Part Number
    Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    I-CODE 2 TAG ANTENNA Search Results

    I-CODE 2 TAG ANTENNA Result Highlights (5)

    Part ECAD Model Manufacturer Description Download Buy
    TC4511BP
    Toshiba Electronic Devices & Storage Corporation CMOS Logic IC, BCD-to-7-Segment Decoder, DIP16 Datasheet
    68305-001LF
    Amphenol Communications Solutions Din Accessory Coding PDF
    65197-001LF
    Amphenol Communications Solutions Din Accessory Coding Part PDF
    70275-001LF
    Amphenol Communications Solutions 70275-001LF-METRAL FEM CODING PART PDF
    91290-101LF
    Amphenol Communications Solutions Board-to-Board Coding System, Receptacle Key, LF PDF

    Documents mentioning I-CODE 2 TAG ANTENNA

    Document Partial File Text Tags Type PDF
    hitag 2
    ib technology Data Sheet H2PROT.PDF 8 Pages Last Revised 21/03/06 Micro RWD H2 Protocol The MicroRWD H2 version is a complete reader and tag acceptance solution for Hitag 2 RF transponders. The solution only needs a 700uH antenna coil connected and 5v DC supply to be a fully featured read/write system. The module provides internal EEPROM
    Original PDF
    passive rfid tags
    AN710 Antenna Circuit Design Author: Dr. Youbok Lee, Ph.D. Microchip Technology Inc. INTRODUCTION Passive RFID tags utilize an induced antenna coil voltage for operation. This induced AC voltage is rectified to provide a voltage source for the device. As the DC
    Original PDF
    an678
    M Author: AN678 RFID Coil Design Youbok Lee Microchip Technology Inc. REVIEW OF A BASIC THEORY FOR ANTENNA COIL DESIGN Current and Magnetic Fields INTRODUCTION In a Radio Frequency Identification (RFID) application, an antenna coil is needed for two main reasons:
    Original PDF
    an830
    AN830 RFID Tag and COB Development Guide with Microchip’s RFID Devices Author: Youbok Lee, Ph.D. Microchip Technology Inc. INTRODUCTION A passive RFID tag contains an RFID integrated circuit (IC), resonant capacitor (C), and antenna (L), as shown in Figure 1. The antenna and capacitor form a parallel
    Original PDF
    ahpr
    ALLEN-BRADLEY Bulletin 2750 Intelligent Antennas (Catalog No. 2750-AS, -ASP, -ASD, -ASPR 2750-AH, -AHP, -AHD, -AHPR) Product Data General. This document describes the Allen-Bradley families of Intelligent Antennas. l Catalog No. 2750-AS Series Antennas are RS-232/422 devices which
    Original PDF
    Using low power transponders and tags for RFID applications. by Thierry Roz (troz@emmarin.ch) Vincent Fuentes (vfuentes@emmarin.ch) EM MICROELECTRONIC MARIN SA, 2074 MARIN - Switzerland antenna geometry should I use to reach 50cm with this transponder integrated circuit ?
    Original PDF
    MLX90109 125kHz RFID Transceiver Features and
    MLX90109 125kHz RFID Transceiver Features and Benefits Integrated RFID transceiver Addressing 100kHz to 150kHz frequency range transponder. Biphase and Manchester ASK. ON/OFF keying modulation. Low Power and high performance Unique Parallel Antenna concept for maximum power efficiency.
    Original PDF
    MLX90109 125kHz RFID Transceiver Features and
    MLX90109 125kHz RFID Transceiver Features and Benefits Integrated RFID transceiver Adressing 100kHz to 150kHz frequency range transponder. Biphase and Manchester ASK. ON/OFF keying modulation. Low Power and high performances Unique Parallel Antenna concept for maximum power efficiency.
    Original PDF
    MLX90109 125kHz RFID Transceiver Features and
    MLX90109 125kHz RFID Transceiver Features and Benefits 1 Integrated RFID transceiver Adressing 100kHz to 150kHz frequency range transponder. Biphase and Manchester ASK. ON/OFF keying modulation. 1 Low Power and high performances Unique Parallel Antenna concept for maximum power efficiency.
    Original PDF
    mlx90109
    MLX90109 125kHz RFID Transceiver Features and Benefits   Integrated transceiver for 100kHz to 150kHz range ASK transponder (tags) Unique Parallel Antenna concept for maximum power efficiency. No external quartz reference required. No zero modulation problems.
    Original PDF
    CR95HF 13.56-MHz multi-protocol contactless
    CR95HF 13.56-MHz multi-protocol contactless transceiver IC with SPI and UART serial access Features ■ Operating modes supported: – Reader/Writer ■ Hardware features – Dedicated internal frame controller – Highly integrated Analog Front End (AFE)
    Original PDF
    sgi-1
    important User information Solid-state equipment has operational characteristics differing from those of electromechanical equipment. “Application Considerations for Solid-State Controls” (Publication SGI-1.1) describes some important differences between solid-state
    Original PDF
    CR95HF 13.56-MHz multi-protocol contactless
    CR95HF 13.56-MHz multi-protocol contactless transceiver IC with SPI and UART serial access Features ■ Operating modes supported: – Reader/Writer ■ Hardware features – Dedicated internal frame controller – Highly integrated Analog Front End (AFE)
    Original PDF
    cr95hf
    CR95HF 13.56-MHz multi-protocol contactless transceiver IC with SPI and UART serial access Datasheet −production data Features ■ Operating modes supported: – Reader/Writer ■ Hardware features – Dedicated internal frame controller – Highly integrated Analog Front End (AFE)
    Original PDF
    STRFNFCA Near field communication transceiver
    STRFNFCA Near field communication transceiver Datasheet −production data Features ■ Operating modes supported: – Reader/Writer – Card Emulation – Peer-to-Peer ■ Hardware features – Dedicated internal frame controller – Highly integrated Analog Front End (AFE)
    Original PDF
    NEW RFID System V680 Series Next-Generation RFID
    NEW RFID System V680 Series Next-Generation RFID System Conforming to ISO/IEC 18000-3 (ISO/IEC 15693). New ID Sensor Units for CJ1/CS1 PLCs and New M12 Antenna. Visualize data transmission on production lines. Managing process instructions and histories for engine
    Original PDF
    an710
    AN710 Antenna Circuit Design Author: Dr. Youbok Lee, Ph.D. Microchip Technology Inc. INTRODUCTION Passive RFID tags utilize an induced antenna coil voltage for operation. This induced AC voltage is rectified to provide a voltage source for the device. As the DC
    Original PDF
    A9212-A 13.56MHz RFID TAG IC Ver 1.0 FEATURE
    A9212-A 13.56MHz RFID TAG IC Ver 1.0 FEATURE eEEPROM Memory – Compatible with ISO/IEC 15693 Standard – No External power supply required – 13.56MHz operating frequency – Embedded Total 512 x 8 bit EEPROM Up to 448 bytes of user data memory organized in 112 four-byte blocks
    Original PDF
    mlx90109
    MLX90109 125kHz RFID Transceiver Features and Benefits   Integrated RFID transceiver Adressing100kHz to 150kHz frequency range transponder. Biphase and Manchester ASK. ON/OFF keying modulation. Low Power and high performances Unique Parallel Antenna concept for maximum power efficiency.
    Original PDF
    CR95HF 13.56-MHz multi-protocol contactless
    CR95HF 13.56-MHz multi-protocol contactless transceiver IC with SPI and UART serial access Datasheet − production data Features ■ Operating modes supported: – Reader/Writer ■ Hardware features – Dedicated internal frame controller – Highly integrated Analog Front End (AFE)
    Original PDF
    Important User In formation Solid-state equipment
    Important User In formation Solid-state equipment has operational characteristics differing from those of electromechanical equipment. “Application Considerations for Solid-State Controls” (Publication SGI-1.1) describes some important differences between solid-state equipment and hard wired
    Original PDF
    cr95hf
    CR95HF 13.56-MHz multi-protocol contactless transceiver IC with SPI and UART serial access Datasheet −production data Features ■ Operating modes supported: – Reader/Writer ■ Hardware features – Dedicated internal frame controller – Highly integrated Analog Front End (AFE)
    Original PDF
    mlx90132
    MLX90132 13.56MHz RFID / NFC Transceiver Features and Benefits Application Examples Conforms with ISO/IEC 18092 (NFC) Conforms with ISO/IEC 14443 A1 and B2, Conforms with ISO/IEC 15693 Conforms with ISO/IEC 18000-3 mode 1 Standard SPI interface with 256 Bytes Buffer
    Original PDF