RF POWER DETECTOR Search Results

umax8

Abstract: Logarithmic Amplifier detector rf power Logarithmic Amplifiers MAX9930
Contextual Info: 19-XXXX; Rev 0; 7/07 2MHz to 1.6GHz 45dB RF-Detecting Controllers and RF Detector Features The MAX9930–MAX9933 low-cost, low-power logarithmic amplifiers are designed to control RF power amplifiers PA and transimpedance amplifiers (TIA), and to detect RF power levels. These devices are designed to

LT5538

Abstract: 2Ghz agc amplifier rf power detector TDD Logarithmic Amplifier detector rf power RF log detector
Contextual Info: News Release ⎜ www.linear.com 40MHz to 3.8GHz Log RF Power Detector Features 75dB Dynamic Range MILPITAS, CA – May 19, 2008 – A new monolithic broadband, high performance logarithmic RF power detector from Linear Technology provides accurate RF power measurement over a

NCS5002

Contextual Info: NCS5002 Product Preview RF Power Detector NCS5002 is a full CMOS detector designed for GSM/DCS/ GPRS/EDGE Power Amplifier Control, and RF measurement applications. This device converts the RF power applied into a DC level. The polynomial detector characteristics provide good accuracy at

Contextual Info: March 2005 LMV227 Production RF Tested, RF Power Detector for CDMA and WCDMA General Description Features The LMV227 is a 30 dB RF power detector intended for use in CDMA and WCDMA applications. The device has an RF frequency range from 450 MHz to 2 GHz. It provides an

LMV228UR

Abstract: MO-211 LMV228
Contextual Info: LMV225,LMV226,LMV228 LMV225/LMV226/LMV228 RF Power Detector for CDMA and WCDMA Literature Number: SNWS013K LMV225/LMV226/LMV228 RF Power Detector for CDMA and WCDMA General Description Features The LMV225/LMV226/LMV228 are 30 dB RF power detectors intended for use in CDMA and WCDMA applications.

MAX2601

Abstract: MAX2235 MAX2240 MAX2264 MAX2430 MAX2602 MAX2840-MAX2841 UltraChip
Contextual Info: Maxim > App Notes > WIRELESS, RF, AND CABLE Keywords: rf, rfic, pa, power amplifier, cdma, ISM band, rf ics, rfics, pa ics Nov 01, 2000 APPLICATION NOTE 335 Maxim Wireless/RF Power Amplifier Selector Guide Abstract: An overview of Maxim's RF power amplifier PA products targeted towards cellular, PCS, 802.11a/b/

Contextual Info: RF52633.3V to 5.0 V, 2.5GHz Linear Power Amplifier RF5263 Preliminary 3.3V TO 5.0V, 2.5GHz LINEAR POWER AMPLIFIER Features „ GND VCC2 VCC2 13 BIAS VCC 1 Single 3.3V or 5.0V Power Supply 12 RF OUT 1st Stage RF IN 2 <2% EVM RMS 54Mbps @ +26dBm 10 RF OUT Detector

TLA08AAA

Abstract: LMV232 LMV232TL LMV232TLX MO-211 RF 98 marking smd Detector "Peak-to-Average Ratio
Contextual Info: LMV232 Dual-Channel Integrated Mean Square Power Detector for CDMA & WCDMA General Description Features The LMV232 dual RF detector is designed for RF transmit power measurement in mobile phones. This dual mean square IC is especially suited for accurate power measurement of RF signals exhibiting high peak-to-average ratios

RF Based Wireless Electronic Notice Board using 8051

Abstract: 433MHZ RF Transmitter INTERFACING 8051 io-homecontrol sample program for CC2431 pir sensor c171 interfacing 8051 with wi-fi modem PIR sensor 8051 projects 433MHZ RF RECEIVER INTERFACING 8051 Interfacing msp430 to cc1111 example TX-433 RF
Contextual Info: Low-Power RF Guide www.ti.com/lprfÊ 2QÊ 2009 2 Low-Power RF Selection Guide ➔ Table of contents RF made easy Texas Instruments TI offers a wide selection of cost-effective, low-power RF solutions for proprietary and standard-based wireless applications

Contextual Info: 19-4946; Rev 0; 10/09 TION KIT EVALUA BLE IL AVA A RF Power Detector Features The MAX2209 is a wideband 800MHz to 2GHz RF power detector. It takes an RF signal from the directional coupler at the input, and outputs a DC voltage proportional to the RF peak voltage. The change in output

WLP 1500

Abstract: max2209 toc12
Contextual Info: 19-4946; Rev 0; 10/09 TION KIT EVALUA BLE IL AVA A RF Power Detector Features The MAX2209 is a wideband 800MHz to 2GHz RF power detector. It takes an RF signal from the directional coupler at the input, and outputs a DC voltage proportional to the RF peak voltage. The change in output

WLP 1500

Contextual Info: 19-5493; Rev 0; 9/10 TION KIT EVALUA BLE IL AVA A RF Power Detector with Shutdown Control The MAX2209A is a wideband 800MHz to 2GHz RF power detector. It takes an RF signal from the directional coupler at the input, and outputs a DC voltage proportional to the RF peak voltage. The change in output

tokin

Abstract: Allen Bradley smd diodes sockets 605 Marcon electrolytic 9433 W 752 ALLEN BRADLEY DIPS Allen Bradley POTENTIOMETERS marcon capacitor tocos potentiometer BH Electronics
Contextual Info: October 15, 2002 DC420A-B DEMO BOARD QUICK START GUIDE DESCRIPTION The DC420A-B contains the LTC4401-1 RF power controller chip and can be used to test the RF detector and controller characteristics. The LTC4400-1 is a power controller for slow turn-on RF power amplifiers. This demo board has been designed to

MAX2235

Abstract: MAX2240 MAX2264 MAX2430 MAX2601 MAX2602 TSSOP-EP max2282 UltraChip max2281
Contextual Info: WIRELESS, RF, AND CABLE Nov 01, 2000 Maxim Wireless/RF Power Amplifier Selector Guide An overview of Maxim's RF power amplifier PA products targeted towards cellular, PCS, 802.11b, cordless phone and Bluetooth applications. Table compares operating voltage, supply current, output power, package, power

ATP10K100M

Abstract: 100w1000 Amplifier Research LA250
Contextual Info: 1st Half of 2014 The Complete Catalog For RF & EMC Testing RF Solid State Power Amplifiers Microwave Solid State and TWT Power Amplifiers MultiStar Multi-Tone Tester MultiStar Field Analyzers MultiStar Precision DSP Receiver RF and Microwave Antennas rf/microwave instrumentation

Contextual Info: RF5125 3V TO 5V, 2.4GHz TO 2.5GHz LINEAR POWER AMPLIFIER „ Single Power Supply 3.0V to 5.0V NC VCC1 NC 12 RF IN 2 Input Match 28dB Typical Small Signal Gain RF IN 3 10 RF OUT „ „ „ „ Power Detector Bias Circuit NC 4 9 NC 5 +23dBm, <4%EVM, 250mA at VCC =5.0V

ALLEN BRADLEY DIPS

Abstract: marcon capacitor 8020 SMA Allen Bradley POTENTIOMETERS LTC4400-1 RF2138 RF2140
Contextual Info: October 15, 2002 DC420A-A DEMO BOARD QUICK START GUIDE DESCRIPTION The DC420A-A contains the LTC4400-1 RF power controller chip and can be used to test the RF detector and controller characteristics. The LTC4400-1 is a power controller for fast turn-on RF power amplifiers. This demo board has been designed to demonstrate

rf power detector dynamic range CDMA

Abstract: a89 diode smd design of multi section directional coupler LMV228 LMV225 LMV225TL LMV225TLX LMV226
Contextual Info: LMV225/LMV226/LMV228 RF Power Detector for CDMA and WCDMA General Description Features The LMV225/LMV226/LMV228 are 30 dB RF power detectors intended for use in CDMA and WCDMA applications. The device has an RF frequency range from 450 MHz to 2 GHz. It provides an accurate temperature and supply compensated output voltage that relates linearly to the RF input

a89 diode smd

Abstract: design of multi section directional coupler Logarithmic Amplifier detector LMV225 LMV225TL LMV225TLX LMV226 LMV228
Contextual Info: LMV225/LMV226/LMV228 RF Power Detector for CDMA and WCDMA General Description Features The LMV225/LMV226/LMV228 are 30 dB RF power detectors intended for use in CDMA and WCDMA applications. The device has an RF frequency range from 450 MHz to 2 GHz. It provides an accurate temperature and supply compensated output voltage that relates linearly to the RF input

DSB070521

Abstract: RF5263 RF5263WBPCK-410 RF5263WLPCK-410 RF5263WMPCK-410 HBT transistor rf transistor 2.5GHz 2.4GHz Power Amplifier transistor
Contextual Info: RF52633.3V to 5.0 V, 2.5GHz Linear Power Amplifier RF5263 Preliminary 3.3V TO 5.0V, 2.5GHz LINEAR POWER AMPLIFIER Features GND VCC2 VCC2 BIAS VCC 1 Single 3.3V or 5.0V Power Supply 12 RF OUT st RF IN 2 <2% EVM RMS 54Mbps @ +26dBm 11 RF OUT P DOWN 3 10 RF OUT

TLA04AAA

Contextual Info: LMV225/LMV226/LMV228 RF Power Detector for CDMA and WCDMA General Description Features The LMV225/LMV226/LMV228 are 30 dB RF power detectors intended for use in CDMA and WCDMA applications. The device has an RF frequency range from 450 MHz to 2 GHz. It provides an accurate temperature and supply compensated output voltage that relates linearly to the RF input

resistor smd 104

Contextual Info: LMV225/LMV226/LMV228 RF Power Detector for CDMA and WCDMA General Description Features The LMV225/LMV226/LMV228 are 30 dB RF power detectors intended for use in CDMA and WCDMA applications. The device has an RF frequency range from 450 MHz to 2 GHz. It provides an accurate temperature and supply compensated output voltage that relates linearly to the RF input

LTC5505

Contextual Info: DC391 DEMO BOARD QUICK START GUIDE INTRODUCTION The DC391 demo board is used to evaluate the LTC5505 RF power detector with integrated output buffer and voltage reference. The LTC5505 converts an RF input signal at pin 1 RF to a DC voltage at pin 4(Vout). The RF input frequency range is 300MHz to 2700MHz. Maximum input power is 18dBm.

Contextual Info: LMV227 www.ti.com SNWS016D – NOVEMBER 2004 – REVISED MARCH 2013 LMV227 Production RF Tested, RF Power Detector for CDMA and WCDMA Check for Samples: LMV227 FEATURES DESCRIPTION • • • • The LMV227 is a 30 dB RF power detector intended for use in CDMA and WCDMA applications. The