Part Number
    Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    ST L6574 Search Results

    Documents mentioning ST L6574

    Document Partial File Text Tags Type PDF
    Evaluation boards STMicroelectronics application
    Evaluation boards STMicroelectronics application support September 2007 www.st.com/evalboards If you want to evaluate ST’s microcontrollers, power and analog product families for use in your new design, check out ST’s new selection of evaluation boards. These tested and qualified application boards are ready-to-go solutions for
    Original PDF
    Demonstration boards STMicroelectronics
    Demonstration boards STMicroelectronics application support September 2008 www.st.com/evalboards STMicroelectronics proposes a wide range of demonstration boards that may be used to perform a comprehensive evaluation of ST’s products and solutions while reducing your development time.
    Original PDF
    emif06-sd02f3
    www.st.com/express Semiconductor Product Design & Innovations 2. STM32 MCU Family 4. ST7 GEM Firmware 16. L6566 2 M3 ST Multi-Mode Controller 17. L598x DC-DC Converters 18. PM8800 PoE-PD Controller 5. EMIF06-SD02F3 IPAD Memory Card Transceiver 6. ACST2 Series
    Original PDF
    Evaluation boards & reference designs Application
    Evaluation boards & reference designs Application concepts to go! November 2006 www.st.com/evalboards If you want to evaluate ST's Microcontrollers, Power and Analog product families for use in your new design, check out ST’s new selection of evaluation boards. These tested and qualified application boards are ready-to-go solutions
    Original PDF
    steval-ild002v1
    STEVAL-ILD002V1 20 W dimmable CFL ballast solution based on the L6574 Data Brief Features ■ Lamp base: E27 ■ Wattage: 20 W (3U T3 lamp) ■ Input line: 180 VAC - 264 VAC ■ Lumen output: 1300 lm ■ Dimming range: 20% - 100% ■ Energy label: Class A
    Original PDF
    an2654
    AN2654 Application note CCFL backlight half-bridge topology based on L6574 and STD7NS20 Introduction Cold cathode fluorescent lamps (CCFL) are widely used in the backlighting of television and PC monitor applications due to their low cost and high efficiency. A 12 V or 24 V DC voltage
    Original PDF
    an993
    AN993 Application note Electronic ballast with PFC using L6574 and L6561 Introduction Dedicated ICs for lamp ballast applications are now replacing the old solutions based on bipolar transistors driven by a saturable pulse transformer. The L6574 is a high-performance ballast driver, designed using 600-V BCD offline
    Original PDF
    an2708
    AN2708 Application note 2X36 W digital dimmable ballast with L6574 and ST7FDALI Introduction This document describes a high-efficiency, high power factor, low THD and digital dimming electronic ballast designed to drive 2X36 W T8 tube lamps. The system consists of three main blocks:
    Original PDF
    an993
    AN993 APPLICATION NOTE ® ELECTRONIC BALLAST WITH PFC USING L6574 AND L6561 by I. Dal Santo, U. Moriconi The advent of dedicate IC for lamp ballast applications is replacing the old solutions based on bipolar transistor driven by a saturable pulse transformer.
    Original PDF
    an1756
    AN1756 Application note Choosing a DALI implementation strategy with ST7DALIF2 Introduction This application note describes how to choose a DALI (Digital Addressable Lighting Interface) implementation strategy using the ST7DALIF2 microcontroller. As well as
    Original PDF
    an1900
    AN1900 Application note Hardware implementation for ST7DALI-EVAL Introduction This application note describes how to implement a DALI (Digital Addressable Lighting Interface) in an existing high-frequency dimmable tube-lamp ballast application. Figure 1. Hardware overview with MCU handling only DALI communication
    Original PDF
    an2590
    AN2590 Application note 20 W dimmable CFL ballast solution Introduction This application note describes the 20 W dimmable CFL ballast solution which can completely replace incandescent lamps in formal dimming systems. The dimmer controlled range is 20% - 100% of full light output without changing the formal triac dimmer.
    Original PDF
    an2459
    AN2459 Application note Digital Power Factor Correction for Tube Lamp Ballasts and other digital power supplies controlled by an 8-bit microcontroller 1 Introduction The electronic ballast market has undergone dramatic changes over the last few years. It has moved from full analog, very differentiated applications made by a collection of drivers
    Original PDF
    l6574
    L6574  CFL/TL BALLAST DRIVER PREHEAT AND DIMMING HIGH VOLTAGE RAIL UP TO 600V dV/dt IMMUNITY ± 50 V/ns IN FULL TEMPERATURE RANGE DRIVER CURRENT CAPABILITY: 250mMA SOURCE 450mA SINK SWITCHING TIMES 80/40ns RISE/FALL WITH 1nF LOAD CMOS SHUT DOWN INPUT UNDER VOLTAGE LOCK OUT
    Original PDF
    l6574
    L6574 ® CFL/TL BALLAST DRIVER PREHEAT AND DIMMING HIGH VOLTAGE RAIL UP TO 600V dV/dt IMMUNITY ± 50 V/ns IN FULL TEMPERATURE RANGE DRIVER CURRENT CAPABILITY: 250mMA SOURCE 450mA SINK SWITCHING TIMES 80/40ns RISE/FALL WITH 1nF LOAD CMOS SHUT DOWN INPUT UNDER VOLTAGE LOCK OUT
    Original PDF
    l6574
    L6574  CFL/TL BALLAST DRIVER PREHEAT AND DIMMING HIGH VOLTAGE RAIL UP TO 600V dV/dt IMMUNITY ± 50 V/ns IN FULL TEMPERATURE RANGE DRIVER CURRENT CAPABILITY: 250mMA SOURCE 450mA SINK SWITCHING TIMES 80/40ns RISE/FALL WITH 1nF LOAD CMOS SHUT DOWN INPUT UNDER VOLTAGE LOCK OUT
    Original PDF
    l6574
    L6574  CFL/TL BALLAST DRIVER PREHEAT AND DIMMING HIGH VOLTAGE RAIL UP TO 600V dV/dt IMMUNITY ± 50 V/ns IN FULL TEMPERATURE RANGE DRIVER CURRENT CAPABILITY: 250mMA SOURCE 450mA SINK SWITCHING TIMES 80/40ns RISE/FALL WITH 1nF LOAD CMOS SHUT DOWN INPUT UNDER VOLTAGE LOCK OUT
    Original PDF
    an993
    AN993 APPLICATION NOTE  ELECTRONIC BALLAST WITH PFC USING L6574 AND L6561 by F. Sandrini, U. Moriconi and I. Dal Santo The advent of dedicate IC for lamp ballast applications is replacing the old solutions based on bipolar transistor driven by a saturable pulse transformer.
    Original PDF
    an993
    AN993 APPLICATION NOTE ® ELECTRONIC BALLAST WITH PFC USING L6574 AND L6561 by F. Sandrini, U. Moriconi and I. Dal Santo The advent of dedicate IC for lamp ballast applications is replacing the old solutions based on bipolar transistor driven by a saturable pulse transformer.
    Original PDF
    l6574
    L6574 CFL/TL BALLAST DRIVER PREHEAT AND DIMMING ■ HIGH VOLTAGE RAIL UP TO 600V dV/dt IMMUNITY ± 50 V/ns IN FULL TEMPERATURE RANGE DRIVER CURRENT CAPABILITY: 250mA SOURCE 450mA SINK SWITCHING TIMES 80/40ns RISE/FALL
    Original PDF
    l6574
    L6574 CFL/TL BALLAST DRIVER PREHEAT AND DIMMING ■ HIGH VOLTAGE RAIL UP TO 600V dV/dt IMMUNITY ± 50 V/ns IN FULL TEMPERATURE RANGE DRIVER CURRENT CAPABILITY: 250mA SOURCE 450mA SINK SWITCHING TIMES 80/40ns RISE/FALL
    Original PDF
    an993
    AN993 APPLICATION NOTE ELECTRONIC BALLAST WITH PFC USING L6574 AND L6561 by F. Sandrini & U. Moriconi The advent of dedicate IC for lamp ballast applications is replacing the old solutions based on bipolar transistor driven by a saturable pulse transformer.
    Original PDF
    l6574
    L6574 CFL/TL BALLAST DRIVER PREHEAT AND DIMMING ■ HIGH VOLTAGE RAIL UP TO 600V dV/dt IMMUNITY ± 50 V/ns IN FULL TEMPERATURE RANGE DRIVER CURRENT CAPABILITY: 250mA SOURCE 450mA SINK SWITCHING TIMES 80/40ns RISE/FALL
    Original PDF