156EIBZ ISL3158EIUZ ISL3156EIUZ RS-422 Transceiver 3156Z 3153EIBZ ISL3152 ISL3150E
Contextual Info: ISL3150E, ISL3152E, ISL3153E, ISL3155E, ISL3156E, ISL3158E Data Sheet January 18, 2008 FN6363.1 ±16.5kV ESD IEC61000-4-2 Protected, Large Output Swing, 5V, Full Fail-Safe, 1/8 Unit Load, RS-485/RS-422 Transceivers Features The ISL315xE are BiCMOS, IEC61000 ESD protected, 5V

MAX680

Abstract: MAX681 8Khz Oscillator MAX680CPA MAX680CSA MAX864 MAX865 S4 C3 5V MAX680 narrow so
Contextual Info: 19-0896; Rev 1; 7/96 +5V to ±10V Voltage Converters _Features The MAX680/MAX681 are monolithic, CMOS, dual charge-pump voltage converters that provide ±10V outputs from a +5V input voltage. The MAX680/MAX681 provide both a positive step-up charge pump to develop

ISL3150E

Abstract: ISL3152E ISL3153E ISL3155E ISL3156E ISL3158E ISL315XE 3156E 3153EIBZ 3156EIB
Contextual Info: ISL3150E, ISL3152E, ISL3153E, ISL3155E, ISL3156E, ISL3158E Data Sheet December 14, 2006 FN6363.0 ±16.5kV ESD IEC61000-4-2 Protected, Large Output Swing, 5V, Full Fail-Safe, 1/8 Unit Load, RS-485/RS-422 Transceivers Features The ISL315XE are BiCMOS, IEC61000 ESD protected, 5V

83080eibz

Abstract: 3083z 3085Z 3088Z 83083EIBZ 3082E 83080E 3080z 3086Z 83083E
Contextual Info: ISL83080E, ISL83082E, ISL83083E, ISL83084E, ISL83085E, ISL83086E, ISL83088E Data Sheet April 22, 2008 ±15kV ESD, 5V, Full Fail-Safe, 1/8 Unit Load, RS-485/RS-422 Transceivers FN6085.9 Features • Pb-Free Available RoHS Compliant The ISL8308xE are BiCMOS, ESD protected, 5V powered,

MAX4645

Abstract: MAX4645EUA MAX4645EUK-T MAX4645EUT-T MAX4646 MAX4646EUA MAX4646EUK-T MAX4646EUT-T 604 SOT23-6
Contextual Info: 19-1653; Rev 1; 7/00 Fast, Low-Voltage, 2.5Ω, SPST, CMOS Analog Switches _Features ♦ +1.8V to +5V Single-Supply Operation ♦ Guaranteed RON 2.5Ω max 5V supply 3.5Ω max (3V supply) ♦ 1.8V Operation RON 30Ω typ Over Temperature

74LX1GU04

Abstract: 74LX1GU04CTR 74LX1GU04STR SC70-5
Contextual Info: 74LX1GU04 LOW VOLTAGE CMOS SINGLE INVERTER WITH 5V TOLERANT INPUT • ■ ■ ■ ■ ■ ■ ■ 5V TOLERANT INPUTS HIGH SPEED: tPD = 4.2ns MAX. at VCC = 3V LOW POWER DISSIPATION: ICC = 1µA (MAX.) at TA = 25°C POWER DOWN PROTECTION ON INPUTS AND OUTPUTS

6 inputs NOR gate truth table

Abstract: 74LX1G04 74LX1G04CTR 74LX1G04STR SC70-5
Contextual Info: 74LX1G04 LOW VOLTAGE CMOS SINGLE INVERTER WITH 5V TOLERANT INPUT • ■ ■ ■ ■ ■ ■ ■ 5V TOLERANT INPUTS HIGH SPEED: tPD = 4.2ns MAX. at VCC = 3V LOW POWER DISSIPATION: ICC = 1µA (MAX.) at TA = 25°C POWER DOWN PROTECTION ON INPUTS AND OUTPUTS

Switched-Capacitor Voltage Doublers 12v

Abstract: LTC1044 LTC660 LTC660CN8 LTC660CS8 LTC690 Voltage Doubler applications LTC126
Contextual Info: LTC660 100mA CMOS Voltage Converter U DESCRIPTION FEATURES • ■ ■ ■ ■ ■ ■ ■ Simple Conversion of 5V to – 5V Supply Output Drive: 100mA ROUT: 6.5Ω 0.65V Loss at 100mA Boost Pin (Pin 1) for Higher Switching Frequency Inverting and Doubling Modes