Part Number
    Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    IMPLEMENTAT Search Results

    Documents mentioning IMPLEMENTAT

    Document Partial File Text Tags Type PDF
    mc14066
    MC14066B Quad Analog Switch/Quad Multiplexer The MC14066B consists of four independent switches capable of controlling either digital or analog signals. This quad bilateral switch is useful in signal gating, chopper, modulator, demodulator and CMOS logic implementation.
    Original PDF
    an3895
    Freescale Semiconductor Application Note AN3895 Rev 1, 03/2010 MPR121 Serial Communication INTRODUCTION The MPR121 uses an I2C Serial Interface. The I2C protocol implementation and the specifics of communicating with the Touch Sensor Controller are detailed in this application note.
    Original PDF
    sirf
    This document becomes an UNCONTROLLED COPY once printed from SiRF’s Intranet. To receive a controlled copy, please contact Document Control. SiRF Application Note GSP2e Hardware Implementation Document Number APNT0012 Revision 1.1 5/16/2000 Author: Oded Yossifor
    Original PDF
    an10775
    AN10775 NicheLite for LPC implementation notes Rev. 01 — 19 December 2008 Application note Document information Info Content Keywords Network, Ethernet, TCP/IP Stack, LPC2400, LPC3250 Abstract This application note discusses implementation details when using the
    Original PDF
    an9327
    TM No. AN9327 Intersil Telecom October 1993 HC-5509A1 RING TRIP COMPONENT SELECTION Author: Ken Feldhaus Introduction Any linecard ringing implementation requires the removal of the ring signal from the subscriber line within a specified time after the subscriber goes off-hook. This prevents the ring signal from causing discomfort to the subscriber. It is also important that the system not falsely ring trip (detect off-hook while
    Original PDF
    604e
    ™ PowerPC 604e RISC Microprocessor Preliminary Copy PowerPC 604e™ RISC Microprocessor Family: PID9q-604e Datasheet The PowerPC 604e microprocessor is an implementation of the PowerPC® family of reduced instruction set computing (RISC) microprocessors. In this document, the term ‘604’ is used as an
    Original PDF
    m37273mf
    M37273 M37273MF: MULTIPLE LINE OSD Abstract The following article will discuss the On-Screen Display (OSD) operation of the Mitsubishi M37273MF MCU. A discussion on the firmware structure and implementation will be detailed. • Author: Shigeru Maeta
    Original PDF
    MAT RA M H S 4tE D a S fibôM S b OGOGHMS S E 3
    MAT RA M H S 4tE D a S fibôM S b OGOGHMS S E 3 MMHS ADVANCE INFORMATION AUGUST 1988 Di 29C93 TERMINAL RATE ADAPTOR CIRCUIT (TRAC) • SPEED ADAPTION OF V24 TERMINALTO ISDN “B” CHANNEL • FULL ECMA102 IMPLEMENTATION SYNC. AND ASYNC.TERMINAL • DATA RATE 50 TO 19200 BPS IN ASYNC. MODE
    OCR Scan PDF
    CT*Siliconix in c o r p o r a te d ANALOG
    CT*Siliconix in c o r p o r a te d ANALOG SWITCHES AND MULTIPLEXERS Introduction Siliconix is the world's leading supplier of high performance, precision solid-state analog switches and multiplexers. Through the Implementation of state-of-the-art technologies (Metal-Gate CMOS, High-Voltage Sllicon-Gate CMOS, and
    OCR Scan PDF
    SIEMENS 4 DRM256 Operation of the Memory Module
    SIEMENS 4 DRM256 Operation of the Memory Module Operation of the memory module is controlled via the command bus, the latency setting, the bank address, column address and row address. Data is read and written via the data bus. 4.1 Data Bus The width of the data bus depends on the actual implementation. It may be configured in a range from
    OCR Scan PDF
    INFRARED INTERFACE The FD C37C665IR's and
    INFRARED INTERFACE The FD C37C665IR's and FDC37C666IR's infrared interface provides a two-way wireless communications port using infrared as a transm ission medium. Tw o infrared implementations have been provided in the FD C37C665IR and FDC37C666IR, IrDA and
    OCR Scan PDF
    an180
    Using the X80070 in an Advanced TCA Application ® Application Note December 1, 2004 AN180.0.0 Author: Carlos Martinez Introduction This application note describes one possible implementation of an Advanced TCA (PICMG 3.x) power supply control. This particular implementation shows the power on control of one
    Original PDF
    a6279
    Application Information A6279 Timing Requirement This application note describes implementation methods for the A6279 in certain customer application configurations. The staggered delay circuit implemented in the A6279 results in some special timing restrictions, applicable if a
    Original PDF
    80c85b
    CA80C85B f jl tu n d r a • Enhanced, high performance CA80C85B microprocessor features pin and functional compatibility with industry standard 8085 and 8085A • Very low power consumption achieved with proven CMOS implementation • TTL compatible input/output voltages
    OCR Scan PDF
    TUNDRA CA82C55A PROGRAMMABLE PERIPHERAL INTERFACE
    TUNDRA CA82C55A PROGRAMMABLE PERIPHERAL INTERFACE • Pin and functional compatibility with the industry standard 8255A • Supports 8086/8088 and 80186/188 m icroprocessors • Very high speed - 1 0 , 8 and 5 MHz zero wait state operation • Low power CMOS Implementation
    OCR Scan PDF
    arrays
    November, 2005 Manufacturers Representatives Corporate Product Line Managers Americas Sales Team Asia Sales Team Europe Sales Team Bourns® Chip Resistors, Chip Arrays, and Resistor Networks Available in Lead Free Only by Fourth Quarter 2006 The date of compliance for Reduction of Hazardous Substances (RoHS) implementation is July 1, 2006.
    Original PDF
    fast 9-09-2002 12:39 Pagina 1 The Cost Effective
    fast 9-09-2002 12:39 Pagina 1 The Cost Effective Solutions to Fast Ethernet Implementation Low power consumption with PHYreIce™ technology IEEE 802.3 10BASE-T and 100BASE-TX compliant STMicroelectronics provides a complete solution for 10/100 Fast Ethernet. STE10/100A is a
    Original PDF
    PRELIMINARY Am79C983A Integrated Multiport
    PRELIMINARY Am79C983A Integrated Multiport Repeater 2 (IMR2™) DISTINCTIVE CHARACTERISTICS n Repeater functionality compliant with IEEE 802.3 Repeater Unit specifications n Hardware implementation of Management Information Base (MIB) with all of the counters,
    Original PDF
    hip6501a
    HIP6501A Data Sheet February 2000 Triple Linear Power Controller with ACPI Control Interface The HIP6501A, paired with either the HIP6020 or HIP6021, simplifies the implementation of ACPI-compliant designs in microprocessor and computer applications. The IC
    Original PDF
    Common Flash Interface Version 1.4 Vendor
    Common Flash Interface Version 1.4 Vendor Specific Extensions Application Note Introduction This application note provides an overview of the changes implemented between versions 1.3 and 1.4 of the SpansionTM Flash memory Common Flash Interface (CFI) implementation.
    Original PDF