RATIOMETRIC Search Results

TL507

Contextual Info: TL507I, TL507C ANALOG-TO DIGITAL CONVERTER D2503, OCTOBER 1 9 7 9 -R E V IS E D OCTOBER 1988 P PA CKAG E • Low Cost • 7-Bit Resolution • Monotonicity Over Entire A/D Conversion Range • Ratiometric Conversion • Conversion Speed . . . Approximately 1 ms

tray data for lga16

Contextual Info: LIS244AL MEMS motion sensor: 2-axis - ±2g ultracompact linear accelerometer Features • Single voltage supply operation ■ ± 2g full-scale ■ Output voltage, offset and sensitivity are ratiometric to the supply voltage ■ Factory trimmed device sensitivity and offset

Z117

Abstract: X117 LIS331AL LIS331ALTR
Contextual Info: LIS331AL MEMS inertial sensor: 3-axis - ±2g analog output “nano” accelerometer Features • Single voltage supply operation ■ ±2.0g full-scale ■ Output voltage, offset and sensitivity are ratiometric to the supply voltage ■ Factory trimmed device sensitivity and offset

CMA3000-A01

Contextual Info: CMA3000-A01 Data Sheet CMA3000-A01 3-AXIS LOW POWER ANALOG OUTPUT ACCELEROMETER Features • • • • • • • • 1.7 V – 3.6 V supply voltage Ratiometric analog voltage output for x, y and z acceleration User selectable ±2 g and ±8 g measurement

A1302KUA-T

Abstract: A1301 A1302EUA 1302 allegro hall effect linear hall effect sensors A1302 A1301EUA-T A1301KLHLT-T A1301KUA-T A1302ELHLT-T
Contextual Info: A1301 and A1302 Continuous-Time Ratiometric Linear Hall Effect Sensors Features and Benefits Description ▪ ▪ ▪ ▪ ▪ ▪ The A1301 and A1302 are continuous-time, ratiometric, linear Hall-effect sensors. They are optimized to accurately provide a voltage output that is proportional to an applied magnetic

spi CONTROLLED KEYPAD SCAN IC

Abstract: 1217c3 QFN-32 TSC2200 TSC2200IPW TSC2200IPWR TSC2200IRHB TSSOP-28 IC 72706 K1 transistor
Contextual Info: TSC2200 TSC220 TSC220 SBAS191F – FEBRUARY 2001 – REVISED APRIL 2004 PDA ANALOG INTERFACE CIRCUIT FEATURES APPLICATIONS ● 4-WIRE TOUCH SCREEN INTERFACE AND 4-BY-4 KEYPAD INTERFACE ● RATIOMETRIC CONVERSION ● SINGLE 2.7V TO 3.6V SUPPLY ● SERIAL INTERFACE

LIS3L02AQ

Abstract: qfn44 LIS3L02 BS 2G 210
Contextual Info: LIS3L02AQ INERTIAL SENSOR: 3Axis - 2g/6g LINEAR ACCELEROMETER 1 • ■ ■ ■ ■ ■ ■ 2 Figure 1. Package FEATURES 2.4V TO 3.6V SINGLE SUPPLY OPERATION 0.5mg RESOLUTION OVER 100Hz BW 2g/6g USER SELECTABLE FULL-SCALE OUTPUT VOLTAGE, OFFSET AND SENSITIVITY RATIOMETRIC TO THE

A3506

Abstract: A3506LUA Application Note 27701
Contextual Info: RATIOMETRIC, LINEAR HALL-EFFECT SENSORS FOR HIGH-TEMPERATURE OPERATION X Vcc ; 1 2 1 1 3 i i 1 >. Q Z zj 9 1Î □» ^ CO ' K ? u:5 O Dwg. PH-006 The A3506-, A3507-, and A3508- comprise a family of sensitive, temperature-stable linear Hall-effect sensors. Ratiometric, linear

UGN3503LT

Abstract: Ay hall sensor
Contextual Info: RATIOMETRIC, LINEAR HALL— EFFECT SENSORS The UGN3503LT, UGN3503U, and UGN3503UA Hall-effect sensors accurately track extremely small changes in magnetic flux density— changes generally too small to operate Hall-effect switches. As motion detectors, gear tooth sensors, and proximity detectors,

UGN3503UA

Abstract: A12505
Contextual Info: RATIOMETRIC, UNEAR HALL—EFFECT SENSORS The UGN3503U and UGN3503UA Hall-effect sensors accurately track extremely small changes in magnetic flux density—changes generally too small to operate Hall-effect switches. As motion detectors, gear tooth sensors, and proximity detectors,

Transistor BC 1078

Abstract: TSS400-S1 LCD tlc 771 TSS400CFN-S1 abe 630 K-Line L line BC 557 PNP TRANSISTOR circuits D4071 digital pressure sensor conditional circuit 44-PIN
Contextual Info: TSS400-S1 uPOWER PROGRAMMABLE HIGH-PRECISION SENSOR SIGNAL PROCESSOR SLMS001 -D 407 1, JANUARY 1993 * Onboard Ratiometric Current Source Programmable From 0.15 mA x SV^d/V to 2.4 mA x (SVDD/V) Two Independent Crystal Controlled Timers (32.768 kHz) Internal MOS Oscillator Serves as System

Contextual Info: TLC0834C, TLC0834I, TLC0838C, TLC0838I 8-BIT ANALOG-TO-DIGITAL CONVERTERS WITH SERIAL CONTROL SLAS094E – MARCH 1995 – REVISED OCTOBER 2000 D D D D D D D 8-Bit Resolution Easy Microprocessor Interface or Stand-Alone Operation Operates Ratiometrically or With 5-V

NSCSANN100PGUNV

Abstract: 1200 RTV spirometer 100MD
Contextual Info: TruStability Board Mount Pressure Sensors: NSC Series– Uncompensated/Unamplified DESCRIPTION The TruStability NSC Series-Uncompensated/Unamplified is a piezoresistive silicon pressure sensor offering a ratiometric analog output for reading pressure over the specified full scale

TL4910

Abstract: A3503 TL491 15A88
Contextual Info:


  
  
 

 
*Patent Pending  

 
• ■ ■ ■ ■ ■ ■ Programmable Linear Hall IC Quad Switched / Chopper Stabilized Ratiometric Output for A/D Interface Adjustable Quiescent Voltage VOQ

A1302

Abstract: A1302EUA-T "Hall Effect Sensors" A1301EUA-T A1302KUA-T A1301ELHLT-T A1301EUA A1302EUA A1301 a1302k
Contextual Info: A1301 and A1302 Continuous-Time Ratiometric Linear Hall Effect Sensors Features and Benefits Description ▪ ▪ ▪ ▪ ▪ ▪ The A1301 and A1302 are continuous-time, ratiometric, linear Hall-effect sensors. They are optimized to accurately provide a voltage output that is proportional to an applied magnetic

ADXRS610

Abstract: gyro sensor calibration SIGMA as 226 ADXRS610BBGZ yaw rate "Vibration Sensor" Temperature Compensation Techniques Gyroscope ADXRS610BBG
Contextual Info: ±300°/sec Yaw Rate Gyro ADXRS610 FEATURES GENERAL DESCRIPTION Complete rate gyroscope on a single chip Z-axis yaw rate response High vibration rejection over wide frequency 2000 g powered shock survivability Ratiometric to referenced supply 5 V single-supply operation

Contextual Info: Data Sheet 27501.10A* 3515 AND •KC31 RATIOM ETRIC, LINEAR H A L L -E FFE C T SENSORS FOR HIGH-TEM PERATURE OPERATION The A3515- and A3516- are sensitive, temperature-stable linear Hall-effect sensors with greatly improved offset characteristics. Ratiometric, linear Hall-effect sensors provide a voltage output that is

MAX5494ETE

Abstract: MAX5494 MAX5495 MAX5495ETE MAX5496 MAX5498 MAX5499
Contextual Info: 19-3562; Rev 2; 1/06 10-Bit, Dual, Nonvolatile, Linear-Taper Digital Potentiometers ♦ 35ppm/°C End-to-End Resistance Temperature Coefficient ♦ 5ppm/°C Ratiometric Temperature Coefficient ♦ 10kΩ and 50kΩ End-to-End Resistor Values ♦ 3-Wire SPI-Compatible Serial Interface

SCA610-C28H1A

Abstract: SCA610C28H1A SCA610 SCA620 3 V Accelerometer
Contextual Info: SCA610-C28H1A Data Sheet SCA610-C28H1A 1-AXIS ANALOG ACCELEROMETER Features • • • • • • • • • • • Single +5 V supply; ratiometric voltage output in the range 4.75…5.25 V ±1.7g Range 8-pin plastic surface mount package with gull wing legs, mountable with pick and place

POLYFUSE BLOCK DIAGRAM

Abstract: LIS3L02AS SO24 inertial sensor polyfuse
Contextual Info: LIS3L02AS INERTIAL SENSOR: 3Axis - 2g/6g LINEAR ACCELEROMETER PRODUCT PREVIEW • 3V TO 5.25V SINGLE SUPPLY OPERATION THE SENSITIVITY IS ADJUSTED WITH A TOTAL ACCURACY OF ±10% THE OUTPUT VOLTAGE, OFFSET, SENSITIVITY AND TEST VOLTAGE ARE RATIOMETRIC TO THE SUPPLY VOLTAGE

TLC0834C

Abstract: TLC0834I TLC0838 TLC0838C TLC0838I ADC0834 ADC0838 TLC0834
Contextual Info: TLC0834C, TLC0834I, TLC0838C, TLC0838I 8-BIT ANALOG-TO-DIGITAL CONVERTERS WITH SERIAL CONTROL SLAS094C – MARCH 1995 – REVISED APRIL 1997 D D D D D D D D D D 8-Bit Resolution Easy Microprocessor Interface or Stand-Alone Operation Operates Ratiometrically or With 5-V

ADC0831

Abstract: ADC0832 TLV0831 TLV0831C TLV0831I TLV0832 TLV0832C TLV0832I TLV0834 TLV0838
Contextual Info: TLV0831C, TLV0831I TLV0832C, TLV0832I 3-VOLT 8-BIT ANALOG-TO-DIGITAL CONVERTERS WITH SERIAL CONTROL SLAS148 – SEPTEMBER 1996 D D D D D D D D D D 8-Bit Resolution 2.7 V to 3.6 V VCC Easy Microprocessor Interface or Standalone Operation Operates Ratiometrically or With VCC

LIS3L02AQ

Contextual Info: LIS3L02AQ INERTIAL SENSOR: 3Axis - 2g/6g LINEAR ACCELEROMETER 1 • ■ ■ ■ ■ ■ ■ 2 Figure 1. Package FEATURES 2.4V TO 3.6V SINGLE SUPPLY OPERATION 0.5mg RESOLUTION OVER 100Hz BW 2g/6g USER SELECTABLE FULL-SCALE OUTPUT VOLTAGE, OFFSET AND SENSITIVITY RATIOMETRIC TO THE

Contextual Info: Amplified Middle Pressure Sensors 0.3 psi to 15 psi Pressure Sensors Military Temperature Grade Features • • • • 0 to 0.3 psi to 0 to 15 psi Pressure Ranges Ratiometric 4V Output Temperature Compensated -40C to 125C Calibrated Zero and Span Applications