DS0088 Search Results

1265

Abstract: TSF1265-01 f095
Contextual Info: Flexibility & Innovation …. DS0088 V.03 14/08/00 DATA SHEET TSF1265-01 1265 MHZ S.A.W.FILTER PRELIMINARY SPECIFICATION PACKAGE 3.8X3.8 MM SMD B E A F A F B E C D Ø LOW LOSS 3.8 mm D Ø HIGH REJECTIONS Ø SMALL SMD PACKAGE Ø SMALL AMPLITUDE AND GROUP DELAY VARIATION

MCP4716

Abstract: MCP4706 MCP47A1 Potentiometers sot 23-6 Marking Code MCP4726 DS25118 a6 marking code sot LT 5210 mcp470 UM10204
Contextual Info: MCP47A1 6-Bit Volatile DAC with Command Code • 6-Bit DAC - 65 Taps: 64 Resistors with Taps to Full-Scale and Zero-Scale Wiper Code 00h to 40h • VREF Pull-down Resistance: 20 k (typical) • VOUT Voltage Range - VSS to VREF • I2C Protocol - Supports SMBus 2.0 Write Byte/Word

LM2940

Abstract: L53B SOT-223 LM2940IMP-9 LM2940CST LM2940LD-10 LM2940C LM2940CT-9 LM2940CT-5 LM2940T-9 LM2940T-5
Contextual Info: LM2940/LM2940C 1A Low Dropout Regulator General Description The LM2940/LM2940C positive voltage regulator features the ability to source 1A of output current with a dropout voltage of typically 0.5V and a maximum of 1V over the entire temperature range. Furthermore, a quiescent current

VSS010

Abstract: marking AAW VSS030
Contextual Info: MCP6401/1R/1U/2/4/6/7/9 1 MHz, 45 µA Op Amps Features Description • • • • • • The Microchip Technology Inc. MCP6401/1R/1U/2/4/6/7/9 family of operational amplifiers op amps has low quiescent current (45 µA, typical) and rail-to-rail input and output

MCP6031

Abstract: 6034E 14L-SOIC 6034EST
Contextual Info: MCP6031/2/3/4 0.9 µA, High Precision Op Amps Features Description • • • • • • • • The Microchip Technology Inc. MCP6031/2/3/4 family of operational amplifiers op amps operate with a single supply voltage as low as 1.8V, while drawing ultra low quiescent current per amplifier (0.9 µA,

Contextual Info: MCP6491 7.5 MHz, Low-Input Bias Current Op Amps Features Description • Low Input Bias Current - 150 pA typical, TA = +125°C • Low Quiescent Current - 530 µA/amplifier (typical) • Low Input Offset Voltage - ±1.5 mV (maximum) • Supply Voltage Range: 2.4V to 5.5V

marking ABG 8pin

Abstract: 2012 Product Selector Guide PICMICRO
Contextual Info: MCP6H91/2/4 10 MHz, 12V Op Amps Features: Description: • • • • • • Microchip’s MCP6H91/2/4 family of operational amplifiers op amps has a wide supply voltage range of 3.5V to 12V and rail-to-rail output operation. This family is unity gain stable and has a gain bandwidth

wu25

Abstract: 5pin MARK AOL
Contextual Info: MCP6441 450 nA, 9 kHz Op Amp Features: Description: • • • • • • • • • The MCP6441 device is a single nanopower operational amplifier op amp , which has low quiescent current (450 nA, typical) and rail-to-rail input and output operation. This op amp is unity gain stable

SMD SOT23 transistor MARK 1e

Abstract: sot 23 MARKING CODE RGB sot-23 Marking N2 smd code marking 56 sot23-6 SMD Marking Code Microchip TRANSISTOR SMD CODE PACKAGE SOT23
Contextual Info: MCP660/1/2/3/4/5/9 60 MHz, 6 mA Op Amps Features Description • • • • • • • • The Microchip Technology, Inc. MCP660/1/2/3/4/5/9 family of operational amplifiers op amps features high gain bandwidth product (60 MHz, typical) and high output short circuit current (90 mA, typical). Some also

1P SMD MARKING CODE

Contextual Info: MCP660/1/2/3/4/5/9 60 MHz, 6 mA Op Amps Features Description • • • • • • • • The Microchip Technology, Inc. MCP660/1/2/3/4/5/9 family of operational amplifiers op amps features high gain bandwidth product (60 MHz, typical) and high output short circuit current (90 mA, typical). Some also

6004STE

Abstract: spice models mcp6001 MARKING CODE AAN SN0432 14L-PDIP MCP6001 MCP6001R MCP6002 SOIC14EV single end diode sot-23 mark pd
Contextual Info: MCP6001/1R/1U/2/4 1 MHz, Low-Power Op Amp Features Description • • • • • • • The Microchip Technology Inc. MCP6001/2/4 family of operational amplifiers op amps is specifically designed for general-purpose applications. This family has a 1 MHz Gain Bandwidth Product (GBWP) and

Contextual Info: MCP6481/2/4 4 MHz, Low-Input Bias Current Op Amps Features Description • Low-Input Bias Current - 150 pA typical, TA = +125°C • Low Quiescent Current - 240 µA/amplifier (typical) • Low-Input Offset Voltage - ±1.5 mV (maximum) • Supply Voltage Range: 2.2V to 5.5V

APC hyperterminal commands

Abstract: ecg replacement guide
Contextual Info: MCP215X/40 Developer’s Daughter Board User’s Guide 2006 Microchip Technology Inc. DS51591A Note the following details of the code protection feature on Microchip devices: • Microchip products meet the specification contained in their particular Microchip Data Sheet.

AN723

Abstract: AN884 MCP6271 pic 12f
Contextual Info: AN884 使用运放驱动容性负载 作者： 用 f2P 来模拟由于内部寄生参数而导致在高频时开环增 益减小的相位裕量（PM < 90°）。 f2P 和容性负载（CL） 均减小了反馈回路的相位裕量。 Kumen Blake Microchip Technology Inc.

MCP2150

Abstract: PIC32 uart example rs232 MCP2155 liteon keyboard notebook AN941 PIC32 PICC-18 PIC C Programming sound echo SIPEX Selection Guide programmer schematic ICD2
Contextual Info: MCP2150 Developer’s Board User’s Guide 2009 Microchip Technology Inc. DS51869A Note the following details of the code protection feature on Microchip devices: • Microchip products meet the specification contained in their particular Microchip Data Sheet.

MCP6442E

Abstract: MCP6442 an1332 MCP6441T MCP6441 AN1332 microchip
Contextual Info: MCP6441/2/4 450 nA, 9 kHz Op Amp Features: Description: • • • • • • • • • The MCP6441/2/4 device is a single nanopower operational amplifier op amp , which has low quiescent current (450 nA, typical) and rail-to-rail input and output operation. This op amp is unity gain stable

6274est

Abstract: MARKING WR SOT-23-6 sot-23-5 marking code 14L-PDIP MCP6271 MCP6271R MCP6272 MCP6273 MCP6274 MCP6275
Contextual Info: MCP6271/1R/2/3/4/5 170 µA, 2 MHz Rail-to-Rail Op Amp Features Description • • • • • • • The Microchip Technology Inc. MCP6271/1R/2/3/4/5 family of operational amplifiers op amps provide wide bandwidth for the current. This family has a 2 MHz

MCP6071

Abstract: MCP6071E MCP6074E MCP6071T MCP6074 SOIC-6 microchip MCP6072 AN990 mcp6071t-e R100-10
Contextual Info: MCP6071/2/4 110 µA 高精度运算放大器 概述 特性 • • • • • • • • 低失调电压： ±150 µV （最大值） 低静态电流： 110 µA （典型值） 轨到轨输入和输出 宽电源电压范围： 1.8V 至 6.0V 增益带宽积： 1.2 MHz （典型值）

Contextual Info: MCP6V31/1U 23 µA, 300 kHz Zero-Drift Op Amps Features Description • High DC Precision: - VOS Drift: ±50 nV/°C maximum - VOS: ±8 µV (maximum) - AOL: 120 dB (minimum, VDD = 5.5V) - PSRR: 120 dB (minimum, VDD = 5.5V) - CMRR: 120 dB (minimum, VDD = 5.5V)

Contextual Info: MCP6281/1R/2/3/4/5 450 µA, 5 MHz Rail-to-Rail Op Amp Features Description • • • • • • • • The Microchip Technology Inc. MCP6281/1R/2/3/4/5 family of operational amplifiers op amps provide wide bandwidth for the current. This family has a 5 MHz Gain

6l74

Contextual Info: MCP6L71/1R/2/4 2 MHz, 150 µA Op Amps Features Description • • • • • • The Microchip Technology Inc. MCP6L71/1R/2/4 family of operational amplifiers op amps supports general purpose applications. The combination of rail-to-rail input and output, low quiescent current and bandwidth

Contextual Info: MCP6V11/1U 7.5 µA, 80 kHz Zero-Drift Op Amps Features Description • High DC Precision: - VOS Drift: ±50 nV/°C maximum - VOS: ±8 µV (maximum) - AOL: 112 dB (minimum, VDD = 5.5V) - PSRR: 118 dB (minimum, VDD = 5.5V) - CMRR: 119 dB (minimum, VDD = 5.5V)

2GMI

Contextual Info: MCP6N11 500 kHz, 800 µA Instrumentation Amplifier Features Description • Rail-to-Rail Input and Output • Gain Set by 2 External Resistors • Minimum Gain GMIN Options: 1, 2, 5, 10 or 100 V/V • Common Mode Rejection Ratio (CMRR): 115 dB (typical, GMIN = 100)

Contextual Info: MCP6286 Low Noise, Low Power Op Amp Features • • • • • • • • • Description Low Noise: 5.4 nV/√Hz typical Low Quiescent Current: 520 µA (typical) Rail-to-Rail Output Wide Supply Voltage Range: 2.2V to 5.5V Gain Bandwidth Product: 3.5 MHz (typical)