Part Number
    Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    SPI CODE Search Results

    SPI CODE Result Highlights (5)

    Part ECAD Model Manufacturer Description Download Buy
    TC4511BP
    Toshiba Electronic Devices & Storage Corporation CMOS Logic IC, BCD-to-7-Segment Decoder, DIP16 Datasheet
    68305-001LF
    Amphenol Communications Solutions Din Accessory Coding PDF
    65197-001LF
    Amphenol Communications Solutions Din Accessory Coding Part PDF
    70275-001LF
    Amphenol Communications Solutions 70275-001LF-METRAL FEM CODING PART PDF
    91290-101LF
    Amphenol Communications Solutions Board-to-Board Coding System, Receptacle Key, LF PDF

    Documents mentioning SPI CODE

    Document Partial File Text Tags Type PDF
    avr151
    AVR151: Setup And Use of The SPI Features • SPI Pin Functionality Multi Slave Systems SPI Timing SPI Transmission Conflicts Emulating the SPI Code examples for Polled operation Code examples for Interrupt Controlled operation 8-bit RISC
    Original PDF
    avr151
    AVR151: Setup And Use of The SPI Features • SPI Pin Functionality Multi Slave Systems SPI Timing SPI Transmission Conflicts Emulating the SPI Code examples for Polled operation Code examples for Interrupt Controlled operation 8-bit RISC
    Original PDF
    Density Vcc Min (Mbits) (V) DataFlash Page Erase
    Density Vcc Min (Mbits) (V) DataFlash Page Erase Part Number Interface Architecture SPI SPI SPI SPI SPI SPI SPI, Rapid8® Speed (MHz) 66 66 66 66 66 66 66/50 Page-erase, Byte-alterable, 2.7 to 3.6V – Industrial Temperature Grade 2.7 2.7 2.7 2.7 2.7 2.7 2.7
    Original PDF
    SPI EXCHANGE SPI-3 TO SPI-4 Issue 1.0 FEATURES •
    SPI EXCHANGE SPI-3 TO SPI-4 Issue 1.0 FEATURES • Functionality - Low speed to high speed SPI exchange device - Logical port (LP) mapping (SPI-3 <-> SPI-4) tables per direction - Per LP configurable memory allocation - Maskable interrupts for fatal errors
    Original PDF
    SPI EXCHANGE 4 x SPI-3 TO SPI-4 Issue 1.0
    SPI EXCHANGE 4 x SPI-3 TO SPI-4 Issue 1.0 FEATURES • Functionality - Low speed to high speed SPI exchange device - Logical port (LP) mapping (SPI-3 <-> SPI-4) tables per direction - Per LP configurable memory allocation - Maskable interrupts for fatal errors
    Original PDF
    SPI EXCHANGE 2 x SPI-3 TO SPI-4 Issue 1.0
    SPI EXCHANGE 2 x SPI-3 TO SPI-4 Issue 1.0 FEATURES • Functionality - Low speed to high speed SPI exchange device - Logical port (LP) mapping (SPI-3 <-> SPI-4) tables per direction - Per LP configurable memory allocation - Maskable interrupts for fatal errors
    Original PDF
    an10428
    AN10428 UART-SPI Gateway for Philips SPI slave bridges Rev. 01 — 7 March 2006 Application note Document information Info Content Keywords UART-SPI Gateway, UART to SPI, RS-232 to SPI Abstract The UART-SPI Gateway enables a PC that has a UART port to communicate with a SPI slave device using an RS-232 terminal. With the
    Original PDF
    lm4855
    July 10, 2002 LM4855 Evaluation Package Instructions The LM4855 Evaluation Package includes the following: LM4855 Demoboard SPI Card SPI Cable SPI Software Hardware Installation Instructions: 1) Plug the SPI Card to the parallel port (LPT1) of the PC. 2) Connect the LM4855 Demoboard to the SPI Card with the SPI Cable.
    Original PDF
    lm4851
    July 10, 2002 LM4851 Evaluation Package Instructions The LM4851 Evaluation Package includes the following: LM4851 Demoboard SPI Card SPI Cable SPI Software Hardware Installation Instructions: 1) Plug the SPI Card to the parallel port (LPT1) of the PC. 2) Connect the LM4851 Demoboard to the SPI Card with the SPI Cable.
    Original PDF
    avr319
    AVR319: Using the USI module for SPI communication 8-bit Microcontrollers Features • C-code driver for SPI master and slave • Uses the USI module • Supports SPI Mode 0 and 1 Application Note Introduction The Serial Peripheral Interface (SPI) allows high-speed synchronous data transfer
    Original PDF
    x25020
    Memory Products—Serial SPI EEPROM Note: Products in Italics NOT Recommended for New Designs Pkg Code ( ) = # of leads Product Description X25020 2K SPI serial EEPROM (256 X 8) SPI modes (0,0 and 1,1),1MHz, Block Lock P, S(8) 4K SPI serial EEPROM X25040 (Alt part
    Original PDF
    avr1309: using the xmega spi
    AVR1309: Using the XMEGA SPI Features • Introduction to SPI and the XMEGA™ SPI module • Setup and use of the XMEGA SPI module • Implementation of module drivers Polled master Interrupt controlled master Polled slave Interrupt controlled slave • Code examples for interrupt controlled and polled drivers
    Original PDF
    um0565
    UM0565 User manual SPC563M SPI driver Introduction This user manual describes the AUTOSAR serial peripheral interface (SPI) driver. AUTOSAR SPI driver configuration parameters and deviations from the specification are described in SPI driver chapter. AUTOSAR SPI driver requirements and APIs are described
    Original PDF
    spi slave
    Active Errata List • During UART Reception, Clearing REN May Generate Unexpected IT SPI Interface - Transmission on Master Mode SPI Interface - SPI SS pin Limitation on Master/Slave SPI - SPI Slave Responding in a Multislave Configuration When Not Selected by the
    Original PDF
    an-300
    AN-300 SPI Bus Compatibility FM25160 16Kb SPI FRAM Overview The FM25160 uses an industry standard SPI interface. When comparing the FM25160 with 16Kb SPI EEPROMs, users may notice two minor operating differences. First, the SPI bus protocol includes 4 modes which may be selected by the
    Original PDF
    fm25160
    Application Note SPI Bus Compatibility FM25160 16Kb SPI FRAM Overview The FM25160 uses an industry standard SPI interface. When comparing the FM25160 with 16Kb SPI EEPROMs, users may notice two minor operating differences. First, the SPI bus protocol includes 4 modes which may be selected by the
    Original PDF
    m95512-dr
    M95512-DR M95512-R M95512-W 512 Kbit serial SPI bus EEPROM with high-speed clock Features ■ Compatible with SPI bus serial interface (Positive clock SPI modes): – M95512-W and M95512-R: standard SPI 512 Kbit EEPROM – M95512-DR: standard SPI 512 Kbit
    Original PDF
    fm25160
    Application Note SPI Bus Compatibility FM25160 16Kb SPI FRAM Overview The FM25160 uses an industry standard SPI interface. When comparing the FM25160 with 16Kb SPI EEPROMs, users may notice two minor operating differences. First, the SPI bus protocol includes 4 modes which may be selected by the
    Original PDF
    m95512
    M95512-DR M95512-R M95512-W 512 Kbit serial SPI bus EEPROM with high-speed clock Features ■ Compatible with SPI bus serial interface (Positive clock SPI modes): – M95512-W and M95512-R: standard SPI 512 Kbit EEPROM – M95512-DR: standard SPI 512 Kbit
    Original PDF
    m95256-dr
    M95256-DR M95256 M95256-W M95256-R 256 Kbit serial SPI bus EEPROM with high-speed clock Features ■ Compatible with SPI bus serial interface (positive clock SPI modes): – M95256, M95256-W and M95256-R: standard SPI 256 Kbit EEPROM – M95256-DR: standard SPI 256 Kbit
    Original PDF
    88k8483
    IDT88K8483 SPI-4 Exchange Document Issue 1.0 Description Features Functionality – Multiplexes logical ports (LPs) from SPI-4A and SPI-4B to SPI4M – Optionally converts between interleaved packet transfers and whole packet transfers per logical port – Data redirection per LP between SPI-4A, SPI-4B and 10G
    Original PDF