TTLOS Search Results

TH4B

Contextual Info: PHAST-3N STM-1/STS-3/STS-3c SDH/SONET Overhead Terminator with Telecom Bus Interface TXC-06103 DATA SHEET • • • • • • • • • • • • • • • • • Bit-serial SDH/SONET line interface - Pseudo-ECL interface with clock recovery and synthesis

MQUAD

Abstract: TQ2059 TQ2059-MC
Contextual Info: T R I Q U I N T S E M I C O N D U C T O R, I N C . TQ2059 REFCLK GND NC NC 10 9 8 7 6 5 High-Frequency Clock Generator 4 NC 12 Phase Detector ÷10 VCO NC 13 TEST1 14 TEST2 15 NC 16 NC 17 27 NC GND 18 26 MUX ÷2 MUX 3 NC 2 NC 1 NC Control 28 NC 19 20 21 22

IC 3526

Contextual Info: DEVICE SPECIFICATION 9-O U TPU T C LO CK DRIVER FEATURES • Five clock outputs at reference frequency up to 80 Mhz • Four clock outputs at half reference frequency up to 40 Mhz • Leading edge skew for all outputs <350 ps • Proprietary output drivers with:

FC66M

Contextual Info: D E V IC E S P E C IF IC A T IO N 10 AND 14-OUTPUT LVTTL CLOCK DRIVERS FEATURES • T en o r fo u rte en c lo c k outpu ts - Outputs operate at frequencies up to 80 M Hz - Outputs grouped in two banks of five outputs on SC3318 SC3318/27/67/68 APPLICATIONS

Contextual Info: PRELIMINARY DEVICE SPECIFICATION > 4 M C 14-OUTPUT C LO CK DRIVER FEATURES C S3LV368 APPLICATIONS • Six clock outputs at primary reference frequency up to 100 Mhz • Eight clock outputs selectable at half primary reference frequency up to 50 Mhz, or at sec­

AUSTRIA MIKRO SYSTEME INTERNATIONAL

Abstract: XC17XX Eland AS350 AS2720
Contextual Info: Preliminary AS2720 Ayr M M fflS S sJF ! 1 | .•s s s s s s s s s s s s s s s s s s s f " m W hbbbbJ B W w — f Austria SViikr# System« International MediaFlex Programmable Network Access Point IM General Description Key Features □ Programmable LAN access point

Contextual Info: DEVICE SPECIFICATION IO-OUTPUT CLOCK DRIVER GENERAL DESCRIPTION The SC3518 is a minimum skew clock driver with ten outputs. It can employ a clock input from a single ended TTL or an ECL differential source operating between +5V and ground. This reference frequency input is

Contextual Info: DEVICE SPECIFICATION IO-OUTPUT CLOCK DRIVER SC3517 FEATURES GENERAL DESCRIPTION • Ten clock outputs: The SC3517 is a precision low skew clock driver with ten outputs. It requires a 2X frequency clock input from a single-ended TTL or an ECL differential source operating between +5V and ground. This 2X

SC3526

Abstract: SC3S26 2bl5
Contextual Info: DEVICE SPECIFICATION 9-OUTPUT CLOCK DRIVER SC3526 GENERAL DESCRIPTION FEATURES • Five clock outputs at reference frequency up to 80 Mhz • Four clock outputs at half reference frequency up to 40 Mhz • Leading edge skew for all outputs <350 ps • Proprietary output drivers with:

Contextual Info: DEVICE SPECIFICATION 10 AND 14-OUTPUT LVTTL CLOCK DRIVERS FEATURES • Ten or fourteen clock outputs - Outputs operate at frequencies up to 80 MHz - Outputs grouped in two banks of five outputs on SC3318 - Outputs grouped in a bank of six and a bank of eight outputs on the SC3368

100 watt inverter ckt

Abstract: SC3502Q SC3502Q-1 SC3502-1
Contextual Info: \ - i J — n |- ^ / DEVICE SPECIFICATION 2 \ -| J M J i 20-OUTPUT CLOCK DRIVER / INVERTER SC3502I GENERAL DESCRIPTION FEATURES • Twenty 20 clock outputs: - Five (5) outputs at primary frequency, up to 80 MHz - Five (5) inverted outputs at the primary

Contextual Info: DEVICE SPECIFICATION 10 AND 14-OUTPUT LVTTL CLOCK DRIVERS 10 AND 14-OUTPUT LVTTL CLOCK DRIVERS FEATURES SC3318/68 SC3318/68 APPLICATIONS • Ten or fourteen clock outputs – Outputs operate at frequencies up to 80 MHz – Outputs grouped in two banks of five outputs

7 pin dil smps power control ic

Abstract: smps control ic with 6 pin sip 6 PIN SMD IC FOR SMPS 7pin smps IC smps ic smd 8 pin 8 PIN SMD IC FOR SMPS 6 PIN SMD IC FOR SMPS primary smps control ic with 6 pin smd 7pin smps control ic 8pin sip 10k
Contextual Info: June 2001 Founded in 1970, Rhombus Industries Incorporated is a privately owned corporation and a leading designer and manufacturer of transformers and magnetic products. Our headquarters is located in Huntington Beach, California and includes engineering, research

Contextual Info: TTL Pulse Width Discriminators TTL Pulse Width Generator Modules Triggered by the inpurs rising edge input pulse width 10 ns, min. , a pulse of specified width will be generated at the output with a propagation delay of 5 ± 2 ns (7 ± 2 ns, for inverted output).

24v Power Distribution Board

Abstract: SC3327
Contextual Info: PRELIMINARY DEVICE SPECIFICATION > 4 M C IO -O U TPU T C LO CK DRIVER FEATURES • Three 3 clock outputs at primary reference frequency up to 80 Mhz • Seven (7) clock outputs selectable at half primary reference frequency up to 40 Mhz, or at secondary reference frequency up to SO Mhz

Contextual Info: IO-OUTPUT LVTTL CLOCK DRIVER FEATURES • Ten clock outputs at primary frequency up to 100 MHz • All outputs are leading-edge synchronized to within <0.5 ns • Proprietary output drivers with: - Complementary 24 mA peak outputs, source and sink - 50-75Q source series termination

TXC 04216 marking

Abstract: 6401H X-00H
Contextual Info: PHAST-3N STM-1/STS-3/STS-3c SDH/SONET Overhead Terminator with Telecom Bus Interface TXC-06103 DATA SHEET • • • • • • • • • • • • • • • • Bit-serial SDH/SONET line interface - Pseudo-ECL interface with clock recovery and synthesis

M2121

Contextual Info: DEVICE SPECIFICATION 9 AND IO-OUTPUT CLOCK DRIVERS FEA TU RES SC3517/18/26/27/28/29 A PP LIC A TIO N S • Nine or Ten clock outputs: • Compatible with Intel’s Pentium processor - O u tp u ts o perate a t fre q u e n c ie s , up to 80 M H z • Compatible with PowerPC™ processors

Contextual Info: PRELIMINARY DEVICE SPECIFICATION > 4 M C 14-OUTPUT CLOCK DRIVER C SC3367 APPLICATIONS FEATURES • Datacom and Telecom networks • Compatible with Intel's Pentium and P6 processors • PCI Bus clock distribution • Workstation and server systems with

Intel 486 SL Microprocessor SuperSet System Design

Abstract: 4510 pinouts NS486 SXF 8254 programmable interval timer NS486 NS486SXF capacitor 105 35K 102 ECP88 DS1287 IEEE-1284
Contextual Info: November 1996 Support: ns486@arador.nsc.com NS486SXF Optimized 32-bit 486-class Controller With On-chip Peripherals for Embedded Systems General Description The NS486SXF is a highly integrated embedded system controller incorporating an Intel486-class 32-bit

EF86

Abstract: NS486SXF CS16 NS486
Contextual Info: Appendix A: Key Processor Differences from the ‘486 Appendix A: Key Processor Differences from the ‘486 The NS486SXF’s 32-bit processor is instruction set compatible with the standard Intel486 processor with the following exceptions: 1 NS486SXF operates in 16-bit and 32-bit protected

Contextual Info: DEVICE SPECIFICATION IO-OUTPUT CLOCK DRIVER FEATURES • Ten clock outputs at primary frequency up to 80 MHz • Leading edge skew for all outputs <0.5 na • Proprietary output drivers with: - Complementary 24 mA peak outputs, source and sink - 50-75C1 source series termination

TTLOS

Abstract: ttl_pw TTLOS-50 TTLOS-10 TTLOS-15 TTLOS-20 TTLOS-25 TTLOS-30 TTLOS-33 TTLOS-35
Contextual Info: TTL Gated Oscillators TTL Pulse Width Generator Modules TTL Pulse Width Discriminators These gated oscillators permit synchronization of the output square wave with the high-tolow transition of the enable input. When the enable is high, the output is held high. The

ECL 10138

Contextual Info: >4M C C IO-OUTPUT LVTTL CLOCK DRIVER FEATURES • Ten clock outputs at primary frequency up to 100 MHz • All outputs are ieading-edge synchronized to within <0.5 ns • Proprietary output drivers with: - Complementary 24 mA peak outputs, source and sink