Part Number
    Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    ELECTRONIC BALLAST 4 SCHEMATIC Search Results

    ELECTRONIC BALLAST 4 SCHEMATIC Result Highlights (5)

    Part ECAD Model Manufacturer Description Download Buy
    AV-THLIN2BNCM-005
    Amphenol Cables on Demand Amphenol AV-THLIN2BNCM-005 Thin-line Coaxial Cable - BNC Male / BNC Male (SDI Compatible) 5ft PDF
    CN-DSUB25PIN0-000
    Amphenol Cables on Demand Amphenol CN-DSUB25PIN0-000 D-Subminiature (DB25 Male D-Sub) Connector, 25-Position Pin Contacts, Solder-Cup Terminals PDF
    CN-DSUBHD26PN-000
    Amphenol Cables on Demand Amphenol CN-DSUBHD26PN-000 High-Density D-Subminiature (HD26 Male D-Sub) Connector, 26-Position Pin Contacts, Solder-Cup Terminals PDF
    CO-058BNCRBNC-010
    Amphenol Cables on Demand Amphenol CO-058BNCRBNC-010 BNC Male to BNC Right Angle Male (RG58) 50 Ohm Coaxial Cable Assembly 10ft PDF
    CO-058BNCX200-012
    Amphenol Cables on Demand Amphenol CO-058BNCX200-012 BNC Male to BNC Male (RG58) 50 Ohm Coaxial Cable Assembly 12ft PDF

    Documents mentioning ELECTRONIC BALLAST 4 SCHEMATIC

    Document Partial File Text Tags Type PDF
    stgd18n40lz
    2 STGD18N40LZ IGBT series Market’s smallest high-performance pencil-coil electronic-ignition driver 3. SMM4F series 400 W high temperature TransilTM provides high power in ultra slim STmite package 4. Lighting design tool From electronic ballast design to product selection with new interactive design tool
    Original PDF
    ap1661
    BCD Semi Ltd Co. AP1661 2*36W ballast Demo Board Manual Content: 1. Description 2. Specifications 3. Schematics of the Demo Board 4. PCB Layout 5. Photo View of the Demo Board 6. PCB Dimensions 7. BOM 8. Test Result PROPRIETARY & CONFIDENTIAL ADVANCED ANALOG CIRCUITS CORPORATION
    Original PDF
    ds2890
    Application Note 191 DS2890 and Fluorescent Lighting Control www.maxim-ic.com INTRODUCTION The largest single load in commercial buildings, typically consuming 40% of electric energy, is fluorescent electric lighting. Despite improvements in equipment efficiency, lighting energy is
    Original PDF
    A New Power Factor Correction and Ballast Control
    A New Power Factor Correction and Ballast Control IC Thomas J. Ribarich International Rectifier 233 Kansas St., El Segundo, CA, 90245-4382 tel. (310)726-8870, fax. (310)726-8846, email: tribari1@irf.com as presented to IEEE/IAS, 2001 Abstract: A new control IC has been developed which
    Original PDF
    ballast control ic
    A New Power Factor Correction and Ballast Control IC Thomas J. Ribarich International Rectifier 233 Kansas St., El Segundo, CA, 90245-4382 tel. (310)726-8870, fax. (310)726-8846, email: tribari1@irf.com as presented to the IEEE Industry Applications Society
    Original PDF
    Time Domain Modeling of Ballast Resonant
    Time Domain Modeling of Ballast Resonant Converters Thomas J. Ribarich and John J. Ribarich International Rectifier, Lighting Design Center As presented at Powersystems World, Nov 03 Abstract - A simple time-domain model has been developed which allows for rapid design and component
    Original PDF
    and8006
    AND8006/D Electronic Starter for Flourescent Lamps http://onsemi.com Prepared by: Alfredo Ochoa, Alex Lara & Gabriel Gonzalez Thyristors Applications Engineers INTRODUCTION In lighting applications for fluorescent lamps the choice of the starter switch to be used is always very important for
    Original PDF
    ® AN1546 - APPLICATION NOTE VIPower:
    ® AN1546 - APPLICATION NOTE VIPower: SELF–OSCILLATING CONVERTER USING VK05CFL FOR COMPACT FLUORESCENT LAMPS N. Aiello - S. Messina ABSTRACT This application note introduces a new self–oscillating converter based on VK05CFL device to drive “SE”, “DE”, and “TE” fluorescent tubes. The design is intended for 5 to 23W fluorescent lamps and 110V,
    Original PDF
    vk05cfl
     AN1546 - APPLICATION NOTE VIPower: SELF–OSCILLATING CONVERTER USING VK05CFL FOR COMPACT FLUORESCENT LAMPS N. Aiello - S. Messina ABSTRACT This application note introduces a new self–oscillating converter based on VK05CFL device to drive “SE”, “DE”, and “TE” fluorescent tubes. The design is intended for 5 to 23W fluorescent lamps and 110V,
    Original PDF
    Digitally Addressable DALI Dimming Ballast
    Digitally Addressable DALI Dimming Ballast Cecilia Contenti and Tom Ribarich Applications Engineer, International Rectifier, Lighting Group, 101S Sepulveda Blv. El Segundo, CA, 90245-4382 tel. (310)726-8927, fax. (310)726-8846, email: cconten1@irf.com as presented at APEC 2002
    Original PDF
    Bipolar power diodes and transistors for
    Bipolar power diodes and transistors for electronic ballast Understanding PFC - Lighting applications What is Power Factor Correction (PFC) Ñ It can be defined as the reduction of the harmonic content, and/or the aligning of the phase angle of incoming current
    Original PDF
    ir2520d
    Application Note AN-1147 Filaments Detection Circuit By Andre Tjokrorahardjo Table of Contents Page Introduction… 1 Electronic Ballast Using IR2520D… 2
    Original PDF
    an3032
    AN3032 Application note STEVAL-ILB007V1, 2 x 58 W/T8 ballast based on the L6585DE suitable for 2 x 36 W/T8 lamp Introduction This application note describes a demonstration board able to drive 2 x 58 W linear T8 fluorescent tubes. The last section of the document describes the changes that need to be
    Original PDF
    ballasts
    ELECTRONIC BALLASTS, Prepare,,y R, J.Haver Motorola Inc. Voltage fed and current fed resonant inverter circuits for fluorescent lamp ballasts are discussed and a design example is presented. ,:!$,. A typical fluorescent lamp is a l-to 2-inch diameter on its
    Original PDF
    IEEE Industry Applications Society Annual Meeting
    IEEE Industry Applications Society Annual Meeting New Orleans, Louisiana, October 5-9, 1997 A New Procedure for High-Frequency Electronic Ballast Design Thomas J. Ribarich and John J. Ribarich (conslt.) International Rectifier, Power Integrated Circuits 233 Kansas St., El Segundo, CA, 90245 USA
    Original PDF
    an2771
    AN2771 Application note 2x58 W/T8 or 2x36 W/T8 ballast demonstration board driven by L6585D Introduction This application note describes a demonstration board able to drive 2x58 W linear T8 fluorescent tubes. In addition, the modifications needed to adapt the same board for 2x36 W
    Original PDF
    an-995a
    Application Notes AN-995A Electronic Ballasts Using the Cost-Saving IR215X Drivers Introduction Electronic ballast circuits have recently undergone a revolution in sophistication from the early bipolar designs of ten years ago. This has been brought about
    Original PDF
    A New Procedure for High-Frequency Electronic
    A New Procedure for High-Frequency Electronic Ballast Design Thomas J. Ribarich and John J. Ribarich (conslt.) International Rectifier, Power Integrated Circuits 233 Kansas St., El Segundo, CA, 90245 USA Phone (310)726-8870 Fax (310)726-8846 as presented at IEEE Industry Applications Society Annual Meeting, New Orleans, Louisiana, October 5-9, 1997
    Original PDF
    motorola
    O rder th is docum ent MOTOROLA by AN1049/D SEMICONDUCTOR © TECHNICAL DATA AN1049 The Electronic Control of Fluorescent Lamps Prepared by Michael BaJranzade, Power Semiconductor Applications, Motorola Toulouse, France Edited by Jim Nappe and Jim Spangler
    OCR Scan PDF
    tld58w
    APPLICATION NOTE HF-TL Ballast with UBA2021 for TLD58W Lamp AN98099 Philips Semiconductors HF-TL Ballast with UBA2021 for TLD58W Lamp Application Note AN98099 Abstract A description is given of a 58 W electronic TL ballast (demo board PR39091), which is able to drive a standard
    Original PDF
    ARE402/D THE FI FCTRONIC .%? CONTROL &$;’”
    ARE402/D THE FI FCTRONIC .%? CONTROL &$;’” Reprinted December MOTOROLA @ Semiconductor Products by permission of ELECTRONIQUE 1988 Issue, 01988 SPS, All Rights DE PUISSANCE, Reserved. THE ELECTRONIC CONTROL OF FLUORESCENT TUBES ,., ‘, . Prepared by:
    Original PDF
    AN880 APPLICATION NOTE  THE L6569: A NEW HIGH
    AN880 APPLICATION NOTE  THE L6569: A NEW HIGH VOLTAGE IC DRIVER FOR ELECTRONIC LAMP BALLAST by G. Calabrese and T. Castagnet INTRODUCTION Electronic lamp ballasts are now popular in both consumer and industrial lighting. They offer power saving, flicker free operation and reduced sizes.
    Original PDF
    APPLICATION NOTE THE L6569: A NEW HIGH VOLTAGE IC
    APPLICATION NOTE THE L6569: A NEW HIGH VOLTAGE IC DRIVER FOR ELECTRONIC LAMP BALLAST by G. Calabrese and T. Castagnet INTRODUCTION Electronic lamp ballasts are now popular in both consumer and industrial lighting. They offer power saving, flicker free operation and reduced sizes.
    Original PDF
    l6569
    AN880 APPLICATION NOTE ® THE L6569: A NEW HIGH VOLTAGE IC DRIVER FOR ELECTRONIC LAMP BALLAST by G. Calabrese and T. Castagnet INTRODUCTION Electronic lamp ballasts are now popular in both consumer and industrial lighting. They offer power saving, flicker free operation and reduced sizes.
    Original PDF
    voltage
    APPLICATION NOTE THE L6569: A NEW HIGH VOLTAGE IC DRIVER FOR ELECTRONIC LAMP BALLAST by G. Calabrese and T. Castagnet INTRODUCTION Electronic lamp ballasts are now popular in both consumer and industrial lighting. They offer power saving, flicker free operation and reduced sizes.
    Original PDF