Part Number
    Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    BC327 Q1 Search Results

    Documents mentioning BC327 Q1

    Document Partial File Text Tags Type PDF
    an908
    AN908 APPLICATION NOTE  HIGH PERFORMANCE VRM USING L4990A, FOR Pentium Pro PROCESSOR by Nicola Tricomi SYSTEM DESCRIPTION The actual generation of Pentium Pro microprocessors, requires a power supply with a programmable output voltage that decreases with the increasing of the processor internal clock. At the same time
    Original PDF
    an908
    AN908 Application note High performance VRM using L4990A, for Pentium Pro® processor Introduction The actual generation of Pentium Pro® microprocessors, requires a power supply with a programmable output voltage that decreases with the increasing of the processor internal
    Original PDF
    rz7 SGS-THOMSON ^ 7 Mrn ^D©K©[l[Li©¥[^(Q)R!]0©§
    rz7 SGS-THOMSON ^ 7 Mrn ^D©K©[l[Li©¥[^(Q)R!]0©§ TECHNICAL NOTE NOVEL PROTECTION AND GATE DRIVES FOR MOSFETs USED IN BRIDGE-LEG CONFIGURATIONS INTRODUCTION Fig. 1 - B ridge configurations The bridge-leg is an im portant building block for many applications such as drives and switch-mode
    OCR Scan PDF
    /T T SGS-THOMSON * 7# . [ f f lD S S & IC T M S O
    /T T SGS-THOMSON * 7# . [ f f lD S S & IC T M S O g i TECHNICAL NOTE NOVEL PROTECTION AND GATE DRIVES FOR MOSFETs USED IN BRIDGE-LEG CONFIGURATIONS INTRODUCTION The bridge-leg is an important building block for many applications such as drives and switch-mode
    OCR Scan PDF
    an908
    AN908 APPLICATION NOTE HIGH PERFORMANCE VRM USING L4990A, FOR Pentium Pro® PROCESSOR by Nicola Tricomi SYSTEM DESCRIPTION The actual generation of Pentium Pro® microprocessors, requires a power supply with a programmable output voltage that decreases with the increasing of the processor internal clock. At the same time
    Original PDF
    an908
    AN908 APPLICATION NOTE HIGH PERFORMANCE VRM USING L4990A, FOR Pentium Pro PROCESSOR by Nicola Tricomi SYSTEM DESCRIPTION The actual generation of Pentium Pro microprocessors, requires a power supply with a programmable output voltage that decreases with the increasing of the processor internal clock. At the same time
    Original PDF
    an1585
    ® AN1585 APPLICATION NOTE PC Stand-by Power Supply with VIPer22A A. BAILLY - G. AUGUSTONI A desktop PC power supply is generally made of two power supplies: the main one built around a forward structure and able to deliver a few hundreds of Watt and switched off in standby mode; the second one
    Original PDF
    L6565 QUASI-RESONANT SMPS CONTROLLER
    L6565 QUASI-RESONANT SMPS CONTROLLER QUASI-RESONANT (QR) ZERO-VOLTAGESWITCHING (ZVS) TOPOLOGY ■ LINE FEED FORWARD TO DELIVER CONSTANT POWER vs. MAINS CHANGE ■ FREQUENCY FOLDBACK FOR OPTIMUM STANDBY EFFICIENCY ■ PULSE-BY-PULSE & HICCUP-MODE OCP ■ ULTRA-LOW START-UP (< 70µA) AND
    Original PDF
    l6565
    L6565 QUASI-RESONANT SMPS CONTROLLER QUASI-RESONANT (QR) ZERO-VOLTAGESWITCHING (ZVS) TOPOLOGY ■ LINE FEED FORWARD TO DELIVER CONSTANT POWER vs. MAINS CHANGE ■ FREQUENCY FOLDBACK FOR OPTIMUM STANDBY EFFICIENCY ■ PULSE-BY-PULSE & HICCUP-MODE OCP ■ ULTRA-LOW START-UP (< 70µA) AND
    Original PDF
    an1585
    AN1585 APPLICATION NOTE ® PC Stand-by Power Supply with VIPer22A A. BAILLY - G. AUGUSTONI A desktop PC power supply is generally made of two power supplies: the main one built around a forward structure and able to deliver a few hundreds of Watt and switched off in standby mode; the second one
    Original PDF
    l6565
    L6565 QUASI-RESONANT SMPS CONTROLLER QUASI-RESONANT (QR) ZERO-VOLTAGESWITCHING (ZVS) TOPOLOGY ■ LINE FEED FORWARD TO DELIVER CONSTANT POWER vs. MAINS CHANGE ■ FREQUENCY FOLDBACK FOR OPTIMUM STANDBY EFFICIENCY ■ PULSE-BY-PULSE & HICCUP-MODE OCP ■ ULTRA-LOW START-UP (< 70µA) AND
    Original PDF
    l6565
    L6565 QUASI-RESONANT SMPS CONTROLLER QUASI-RESONANT (QR) ZERO-VOLTAGESWITCHING (ZVS) TOPOLOGY ■ LINE FEED FORWARD TO DELIVER CONSTANT POWER vs. MAINS CHANGE ■ FREQUENCY FOLDBACK FOR OPTIMUM STANDBY EFFICIENCY ■ PULSE-BY-PULSE & HICCUP-MODE OCP ■ ULTRA-LOW START-UP (< 70µA) AND
    Original PDF
    an1686
    AN1686 APPLICATION NOTE AN L5991-BASED CONVERTER WITH TEMPORARY EXTRA POWER CAPABILITY by C. Adragna In some applications the SMPS, normally supposed to deliver a certain amount of power, from time to time undergoes load peaks that can be even two or more times as much. Such peaks are often too long
    Original PDF
    san2202
    sames SAN2202 APPLICATION NOTE SINGLE CHIP “SPEAKERPHONE” WITH 8 - OHM LOUDSPEAKER AMPLIFIER 1 Scope This application note describes a low-cost add-on circuit for driving an 8Ω-Loudspeaker to get a simple loudhearing (“Speakerphone”) Telephone. To possible ways of supplying the amplifier are shown:
    Original PDF
    pm9607ap
    Application Note: Energy Meter Evaluation Module sames PM9607AP INTRODUCTION meter configurations possible with the SA9607M using the PM9607AP module. Note that the values of the current transformer’s resistor values need to change to make some of the rated conditions possible. This will be covered in the
    Original PDF
    an-634
    AN-634 APPLICATION NOTE One Technology Way • P.O. Box 9106 • Norwood, MA 02062-9106, U.S.A. • Tel: 781.329.4700 • Fax: 781.461.3113 • www.analog.com Using the ADN2830 Evaluation Board by Dongfeng Zhao Because a laser emanates an optical average power when a
    Original PDF
    CHAPTER 1 Selector Guide http://onsemi.com 5
    CHAPTER 1 Selector Guide http://onsemi.com 5 http://onsemi.com 6 Small–Signal Bipolar Transistors, JFETs, and Diodes In Brief… Page Bipolar Transistors General–Purpose Transistors… 8 General–Purpose Multiple Transistors… 11
    Original PDF
    CHAPTER 1 Selector Guide http://onsemi.com 5
    CHAPTER 1 Selector Guide http://onsemi.com 5 Small–Signal Bipolar Transistors, JFETs, and Diodes In Brief… Page Bipolar Transistors General–Purpose Transistors… 8 General–Purpose Multiple Transistors… 11
    Original PDF
    an2101
    Preliminary AN2101  Austria Mikro Systeme International AG Application Note AN2101: Evaluation Board:DB2101 AS2520/21/B Telephone Speech Circuit with Loudhearing and Handsfree 1. Scope This application note describes applications for the AS2520 / 21 / 20B / 21B speech circuits with
    Original PDF
    A5974D Up to 2.5 A step down switching regulator
    A5974D Up to 2.5 A step down switching regulator for automotive applications Features ■ Qualified following the AEC-Q100 requirements (see PPAP for more details) ■ 2.5 A DC output current ■ Operating input voltage from 4 V to 36 V ■ 3.3 V / (±2%) reference voltage
    Original PDF
    as2523
    austriamicrosystems Telephone Line Interface and Speakerphone Circuit AS2523, AS2524 Key Features - Line/Speakerphone circuit on a 28-pin CMOS-IC, simplified inventory: same die for AS2523 and AS2524 Serial I/F on AS2523, parallel I/F on AS2524 Enhanced voice switching
    Original PDF
    as2523
    austriamicrosystems Telephone Line Interface and Speakerphone Circuit AS2523, AS2524 Key Features - Line/Speakerphone circuit on a 28-pin CMOS-IC, simplified inventory: same die for AS2523 and AS2524 Serial I/F on AS2523, parallel I/F on AS2524 Enhanced voice switching
    Original PDF
    austriamicrosystems Telephone Line Interface and
    austriamicrosystems Telephone Line Interface and Speakerphone Circuit AS2523, AS2524 Key Features - Line/Speakerphone circuit on a 28-pin CMOS-IC, simplified inventory: same die for AS2523 and AS2524 Serial I/F on AS2523, parallel I/F on AS2524 Enhanced voice switching
    Original PDF
    ncp3102
    DN06035/D DN06035/D 5 V to 1.5 V/10 A Integrated Buck Switching Regulator Device Application Input Voltage NCP3102 DC/DC converter 5V Output Power 15 W Topology I/O Isolation Buck NONE Other Specifications Output Voltage Oscillator Frequency Nominal Current
    Original PDF