17MHZ Search Results

LB3218T1ROM

Abstract: OPA564 schottky S4 56a OPA365 OPA561 PGA112 TL074 Tachometer circuit 2011 Inductive current sensor of measurement PLC coupling OFDM
Contextual Info: OPA564 SBOS372E – OCTOBER 2008 – REVISED JANUARY 2011 www.ti.com 1.5A, 24V, 17MHz POWER OPERATIONAL AMPLIFIER Check for Samples: OPA564 FEATURES 1 • • 23 • • • • • • • HIGH OUTPUT CURRENT: 1.5A WIDE POWER-SUPPLY RANGE: – Single Supply: +7V to +24V

sdars radio tuner

Abstract: STA210 LBGA thermal STA210N STA240 HCMOS9 19X19 7402 block diagram JESD97 LBGA288
Contextual Info: STA240 Sirius SDARS channel, service & source decoder Data Brief Features • 2 Satellite and 1 terrestrial signal demodulators and decoders ■ Advanced DSP processor to implement PAC audio decoder ■ Requires a single 17MHz clock reference; all high-speed clock signals are derived using

850VDC

Contextual Info: 52168 PRI Line 1 8 3 2 6 7 4 5 SEC (Device) ELECTRICAL SPECIFICATIONS @ 25°C unless otherwise noted: LONGITUDINAL BALANCE: TBDdB min., 100k-17MHz, per ITU Method (L->M). D.C. RESISTANCE (@20°C): 1-3 , 0.535 Ohms ±10%. 2-4 , 0.535 Ohms ±10%. 8-6 , 0.260 Ohms ±10%.

Contextual Info: LF1 52278 SOLDER SUFFIX 1 7 PRI Line 3 SEC (Device) 2 6 4 ELECTRICAL SPECIFICATIONS @ 25°C unless otherwise noted: LONGITUDINAL BALANCE: TBDdB min., 25k-17MHz, per ITU Method (L->M). D.C. RESISTANCE (@20°C): 1-3 , 0.185 Ohms ±10%. 2-4 , 0.185 Ohms ±10%.

Contextual Info: LF1 52279 SOLDER SUFFIX PRI Line 1 8 3 6 2 7 4 5 SEC (Device) ELECTRICAL SPECIFICATIONS @ 25°C unless otherwise noted: LONGITUDINAL BALANCE: TBDdB min., 25k-17MHz, per ITU Method (L->M). D.C. RESISTANCE (@20°C): 1-3 , 0.200 Ohms ±10%. 2-4 , 0.200 Ohms ±10%.

LT5503

Contextual Info: LT5546 40MHz to 500MHz VGA and I/Q Demodulator with 17MHz Baseband Bandwidth FEATURES • ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ U ■ DESCRIPTIO The LT 5546 is a 40MHz to 500MHz monolithic integrated quadrature demodulator with variable gain amplifier VGA

Contextual Info: LTC6905 17MHz to 170MHz Resistor Set SOT-23 Oscillator FEATURES n n n n n n n n n n n One External Resistor Sets the Frequency Fast Start-Up Time: 100µs Typical Frequency Range: 17MHz to 170MHz Frequency Error ±0.5% Typ 17MHz to 170MHz TA = 0°C to 70°C, Over All Settings

LB 3218T1ROM

Abstract: OPA564 PLC coupling OFDM 3218T1ROM B350A-13-F TMP411 pos5100h powerline schematic diagram SLMA002 LAND PATTERN SPI Optical Tachometer
Contextual Info: OPA564 OP A5 64 www.ti.com SBOS372C – OCTOBER 2008 – REVISED NOVEMBER 2009 1.5A, 24V, 17MHz POWER OPERATIONAL AMPLIFIER Check for Samples: OPA564 FEATURES 1 • • 23 • • • • • • • HIGH OUTPUT CURRENT: 1.5A WIDE POWER-SUPPLY RANGE: – Single Supply: +7V to +24V

Contextual Info: SMD Monolithic Crystal Filters UM-4J, UM-5J 2POLE UM-4J Fundamental; 45MHz~60MHz UM-5J (Fundamental; 17MHz∼60MHz, 3rd overtone; 45MHz∼110MHz) Features ● UM-5 and UM-4 type of SMT products. 2 POLE the guaranteed attenuation for a fo-910kHz imaging frequency is 60dB or higher.

ATTEN30dB

Contextual Info: ELECTRICAL CHARACTERISTICS: Cutoff Freq: Transmit/ Receiver 17MHz±1.0MHz Insertion Loss: Transmit l.OdB Max @lMHz~10MHz Receiver l.OdB Max @lMHz~10MHz Attenuation: @20MHz Transmit 7dB Min Reciver 6dB Min @25MHz Transmit 19dB Min Reciver 14dB Min @30MHz Transmit 30dB Min Reciver 20dB Min

D21707A

Abstract: D45015A 4 E 5J
Contextual Info: SMD Type Monolithic Crystal Filters [Jacket Type] UM-4J, UM-5J 2POLE Fundamental; 17MHz~60MHz, 3rd overtone; 45MHz∼110MHz Features version of UM-4 and UM-5. ● Attenuation at 2 pole with image frequency of Completely Lead-Free fo-910kHz is 60dB or higher.

LBN16050

Contextual Info: 160MHz SAW Filter 17MHz Bandwidth China Electronics Technology Group Corporation No.26 Research Institute SIPAT Co., Ltd. Part Number: LBN16050 www. sipatsaw.com Features — For IF SAW filter — High attenuation — Single-ended operation — Dual In-line Package

Contextual Info: KM736V990 KM718V090 PRELIMINARY 512Kx36 & 1Mx18 Synchronous SRAM Document Tills 512Kx36 & 1Mx18-Bit Synchronous Pipelined Burst SRAM Revision History Rev. No. History Draft 0.0 Initial draft Jan. 18. 1999 Prelim inary 0.1 1. Update ICC & ISB values. 2. Remove tCYC 1 17MHz -8 5

Contextual Info: ELECTRICAL CHARACTERISTICS: Insertion Loss: 1.0dB Maximum @ 1MHz ~ 10MHz Return Loss: 15dB Minimum @ 1MHz ~ 10MHz Crosstalk: 30dB Minimum @ 1MHz ~ 10MHz Attenuation @ 30MHz Transmit: 30dB Minimum Receive: 20dB Minimum Cut-off Frequency: 17MHz Typical I/O Impedance: 100 Ohms

A556-3

Contextual Info: bel/ defining a degree of excellence 10 BASE T FILTER Bel A556-3899-00 . 800- .285 MAX .325 Top View .180 MAX 100° MAX 90° MIN .0 0 8 MIN .012 MAX Side View TxD- TD- TxD+ TD+ Basic Filter Specifications fc 3dB Cutoff : 17MHz Inband Variation (5-10MHz): <0.5dB

Contextual Info: OPA564 SBOS372E – OCTOBER 2008 – REVISED JANUARY 2011 www.ti.com 1.5A, 24V, 17MHz POWER OPERATIONAL AMPLIFIER Check for Samples: OPA564 FEATURES 1 • • 23 • • • • • • • HIGH OUTPUT CURRENT: 1.5A WIDE POWER-SUPPLY RANGE: – Single Supply: +7V to +24V

36Mhz

Abstract: 455 XTAL PLL500-17SC-R P500-17 17Sc 881-i diode vcxo 36Mhz PLL500-17 PLL500-17DC PLL500-17SC
Contextual Info: PLL500-17 Low Phase Noise VCXO 17MHz to 36MHz FEATURES • • • • • • • • VCXO output for the 17MHz to 36MHz range Low phase noise (-130 dBc @ 10kHz offset at 35.328MHz). CMOS output with OE tri-state control. 17 to 36MHz fundamental crystal input.

Contextual Info: 52184 PRI Line 1 8 3 2 6 7 4 5 SEC (Device) ELECTRICAL SPECIFICATIONS @ 25°C unless otherwise noted: LONGITUDINAL BALANCE: TBDdB min., 100k-17MHz, per ITU Method (L->M). D.C. RESISTANCE (@20°C): 1-3 , 0.630 Ohms ±10%. 2-4 , 0.630 Ohms ±10%. 8-6 , 0.320 Ohms ±10%.

booster pump control system using PLC

Abstract: schematic Class D 1KW RMS audio amplifier led flip-chip heatsink OPA564AQ
Contextual Info: OPA564-Q1 SBOS567 – JUNE 2011 www.ti.com 1.5A, 24V, 17MHz POWER OPERATIONAL AMPLIFIER Check for Samples: OPA564-Q1 FEATURES 1 • • • 23 • • • • • • • Qualified for Automotive Applications High Output Current: 1.5A Wide Power-Supply Range:

Contextual Info: ABV0017B/27B/37B Low Power CMOS Output VCXO Family 17MHz to 130MHz PIN CONFIGURATION FEATURES • • • • • • • DESCRIPTION The ABV0017B/27B/37B are a low cost, high performance, low phase noise, and high linearity VCXO family for the 17 to 130MHz range, providing less

JTX-4-10T

Abstract: LT5511 LT5512 LT5546 LT5546EUF MO-220 LT1818CS 284MHz LT5503
Contextual Info: LT5546 40MHz to 500MHz VGA and I/Q Demodulator with 17MHz Baseband Bandwidth U FEATURES DESCRIPTIO • The LT 5546 is a 40MHz to 500MHz monolithic integrated quadrature demodulator with variable gain amplifier VGA and 17MHz I/Q baseband bandwidth designed for low voltage operation. It supports standards that use a linear modulation format. The chip consists of a VGA, quadrature downconverting mixers and 17MHz lowpass noise filters (LPF).

analog input optocoupler

Contextual Info: OPA564 SBOS372E – OCTOBER 2008 – REVISED JANUARY 2011 www.ti.com 1.5A, 24V, 17MHz POWER OPERATIONAL AMPLIFIER Check for Samples: OPA564 FEATURES 1 • • 23 • • • • • • • HIGH OUTPUT CURRENT: 1.5A WIDE POWER-SUPPLY RANGE: – Single Supply: +7V to +24V

schottky S4 56a

Abstract: led flip-chip heatsink schematic Class D 1KW RMS audio amplifier OPA564AQ 20KW DC motor
Contextual Info: OPA564-Q1 SBOS567 – JUNE 2011 www.ti.com 1.5A, 24V, 17MHz POWER OPERATIONAL AMPLIFIER Check for Samples: OPA564-Q1 FEATURES 1 • • • 23 • • • • • • • Qualified for Automotive Applications High Output Current: 1.5A Wide Power-Supply Range:

Contextual Info: OPA564 SBOS372E – OCTOBER 2008 – REVISED JANUARY 2011 www.ti.com 1.5A, 24V, 17MHz POWER OPERATIONAL AMPLIFIER Check for Samples: OPA564 FEATURES 1 • • 23 • • • • • • • HIGH OUTPUT CURRENT: 1.5A WIDE POWER-SUPPLY RANGE: – Single Supply: +7V to +24V