Part Number
    Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    THAT2252 Search Results

    THAT2252 Datasheets (3)

    THAT
    Part ECAD Model Manufacturer Description Datasheet Type PDF PDF Size Page count
    THAT2252
    THAT IC RMS-level detector Original PDF 188.07KB 10
    THAT2252
    THAT IC RMS-Level Detector Original PDF 375.25KB 10
    THAT2252
    THAT IC RMS-Level Detector Original PDF 117.22KB 4

    Documents mentioning THAT2252

    Document Partial File Text Tags Type PDF
    that2180
    1 THAT Corporation Design Note 107/111 A simple, effective soft-knee compressor/limiter The schematic shown in Figure 1 is a basic soft-knee compressor/limiter circuit that can be used as-is or as the basis for a more sophisticated design. The circuit consists of a THAT2180C VCA, a THAT2252 RMS level detector, a few op-amps, and
    Original PDF
    that2180c
    1 THAT Corporation Design Note 107 / 111 A simple, effective soft-knee compressor/limiter The schematic shown in Figure 1 is a basic soft-knee compressor/limiter circuit that can be used as-is or as the basis for a more sophisticated design. The circuit consists of a THAT2180C VCA,
    Original PDF
    lt1054
    1 THAT Corporation Design Note 105 Low Voltage Compressor / Limiter The following circuit is a standard compressor / limiter adapted to run off +5 volts and -4 volts. A Linear Technology LT1054 is used to generate the -4 volt rail as shown in Figure 2. C14 47p
    Original PDF
    1 THAT Corporation Design Note 116 Techniques for
    1 THAT Corporation Design Note 116 Techniques for stereo volume control (with optional compressor/limiter) This design note includes techniques for implementing: 1. Stereo control of a VCA with a single, linear potentiometer 2. Multiple adjustment slope across the range
    Original PDF
    rms detector
    1 THAT Corporation Design Note 114 Adaptive attack and release rates using THAT Corporation RMS detectors (the Non-Linear Capacitor circuit) Single-band compressor designs must contend with the trade off between fast detector response (to minimize some compressor artifacts), and low frequency distortion (the result
    Original PDF
    the solutions are out there you just haven’t
    the solutions are out there you just haven’t registered yet… RoadTest the newest products in the market! View the latest news, design support and hot new technologies for a range of applications Join the RoadTest group and be in with a chance to trial exclusive new products for free. Plus, read
    Original PDF
    rms detector
    1 THAT Corporation Design Note 114 Adaptive attack and release rates using THAT Corporation RMS detectors (the Non-Linear Capacitor circuit) Single-band compressor designs must contend with the trade off between fast detector response (to minimize some compressor artifacts), and low frequency
    Original PDF
    rms detector
    1 THAT Corporation Design Note 131 Dealing with the PTAT Coefficient The nature and origin of the PTAT coefficient in THAT Corporation’s VCAs and RMS detectors was previously discussed in Design Note 128. This coefficient is a span coefficient, the effect
    Original PDF