E12388 Search Results

E12388

Abstract: mcm 1250
Contextual Info: Æk. n U M l w E l i r * AMPOWER Terminals and Splices Catalog 82025 Revised 5-95 Product Facts • Designed for large cables and leads ■ Ideally suited for power generation and distribution a Accepts a wide range of stranded copper wires 6 AWG to 1000 MCM [13507 mm2]— for terminals

Contextual Info: _ _ AMPOWER Terminals and Splices Catalog 1307612 Revised 7-01 Product Facts • Designed for large cables and leads ■ Ideally suited for power generation and distribution ■ Accepts a wide range of stranded copper wires 6 AWG to 1000 MCM [13507 mm2]— for terminals

69133

Abstract: 59973-1 46756-2 69099 408-6803 CM119 mcm 1250 terminals mcm 350 325602 46753
Contextual Info: Data downloaded from http://www.anglia.com - the website of Anglia - tel: 01945 474747 AMPOWER Terminals and Splices Catalogue 1654741 Revised 1-04 Product Facts • Designed for large cables and leads ■ Ideally suited for power generation and distribution

68284-1

Abstract: M 6965-3
Contextual Info: r AMPOWER Terminals and Splices Issued 5-97 AMPOWER terminals and splices are ideally suited for power generation and distribution. This makes electrical equipment subject to continuous operation, such as generators, motors and welders, a perfect application

59973-1

Abstract: 324468 326803 325702 mcm 1250 311471-1 326807 325703 DYNA-CRIMP Tyco Electronics 325201
Contextual Info: AMPOWER Terminals and Splices Catalog 82025 Revised 05-95 Product Facts • Designed for large cables and leads ■ Ideally suited for power generation and distribution ■ Accepts a wide range of stranded copper wires 6 AWG to 1000 MCM [13507 mm2]— for terminals

59973-1

Abstract: tyco crimp height chart 46756-2 butt splices 408-1602 69099 409-1950 mcm 1250 58422-1 assembly instruction 3068
Contextual Info: Application Specification 114- 2150 AMPOWER* Terminals and Splices NOTE i 18 NOV 09 Rev B All numerical values are in metric units [with U.S. customary units in brackets]. Dimensions are in millimeters [and inches]. Unless otherwise specified, dimensions have a tolerance of +0.13 [+.005] and angles have a tolerance of +2_.