Part Number
    Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    DIFFERENCE BETWEEN LS Search Results

    DIFFERENCE BETWEEN LS Result Highlights (5)

    Part ECAD Model Manufacturer Description Download Buy
    DAL3V3P500G4CLF
    Amphenol Communications Solutions D-Sub Power Board Mount Connectors, Input Output Connectors, Full Power 3V3 Pin Right Angle Solder 30A, Europe Standard, 200 Cycles, Front: Threaded Insert M3, Back: Harpoons for 1.6mm PCB Thickness, 1.14mm offset between R/A contacts and harpoons. PDF
    DEM-DAC90XU
    Texas Instruments 10-BIT, 165MSPS SPEEDPLUS(TM) DAC SCALABLE CURRENT OUTPUTS BETWEEN 2MA TO 20MA Visit Texas Instruments
    INA117SMQ
    Texas Instruments High Common-Mode Voltage Difference Amplifier 8-TO-99 Visit Texas Instruments
    INA133UA/2K5
    Texas Instruments High-Speed, Precision Difference Amplifiers 8-SOIC Visit Texas Instruments Buy
    INA152EA/2K5
    Texas Instruments Single-Supply Difference Amplifier 8-VSSOP -40 to 85 Visit Texas Instruments Buy

    Documents mentioning DIFFERENCE BETWEEN LS

    Document Partial File Text Tags Type PDF
    sm8750av
    SM8750AV Data Jitter Measurement IC OVERVIEW The SM8750AV is a data jitter measurement CMOS LSI that can be used to determine test signal jitter for adaptive-control recording DVD-RAM devices. It measures the phase difference between the data signal and clock and converts the phase difference to a voltage output. A sufficient sum of phase difference data, according to the system, can then be read into a CPU and analyzed to determine the amount of jitter.
    Original PDF
    an5285
    ICs for TV AN5285K Sound level automatic gain control IC ■ Overview Unit: mm 10 1.778 18.24±0.3 0.5 1.1 The AN5285K is a stereo automatic volume control IC for reducing a difference in volume between broadcasting stations and between programs. It is a kind of
    Original PDF
    Difference between old stock number (5327489) and
    Difference between old stock number (5327489) and new stock number (133850) is: RF Engine upgraded transition to latest version should be transparent TM Toothpick 2.0 PIC with integral Bluetooth and Toothpick Services firmware layer FlexiPanel 24MHz 32768Hz
    Original PDF
    8 Bit Microcontroller TLCS-870/C1 Series
    8 Bit Microcontroller TLCS-870/C1 Series TMP89FM42A © 2009 TOSHIBA CORPORATION All Rights Reserved TMP89FM42A Difference between 89FM42A and 89FM42, 89CM42 In the product with an internal oscillator (89FM42A), a part of after reset value in registers and characteristics is
    Original PDF
    ad8555
    Zero-Drift, Single-Supply, Sensor Signal Amplifier with Digitally Programmable Gain and Offset a Preliminary Technical Data AD8555 with a resolution of better than 0.4% of the difference between VDD and VSS. A lockout trim after gain and offset adjustment
    Original PDF
    pnx8510
    PNX8510; PNX8511 Analog companion chip Rev. 04 – 12 January 2004 Product data 1. General description The PNX8510; PNX8511 is an analog backend companion chip to digital ICs processing video and audio signals. The primary difference between the PNX8510 and the PNX8511 is:
    Original PDF
    mx93011
    IWKIC MX 9 3 0 1 1 A CONTENT 1.0 FEATURES 1.1 DIFFERENCE BETWEEN MX93011 and MX93011A 2.0 FUNCTION BLOCK DIAGRAM 3.0 PIN CONFIGURATION 3.1 PIN DESCRIPTIONS 3.2 PIN TYPE SUMMARY 3.3 MULTIPLEX PINS 4.0 FUNCTION DESCRITION 4.1 LOOP 4.2 MODULAR ADDRESSING 4.3 AUXILIARY REGISTERS
    OCR Scan PDF
    tl16c752b
    DATA COMMUNICATIONS APPLICATION NOTE DAN130 June 2002 EXAR’S DUARTS COMPARED WITH TI’S TL16C752B Author: PY 1.0 INTRODUCTION This application note describes the major difference between Exar’s DUARTs (ST16C2550, XR16L2750, XR16L2751 and XR16C2850) with TI’s TL16C752B. These devices are very similar, with a few hardware,
    Original PDF
    dsp56000
    SECTION 1 Introduction “Data representations are not as difficult as they may first appear. The basic difference between data representations is a shifting or scaling operation.” The DSP56000 Family of general-purpose digital signal processors (DSPs) is distinctive in that the onchip multiplier directly supports fractional data formats
    Original PDF
    mn101lr05d
    MN101LR05D/04D/03D/02D 8-bit Single-chip Microcontroller  Product Summary MN101LR05D is described in this deta sheet. For the difference between each product, See  Functions . VDD18 voltage after reset release, oscillation stabilization wait time after reset release and ROM capacity vary depending on the ROM name of
    Original PDF
    tl16c554
    DATA COMMUNICATIONS APPLICATION NOTE DAN133 June 2002 EXAR’S QUARTS COMPARED WITH TI’S TL16C554 AND TL16C554A Author: PY 1.0 INTRODUCTION This application note describes the major difference between Exar’s QUARTs (ST16C554, ST16C654, and XR16C854) with TI’s TL16C554 and TL16C554A. These devices are similar, with a few hardware, bus timing
    Original PDF
    st16c654
    DATA COMMUNICATIONS APPLICATION NOTE DAN134 June 2002 EXAR’S ST16C654 AND XR16C854 COMPARED WITH TI’S TL16C754B Author: PY 1.0 INTRODUCTION This application note describes the major difference between Exar’s ST16C654 and XR16C854 with TI’s TL16C754B. These devices are similar, with a few hardware, bus timing and firmware-related differences.
    Original PDF
    st16c650a
    DATA COMMUNICATIONS APPLICATION NOTE DAN131 June 2002 EXAR’S ST16C650A AND XR16C850 COMPARED WITH TI’S TL16C750 Author: PY 1.0 INTRODUCTION This application note describes the major difference between Exar’s ST16C650A and XR16C850 with TI’s TL16C750. These devices are very similar, with a few hardware, firmware-related and bus timing differences.
    Original PDF
    tl16c550c
    DATA COMMUNICATIONS APPLICATION NOTE DAN132 June 2002 EXAR’S SINGLE CHANNEL UARTS COMPARED WITH TI’S TL16C550C Author: PY 1.0 INTRODUCTION This application note describes the major difference between Exar’s ST16C550, ST16C580, ST16C650A, and XR16C850 with TI’s TL16C550C. These devices are very similar, with a few hardware, bus timing and firmware-related differences.
    Original PDF
    HD74HCT374/HD74HCT534 Octal D-type Flip-Flops
    HD74HCT374/HD74HCT534 Octal D-type Flip-Flops (with 3-state outputs)/ Octal D-type Flip-Flops (with inverted 3-state outputs) Description These device are positive edge triggered flip-flops. The difference between HD74HCT374 and HD74HCT534 is only that the former is a true outputs and the latter is a false outputs. Data at the D
    Original PDF
    Application Note 9018 May, 2002 Smart Power
    Application Note 9018 May, 2002 Smart Power Module User’s Guide 8.Bootstrap Circuit 8.1 Operation of a Bootstrap Circuit The VBS voltage, which is the voltage difference between VB (SPM pins 20, 25 and 29) and VS (SPM pins 21, 26 and 30), provides the supply to the HVICs within the SPM. This supply must
    Original PDF
    HD74HC374/HD74HC534 Octal D-type Flip-Flops (with
    HD74HC374/HD74HC534 Octal D-type Flip-Flops (with 3-state outputs) Octal D-type Flip-flops (with inverted 3-state outputs) Description These devices are positive edge triggered flip-flops. The difference between HD74HC374 and HD74HC534 is only that the former is a true outputs and the latter is a false outputs. Data at the D
    Original PDF
    vpx 3220
    PRELIMINARY DATA SHEET VPX 3220 A, VPX 3216 B, VPX 3214 C Video Pixel Decoders Edition July 1, 1996 6251-368-2PD VPX 3220 A, VPX 3216 B, VPX 3214 C PRELIMINARY DATA SHEET Contents Page Section Title 5 5 5 5 1. 1.1. 1.2. 1.3. Introduction Difference between VPX 3220 A and VPX 3216 B
    Original PDF