Part Number
    Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    ROUGHNESS Search Results

    Documents mentioning ROUGHNESS

    Document Partial File Text Tags Type PDF
    d-150-9133
    SPECIFICATION CONTROL DRAWING Tyco Electronics Corporation 300 Constitution Drive, Menlo Park, CA. 94025, U.S.A. TITLE: Raychem DOCUMENT NO.: Unless otherwise specified dimensions are in millimeters. [Inches dimensions are shown in brackets] D-150-9133 ROUGHNESS IN
    Original PDF
    E Cores General Information 4 Cores with
    E Cores General Information 4 Cores with toleranced air gap The following tolerances for dimension „g“ apply to all E cores: Dimension g mm g < 0,10 mm 0,10 mm ≤ g < 0,5 g ≥ 0,5 Tolerance mm ± 0,01 ± 0,02 ± 0,05 As is the case with ungapped cores, a certain degree of roughness cannot be avoided on the
    Original PDF
    Processing Notes Processing notes 1 Gapped and
    Processing Notes Processing notes 1 Gapped and ungapped ferrite cores Even with the best grinding methods known today, a certain degree of roughness on ground surfaces cannot be avoided, so that the usual term “without air gap” or “ungapped” does not imply no
    Original PDF
    CLEC Group R-2200 Specification 1. Scope: This
    CLEC Group R-2200 Specification 1. Scope: This specification applies to resistive paste for thick film circuit and chip resistor. 2. General: 2.1)Transportation method: By Post, Railway, Airways etc 2.2)Operating conditions: Substrate:96% alumina,surface roughness 3-5μm
    Original PDF
    powersemiconductor
    from Europe for the World Application Note European PowerSemiconductor and Electronics Company Heat Sink Specification for IGBT Modules Condition of Contact Area of Modules Footprint Roughness Planarity of Module RZ [µm] [µm] 130 x 140 10 - 15 < 30 140 x 190
    Original PDF