E505 Search Results

Contextual Info: Application Note VS-702 VCSO Typical Phase Noise and Jitter Measurements Phase Noise Results Phase noise measurements were performed on an Agilent E5052 SSA using an evaluation board with AC coupled output. The E5052 SSA has a phase noise to jitter integration calculation feature and devices

VDUGLD-51M840

Abstract: E5052A 19M440 24M704
Contextual Info: Application Note V-Type, CMOS VCXO Typical Phase Noise Measurements Phase Noise Results Phase noise measurements were performed on an Agilent E5052A signal source analyzer SSA . The E5052A has a phase noise to jitter integration calculation feature and devices were characterized in the

vectron

Abstract: E5052A VTC4-B22E-12M800 vtc4
Contextual Info: Application Note VTC4, Clipped Sine Wave TCXO Typical Phase Noise Measurements Phase Noise Results Phase noise measurements were performed on an Agilent E5052A signal source analyzer SSA . The E5052A has a phase noise to jitter integration calculation feature and devices were characterized in the

E5052B

Abstract: 11970W E5001A E5053A E5052B-011 11970A Average Current Mode Controlled Power Factor Corr 1 watt RF band pass filter 2.45 ghz N5507 11970U
Contextual Info: Agilent E5052B Signal Source Analyzer 10 MHz to 7 GHz, 26.5 GHz, or 110 GHz Data Sheet Definitions RF Input Port All specifications apply over a 23 °C ± 5 °C range unless otherwise stated and 30 minutes after the instrument has been turned on. Table 1-1. RF IN port

Agilent E5052 settling time

Abstract: E5052A E5001A 801 floppy n5507a E5053A E5052A-011 N5507
Contextual Info: Agilent E5052A Signal Source Analyzer 10 MHz to 7, 26.5, or 110 GHz Data Sheet Definitions All specifications apply over a 18 °C to 28 °C range unless otherwise stated and 30 minutes after the instrument has been turned on. All specified and supplemental values for RF input signals are

FSUP26

Contextual Info: reference phase locked translator connectorized MODEL: KFcts800-10 800 MHz fixed frequency FEATURES: ► Ultra-Low Phase Noise ► No Programming Required Phase Noise Measured with Agilent E5052A or R&S FSUP-26/27 -60 -70 Phase Noise (dBc/Hz) -80 -90 -100

E5052A

Abstract: 3 phase soft start Z-Communications IS-136 AN-109 fixture
Contextual Info: VCO Application Note AN-109 Phase Noise Measurement of Z-Communications VCOs Phase noise of ZCOMM VCOs free running can be measured at different offsets, using the test set up and procedure below. Figure AN-109:1- VCO Phase Noise Measurement Setup Procedure using Agilent Technologies E5052A Signal Source Analyzer

Contextual Info: SHT, 1 MR 1- SDA-90897 OF 1 M O DIFIC ATIO N ECN IS S . DATE in it E 50 I6 6 A 34. II. 14 PW E50235 B 35.4 . 9 SM E5050T C 35. 5 . 9 E600B7 D N EW RELEASE 1.2 K IN K REM O VED SM 1.2 D C N /P LA T IN G 3 5 .0 B .I4 P B 1.2 E N G I N E E R IN G M O LEX EURO PE

dallas date code

Abstract: E50501 E505 DS1013 DS1035 DS1044
Contextual Info: DALLAS SEMICONDUCTOR 4401 South Beltwood Parkway Dallas, Texas 75244–3292 214 450–0400 Date: July 10, 1995 To: Subject: PRODUCT CHANGE NOTICE – E50501 Description: DS1035 B to C Die Revision Change The attached letter has been generated as a part of the Dallas Semiconductor Product Change Notification Procedure. Please insure that it gets to the correct person at the customer’s facility. We are asking

FCTS1000-10

Contextual Info: reference phase locked translator surface mount MODEL: Fcts800-10 800 MHz fixed frequency FEATURES: ► Ultra-Low Phase Noise ► No Programming Required Phase Noise Measured with Agilent E5052A or R&S FSUP-26/27 -60 -70 Phase Noise (dBc/Hz) -80 -90 -100

C0413

Abstract: FSUP26 FCTS1000-10
Contextual Info: reference phase locked translator connectorized MODEL: KFcts1000-10 1000 MHz fixed frequency FEATURES: ► Ultra-Low Phase Noise ► No Programming Required Phase Noise Measured with Agilent E5052A or R&S FSUP-26/27 -70 -80 Phase Noise (dBc/Hz) -90 -100

"power line modem"

Abstract: rx2 G receiver ic remote control NE5050 NE5050N
Contextual Info: Product specification Philips Sem iconductors Linear Products Power line modem E5050 PIN CONFIGURATION DESCRIPTION The N E5050 is a modem for pow er line, coaxial cable, and twisted-pair com m unications. The m odem in corporates features to overcom e line im pulse noise and line im pedance m odulation. The

BD-E505RD

Contextual Info: BRIGHT LED ELECTRONICS CORP. BD-E505RD SINCE 1981 ● ● Features : 1. 0.50 inch 12.70mm Digit Height. 2. Continuous uniform segments. 3. Low power requirement. 4. Excellent characters appearance. 5. Solid state reliability. 6. Categorized for luminous intensity.

FCTS1000-10

Contextual Info: reference phase locked translator surface mount MODEL: Fcts1000-10 1000 MHz fixed frequency FEATURES: ► Ultra-Low Phase Noise ► No Programming Required Phase Noise Measured with Agilent E5052A or R&S FSUP-26/27 -70 -80 Phase Noise (dBc/Hz) -90 -100

VC-800-LAF-GTJ-19M440

Abstract: VCXO vectron E5052A VC-800 27M000 VC-800-LAF-GTJ-32M768 VECTRON
Contextual Info: Application Note VC-800, CMOS VCXO Typical Phase Noise Measurements Phase Noise Results Phase noise measurements were performed on an Agilent E5052A signal source analyzer SSA . The E5052A has a phase noise to jitter integration calculation feature and devices were characterized in the

VCC6-QAB-156M25

Abstract: VCC6-QCD-250M000 Vectron International E5052A vectron VCC6-QAB-155M52 VCC6-QCB-87M500 Noise VCC6-QAB-74M250 VCC6-QCD-250M00
Contextual Info: Application Note VCC6, LVPECL XO Typical Phase Noise Measurements Phase Noise Results Phase noise measurements were performed on an Agilent E5052A signal source analyzer SSA . The E5052A has a phase noise to jitter integration calculation feature and devices were characterized in the

NB6N11SMNG

Contextual Info: NB6N11S 3.3 V 1:2 AnyLevelE Input to LVDS Fanout Buffer / Translator Description The NB6N11S is a differential 1:2 Clock or Data Receiver and will accept AnyLevel input signals: LVPECL, CML, LVCMOS, LVTTL, or LVDS. These signals will be translated to LVDS and two identical

Contextual Info: CDCM7005 www.ti.com SCAS793B – JUNE 2005 – REVISED OCTOBER 2005 3.3-V HIGH PERFORMANCE CLOCK SYNCHRONIZER AND JITTER CLEANER GND GND GND GND GND GND C VBB GND AVCC AVCC AVCC AVCC AVCC GND STATUS_ REF or PRI_SEC_ CLK STATUS_ D VCXO_IN GND GND GND GND GND

ADF4350

Abstract: ADF4351 ADF4350BCPZ ADF4350BCPZ-RL7 SW 5189 C EVAL-ADF4350EB2Z ADSP-BF527 DB31 E5052A GSM900
Contextual Info: Wideband Synthesizer with Integrated VCO ADF4350 FEATURES GENERAL DESCRIPTION Output frequency range: 137.5 MHz to 4400 MHz Fractional-N synthesizer and integer-N synthesizer Low phase noise VCO Programmable divide-by-1/-2/-4/-8/-16 output Typical rms jitter: <0.4 ps rms

CF5076

Abstract: WF5076
Contextual Info: 5076 series VCXO Module IC with Built-in Varicap OVERVIEW The 5076 series are miniature VCXO ICs that provide a wide frequency pulling range, even when using miniature crystal units for which a wide pulling range is difficult to provide. They employ a recently developed varicap diode fabrication process that provides a wide frequency pulling range and good linearity without any

S&EI CAPACITORS

Abstract: B-405 E824 e155 B504 x473
Contextual Info: r~ • "■ , y *- . :" . . / ^ lili ; . : ■ ~ 7 - ' . ■ . ■. - ^ ,í T . . . . . . . ff' / . .’ . '/ A» , =- ■ ; . - / . *# A * .- sei 'y ' - . - ' : : ' : . : ' . , > : r t CAPACITORS •• . METALLIZED POLYESTER CAPACITORS OvaI Wrap~and-Fill Style

Contextual Info: LMK03200 Precision Clock Conditioner with Integrated VCO Evaluation Board Operating Instructions 6-16-2009 National Semiconductor Corporation Interface 2900 Semiconductor Dr. MS A2-600 Santa Clara, CA, 95052-8090 L M K 0 3 2 0 0 E V A L U A T I O N B O A R D

Contextual Info: LMX2531LQ1570E Evaluation Board Operating Instructions National Semiconductor Corporation Wireless Communications, RF Products Group 2900 Semiconductor Dr. M/S A-600 Santa Clara, CA, 95052-8090 LMX2531LQ1570EFPEB Rev 1.20.2006 L M X 2 5 3 1 L Q 1 5 7 0 E E V A L U A T I O N

CDCM7005HFG-V

Abstract: smd y1a
Contextual Info: CDCM7005-SP www.ti.com . SGLS390A – JULY 2009 – REVISED AUGUST 2009 3.3-V HIGH PERFORMANCE RAD-TOLERANT CLASS V, CLOCK SYNCHRONIZER AND