04OCT2011 Search Results

Contextual Info: 4 THIS DRAWING IS UNPUBLISHED. C COPYRIGHT 20 RELEASED FOR PUBLICATION LOC I ALL RIGHTS RESERVED. BY - 20 2 3 TYPICAL APPLICATION 1 REVISIONS DIST 2 P A A1 D DWN APVD FIRST ISSUE 17FEB2010 AV GT REVISED MARKS ON -5 WAS MARKED AC 04OCT2011 AV GT REVISED PER ECR-13-009678

Contextual Info: VNQ6004SA-E Quad-channel high-side driver with 16-bit SPI interface Datasheet - production data – Reverse battery protected through power outputs self turn-on no external components – Load dump protected – Protection against loss of ground PSSO36 Description

Contextual Info: L6370Q 2.5 A single high-side smart power switch Datasheet - production data • Two diagnostic outputs • Output status LED driver • Non-dissipative short-circuit protection • Surge and transient protection IEC61000-4-5 • Burst transient immunity (IEC61000-4-4)

Contextual Info: L6370Q 2.5 A single high-side smart power switch Features Type Vdemag RDSon Iout Vs L6370Q Vs-50 V 0.1 Ω 2.5 A 50 V • 2.5 A output current ■ 9.5 V to 35 V supply voltage range ■ Internal current limiting ■ Thermal shutdown Applications ■ Open ground protection

Contextual Info: SPV1040 High efficiency solar battery charger with embedded MPPT Datasheet — production data Features • 0.3 V to 5.5 V operating input voltage ■ 140 mΩ internal synchronous rectifier ■ 120 mΩ internal power active switch ■ 100 kHz fixed PWM frequency

Contextual Info: VNQ6004SA-E Quad-channel high-side driver with 16-bit SPI interface Datasheet − production data Features Channel VCC RON typ ILIMH(min) 0–1 28 V 30 mΩ 25 A 2–3 28 V 10 mΩ 55 A PSSO36 Description • ■ ■ General – 16-bit ST-SPI for full and diagnostic

Contextual Info: STEVAL-PCC009V4 Opto-isolated universal USB to serial bridge demonstration board for motor control applications Data brief Features • STM32-based demonstration board used as the interface between the PC and motor control systems ■ 8-pin interface for SPI/I2C/UART

Contextual Info: L6370Q 2.5 A single high-side smart power switch Features Type Vdemag RDSon Iout Vs L6370Q Vs-50 V 0.1 Ω 2.5 A 50 V • 2.5 A output current ■ 9.5 V to 35 V supply voltage range ■ Internal current limiting ■ Thermal shutdown Applications ■ Open ground protection

stl18n55m5

Contextual Info: STL18N55M5 N-channel 550 V, 0.205 Ω, 13 A PowerFLAT 8x8 HV MDmesh™ V Power MOSFET Features Type VDSS @ TJmax RDS on max ID STL18N55M5 600 V < 0.270 Ω 13 A (1) 3 3 3 "OTTOMVIEW ' $ 1. The value is rated according to Rthj-case • 100% avalanche tested

UM0627

Abstract: stlink STM8 SWIM ERNI STM8 programming manual
Contextual Info: UM0627 User manual ST-LINK in-circuit debugger/programmer for STM8 and STM32 microcontrollers Introduction The ST-LINK is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The SWIM and JTAG/SWD interface is used to communicate with the STM8 or STM32

VNQ6004

Abstract: VNQ6004SA-E VNQ6004SA VNQ600 VNQ6004S
Contextual Info: VNQ6004SA-E Quad-channel high-side driver with 16-bit SPI interface Datasheet − production data Features Channel VCC RON typ ILIMH(min) 0–1 28 V 30 mΩ 25 A 2–3 28 V 10 mΩ 55 A PSSO36 Description • ■ ■ General – 16-bit ST-SPI for full and diagnostic

STBB1-A

Abstract: STBB1-APUR STBB1 XFL4020-222M marking bb1 BB1A XFL4020-222ME COILCRAFT XFL4020
Contextual Info: STBB1-AXX 1 A, high efficiency single inductor dual mode buck-boost DC-DC converter Features • Buck-boost DC-DC converter ■ Operating input voltage range from 2.0 V to 5.5 V ■ 2% DC feedback voltage tolerance ■ Synchronous rectification ■ Shutdown function

SPV1040

Abstract: document for mppt algorithm "low voltage" Solar mppt spv104 DC - DC converter MPPT built-in algorithm mppt solar charge circuit
Contextual Info: SPV1040 High efficiency solar battery charger with embedded MPPT Datasheet - production data Description The SPV1040 device is a low power, low voltage, monolithic step-up converter with an input voltage range from 0.3 V to 5.5 V, and is capable of maximizing the energy generated by even a

SPV1040

Abstract: AM02612v1 document for mppt algorithm BOOST CONVERTER MPPT mppt solar charge circuit MPPT control SPV1040TTR
Contextual Info: SPV1040 High efficiency solar battery charger with embedded MPPT Features • 0.3 V to 5.5 V operating input voltage ■ 140 mΩ internal synchronous rectifier ■ 120 mΩ internal power active switch ■ 100 kHz fixed PWM frequency ■ Duty cycle controlled by MPPT algorithm