Part Number
    Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    NATIONAL LINEAR APPLICATION NOTES BO Search Results

    NATIONAL LINEAR APPLICATION NOTES BO Result Highlights (5)

    Part ECAD Model Manufacturer Description Download Buy
    TA75W393FU
    Toshiba Electronic Devices & Storage Corporation Comparator, Bipolar (393) type Dual Comparator, 2V to 36V, SOT-25 Datasheet
    TC75S67TU
    Toshiba Electronic Devices & Storage Corporation Operational Amplifier, 2.2V to 5.5V, Low Noise type:VNI=6nV/√Hz@1kHz, SOT-353F Datasheet
    TA75W01FU
    Toshiba Electronic Devices & Storage Corporation Operational Amplifier, Bipolar (358) type Dual Op-Amp, 3V to 12V, SOT-505 Datasheet
    TC75S59F
    Toshiba Electronic Devices & Storage Corporation Comparator, 1.8V to 7.0V, IDD=100μA, Open-drain output, SOT-25/SOT-353 Datasheet
    TA75S393F
    Toshiba Electronic Devices & Storage Corporation Comparator, Bipolar (393) type, 2V to 36V, SOT-25 Datasheet

    Documents mentioning NATIONAL LINEAR APPLICATION NOTES BO

    Document Partial File Text Tags Type PDF
    National PREFACE The purpose of this handbook is
    National PREFACE The purpose of this handbook is to provide a fully indexed and cross-referenced collection of linear in­ tegrated circuit applications using both monolithic and hybrid circuits from National Semiconductor. Individual application notes are normally written to ex­
    OCR Scan PDF
    National Semiconductor Application Note 1886
    National Semiconductor Application Note 1886 October 6, 2008 Introduction For the Evaluation Board the typical post regulation application is realized: the output voltage of the DC-DC converter is used as supply for the linear regulator (VOUT_DCDC = VIN_LILO). Thereby a higher efficiency and lower power dissipation of the system can be achieved compared to using the
    Original PDF
    rd-170
    National Semiconductor Application Note 1950 Frederik Dostal July 28, 2009 Introduction 1. The reference design RD-170 includes linear regulators as local low noise power supplies and a good solution for a switch mode power supply powering the board RD-170 or
    Original PDF
    lm3429
    April 30, 2009 LM3429 N-Channel Controller for Constant Current LED Drivers General Description Features The LM3429 is a versatile high voltage LED driver controller. With the capability to be configured in a Buck, Boost, BuckBoost (Flyback), or SEPIC topology, and an input and output
    Original PDF
    April 29, 2009 LM3429 N-Channel Controller for
    April 29, 2009 LM3429 N-Channel Controller for Constant Current LED Drivers General Description Features The LM3429 is a versatile high voltage LED driver controller. With the capability to be configured in a Buck, Boost, BuckBoost (Flyback), or SEPIC topology, and an input and output
    Original PDF
    lp3906
    National Semiconductor RD-161 Novtech Engineering December 2007 1.0 Design Description 2.0 Features The LP3906 Smart Power Board provides a complete, multirail solution for FPGAs, Microprocessors, or any other systems requiring multiple voltages, special power sequencing,
    Original PDF
    lp5900
    National Semiconductor Application Note 1494 John Bowie August 2007 Introduction Operation This evaluation board is designed to enable the evaluation of the LP5900 Voltage Regulator. Each board is assembled and tested in the factory. This evaluation board has the 6 pin LLP
    Original PDF
    lp5900
    National Semiconductor Application Note 1396 John Bowie September 2007 Introduction Operation This evaluation board is designed to enable the evaluation of the LP5900 Voltage Regulator. Each board is assembled and tested in the factory. This evaluation board has the microSMD-4 bump package mounted.
    Original PDF
    National Semiconductor Application Note 1208 July
    National Semiconductor Application Note 1208 July 2001 NOTES 1. When a DIP switch slide is ON, the signal whose label appears beside that slide is grounded; 2. Much flexibility is built into the board. For example, it is possible to use a dual SO-8 FET in Ch2, it is possible to
    Original PDF
    lp3910
    November 2006 LP3910 Power Management IC for Hard Drive Based Portable Media Players General Description Features The LP3910 is a programmable system power management unit that is optimized for HDD-based Portable Media Players. The LP3910 incorporates 2 low-dropout LDO voltage regulators, 2 integrated Buck DC/DC converters with Dynamic Voltage Scaling (DVS), 1 wide load range Buck-Boost DC/DC
    Original PDF
    National Semiconductor Application Note 2161 Kern
    National Semiconductor Application Note 2161 Kern Wong June 27, 2011 Introduction Operation This evaluation board is designed to enable the evaluation of the LP5904 Voltage Regulator. Each board is assembled and tested in the factory. This evaluation board has the 4-bump
    Original PDF
    National Semiconductor Application Note 1208 July
    National Semiconductor Application Note 1208 July 2001 Notes 4. The board shuts down after a VID bit is toggled on the DIP switch; Do not change the Ch1 voltage setting on the fly using the DIP switch. Instead, set the corresponding DIP VID bits to float, and then use a signal generator to toggle the
    Original PDF
    lp3905
    National Semiconductor Application Note 1501 Graham Roxburgh March 2007 General Information The evaluation board is a complete circuit allowing full operation of the LP3905 within the recommended application circuit. Each board is pre-assembled and tested in the factory.
    Original PDF
    ds100br
    October 20, 2010 Low Power Quad Channel Repeater with 10.3125 Gbps Equalizer and De-Emphasis Driver General Description Features The DS100BR410 is an extremely low power, high performance quad-channel repeater for high-speed serial links with data rates up to 10.3125 Gbps. The device performs both receive equalization and transmit de-emphasis on each of its 4
    Original PDF
    lp2998
    National Semiconductor Application Note 1813 Dennis Hudgins March 10, 2008 The LP2998 evaluation board is designed to provide the design engineer with a fully functional prototype system in which to evaluate the LP2998 in both a static environment and with
    Original PDF
    Product Information Bulletin HF2Linear Hi-Flux
    Product Information Bulletin HF2Linear Hi-Flux 2nd Generation Module • Hi-Flux LED module with integral thermal management and optics • Each board contains screw holes for proper mounting • Size of entire module (L x W x H) 12.1 in. x 1.4 in. x 1.0 in.
    Original PDF
    lp38511tj-adj
    National Semiconductor Application Note 1801 Don Jones January 23, 2009 TABLE 1. Introduction This board is designed to allow the evaluation of the LP38511TJ-ADJ Voltage Regulator. Each board is assembled and tested in the factory. This evaluation board has the
    Original PDF
    lm5046
    National Semiconductor Application Note 2126 Ajay Hari March 4, 2011 Introduction Theory of Operation The LM5046 reference board is designed based on the phase-shifted full-bridge topology. This board is for reference only and is intended to demonstrate the capability of the
    Original PDF
    lp38513tj-adj
    National Semiconductor Application Note 1670 Don Jones January 23, 2009 TABLE 1. Introduction This board is designed to allow the evaluation of the LP38513TJ-ADJ Voltage Regulator. Each board is assembled and tested in the factory. This evaluation board has the
    Original PDF
    1802
    National Semiconductor Application Note 1802 Don Jones January 23, 2009 TABLE 1. Introduction This board is designed to allow the evaluation of the LP38512TJ-ADJ Voltage Regulator. Each board is assembled and tested in the factory. This evaluation board has the
    Original PDF
    lm3530
    LM3530 PRODUCT BRIEF September 3, 2009 High Efficiency White LED Driver with Programmable Ambient Light Sensing Capability and I2C Compatible Interface General Description Features The LM3530 current mode boost converter supplies the power and controls the current in up to 11 series white LED’s. The
    Original PDF
    lm3530
    LM3530 PRODUCT BRIEF High Efficiency White LED Driver with Programmable Ambient Light Sensing Capability and I2C Compatible Interface General Description Features The LM3530 current mode boost converter supplies the power and controls the current in up to 11 series white LED’s. The
    Original PDF
    lp3905
    National Semiconductor Application Note 1527 Graham Roxburgh November 5, 2007 General Information The evaluation board is a complete circuit allowing full operation of the LP3905 within the recommended application circuit. Each board is pre-assembled and tested in the factory.
    Original PDF
    2000 Burr-Brown Product Selection Guide Linear & Mixed Signal Products ® ©2000 LI-545 Burr-Brown Corporation Printed in USA Burr-Brown Corporation Mailing Address: PO Box 11400 Tucson, AZ 85734 Street Address: 6730 S. Tucson Blvd. Tucson, AZ 85706 Tel: (520) 746-1111 • Twx: 910-952-1111 • Internet: http://www.burr-brown.com/
    Original PDF