EWAVR Search Results
Documents mentioning EWAVR
| Document | Partial File Text | Tags | Type | |||
|---|---|---|---|---|---|---|
| avr32 | AVR32733: Placing data and the heap in external SDRAM. Features • Place the heap in external SDRAM • Place variables in external SDRAM • SDRAMC Software Framework driver usage • GNU linker script overview and IAR™ linker command file overview • Startup customization APIs of the AVR32 GNU Toolchain and IAR EWAVR32 |
Original | ||||
| AVR4016: Sensors Xplained Software Users Guide | AVR4016: Sensors Xplained Software Users Guide Features • Hardware-independent C language interfaces for sensor devices Conversion to standard units for all measurement types Device drivers for a variety of MEMS-based sensors Easy-to-use configuration and initialization |
Original | ||||
| Features General • High-performance, Low-power | Features General • High-performance, Low-power secureAVRTM Enhanced RISC Architecture • – 135 Powerful Instructions (Most Executed in a Single Clock Cycle) Low Power Idle and Power-down Modes Bond Pad Locations Conforming to ISO 7816-2 |
Original | ||||
| Features General • High-performance, Low-power | Features General • High-performance, Low-power secureAVR™ RISC Architecture – 135 Powerful Instructions (Most Executed in a Single Clock Cycle) Low Power Idle and Power-down Modes Bond Pad Locations Conforming to ISO 7816-2 ESD Protection to ± 6000V |
Original | ||||
| Getting Started with the IAR Embedded Workbench | Getting Started with the IAR Embedded Workbench for FPSLIC Introduction The purpose of this application note is to guide new users through the design and development of C/Assembly code for FPSLIC when using an IAR Embedded Workbench (IAREW). This application note provides information on all the settings in |
Original | ||||
| avr10 | AVR107: Interfacing AVR serial memories Features • Devices: AT25128A/256A, AT25F1024/2048/4096 Full Serial Memory Functions Support Memory Array Burst Read Page Burst Write Write Protection Detection On Going Access Detection |
Original | ||||
| avr32 uc3 software framework | AVR32 UC3 Software Framework… User Manual Section 1 AVR32 UC3 Software Framework 1.1 Features Drivers for each AVR®32 UC3 peripheral Software libraries optimized for AVR32 |
Original | ||||
| Features General • High-performance, Low-power | Features General • High-performance, Low-power secureAVR® RISC Architecture • – 135 Powerful Instructions (Most Executed in a Single Clock Cycle) Low Power Idle and Power-down Modes Bond Pad Locations Conforming to ISO 7816-2 ESD Protection to ± 6000V |
Original | ||||
| bldc driver | Fully Integrated BLDC Motor Control from the Signal Generation to the Full BLDC Motor Control Chain 1. Description The purpose of this document is to explain the theory and application of Atmel®’s integrated BLDC driver solution. The worldwide demand for BLDC systems is increasing |
Original | ||||
| avr064 | AVR064: STK502 – A Temperature Monitoring System with LCD Output Features • Presenting Data on an LCD Display Temperature Measurement Real Time Clock (RTC) UART Communication with a PC PWM Implementation Introduction 8-bit Microcontroller |
Original | ||||
| SEMICONDUCTORS MCU/MPU/DSP Atmel… 167, 168, 169, | SEMICONDUCTORS MCU/MPU/DSP Atmel… 167, 168, 169, 170, 171, 172 Blackhawk… 173 Cyan… 174 Cypress… 175, 176, 177, 178 |
Original | ||||
| Features General • High-performance, Low-power | Features General • High-performance, Low-power secureAVR™ Enhanced RISC Architecture • – 137 Powerful Instructions (Most Executed in a Single Clock Cycle) Low Power Idle and Power-down Modes Bond Pad Locations Conforming to ISO 7816-2 |
Original | ||||
| avr312 | AVR312: Using the USI module as a I2C slave Features • C-code driver for TWI slave, with transmit and receive buffers Compatible with Philips' I2C protocol Interrupt driven, detection and transmission/reception Wake up from all sleep mode, including Power Down |
Original | ||||
| avr443 | AVR443: Sensor-based control of three phase Brushless DC motor Features • Less than 5us response time on Hall sensor output change Theoretical maximum of 1600k RPM Over-current sensing and stall detection Support for closed loop regulation |
Original | ||||
|
|
||||||
| avr065 | AVR065: LCD Driver for the STK502 and AVR Butterfly Features • Software Driver for Alphanumeric Characters Liquid Crystal Display (LCD) Contrast Control Interrupt Controlled Updating Conversion of ASCII to LCD Segment Control Codes (SCC) |
Original | ||||
| avr307 | AVR307: Half Duplex UART Using the USI Module Features • Half Duplex UART Communication Communication Speed Up To 230.4 kbps at 14.75MHz Interrupt Controlled Communication Eight Bit Data, One Stop-bit, No Parity Data Buffer Handling 8-bit |
Original | ||||
| avr341 | AVR341: Four and five-wire Touch Screen Controller Features • Reading touch screen coordinates for 4- and 5-wire screens • Measurement of screen resistance (4-wire) • Translation of touch coordinates into screen coordinates. 8-bit Microcontrollers Application Note |
Original | ||||
| at86rf230 | AVR2001: AT86RF230 Software Programmer's Guide Features 8-bit Microcontrollers • Complete set of programming sequences for the AT86RF230 radio transceiver. - Extends the information in the datasheet. - Detailed Timing Information. - Hints and Notifications for optimized usage. |
Original | ||||
| avr275 | AVR275: Sensor-based Control of Three Phase Brushless DC Motors Using AT90USB family 8-bit Features • Less than 3µs response time on Hall sensor output change • Theoretical maximum of 3478K RPM (Electrical RPM) • Support for closed loop regulation, over current, stall and overload detection. |
Original | ||||
| flexray | 50 Atmel Automotive Compilation, Vol. 5 Standard Products Atmel's FlexRay Evaluation and Development Platform Fabrice Gasnier Introduction tially developed to be used in ‘X-by- ‘frames’ are generated accord- wire’ applications. While support- ing to a time schedule. Different |
Original | ||||
| avr480 | AVR480: Anti-Pinch System for Electrical Window Automotive motorized window or door apparatus which closes automatically involve risks for trapping, squeezing or injury to people. They must reverse their movement in case the force applied by the motor gets higher than one normalized limit. The feature |
Original | ||||
| avr1000: getting started writing c-code for xmega | AVR1000: Getting Started Writing C-code for XMEGA Features • Naming conventions - Register names - Bit names • C-code names - Bit and group masks - Group configuration masks • Methods for accessing registers • Methods for writing reusable module functions |
Original | ||||
| avr4029 | Atmel AVR4029: AVR Software Framework Getting Started Features • Access to ASF examples Add ASF modules to a project Atmel® AVR Studio® 5 IAR™ GNU makefile / GCC Atmel Microcontrollers Application Note 1 Introduction The Atmel AVR software framework (ASF, www.atmel.com/asf) provides software |
Original | ||||
| Features General • High-performance, Low-power | Features General • High-performance, Low-power secureAVR™ RISC Architecture – 135 Powerful Instructions (Most Executed in a Single Clock Cycle) Low Power Idle and Power-down Modes Bond Pad Locations Conforming to ISO 7816-2 ESD Protection to ± 6000V |
Original | ||||