APPLICATION OF PROGRAMMABLE VARIABLE RESISTOR Search Results

state variable filter

Abstract: Active Filters variable state filter TAN15 AN15 Analog Solutions Analog Devices Active Filter Design low-pass Passive filter design Passive Low-pass Filter Introduction
Contextual Info: TRAC Application Note AN15 Issue 1 September 1998 State Variable Filter Utilising TRAC Kambiz Pourhady The TRAC family of Totally Reconfigurable Field Programmable Analog Devices offer an integrated path from signal processing problems to working silicon solutions - in minutes!

MAX5494ETE

Abstract: MAX5495ETE MAX5494 MAX5495 MAX5496 MAX5498 MAX5499
Contextual Info: 19-3562; Rev 1; 6/05 10-Bit, Dual, Nonvolatile, Linear-Taper Digital Potentiometers ♦ 35ppm/°C End-to-End Resistance Temperature Coefficient ♦ 5ppm/°C Ratiometric Temperature Coefficient ♦ 10kΩ and 50kΩ End-to-End Resistor Values ♦ 3-Wire SPI-Compatible Serial Interface

MAX5494ETE

Abstract: MAX5494 MAX5495 MAX5495ETE MAX5496 MAX5498 MAX5499
Contextual Info: 19-3562; Rev 2; 1/06 10-Bit, Dual, Nonvolatile, Linear-Taper Digital Potentiometers ♦ 35ppm/°C End-to-End Resistance Temperature Coefficient ♦ 5ppm/°C Ratiometric Temperature Coefficient ♦ 10kΩ and 50kΩ End-to-End Resistor Values ♦ 3-Wire SPI-Compatible Serial Interface

MAX5494ETE

Contextual Info: 19-3562; Rev 0; 1/05 10-Bit, Dual, Nonvolatile, Linear-Taper Digital Potentiometers ♦ 35ppm/°C End-to-End Resistance Temperature Coefficient ♦ 5ppm/°C Ratiometric Temperature Coefficient ♦ 10kΩ and 50kΩ End-to-End Resistor Values ♦ 3-Wire SPI-Compatible Serial Interface

variable resistor connection

Abstract: 555-timer ad8402 filter application of programmable variable resistor 8251 microcontroller free 555 IC virtual timer pin configuration 100 K variable resistor Sheingold variable resistor AD8402
Contextual Info: Design Circuits with Digitally Controllable Variable Resistors AD8402/3 dual/quad digital pots set resistance values and ratios remotely by Walt Heinzer H ere is the first viable cost-effective substitute for trim m ers and potentiom eters in new designs. T his new IC family offers digital

L2 SOT23-6

Abstract: sb sot23-6 sot23 mark TB SOT23-6 L2 sd sot23 Programmable Voltage mark mo sc70 CAT5120TBI-10GT3
Contextual Info: CAT5120, CAT5121, CAT5122 16-Tap MiniPot Digitally Programmable Potentiometers with 2-Wire Interface Features DEscription • 0.3µA Ultra-low supply current ■ Single-supply operation: 2.7V to 5.5V ■ Glitchless switching between resistor taps ■ Power-on reset to midscale

TC5043P

Abstract: pin configuration 5K variable resistor TC5043P equivalent 600t osc diode zener ZD 103
Contextual Info: TC5043P TC5043P C2MOS DIGITAL INTEGRATED CIRCUIT SILICON MONOLITHIC PROGRAMMABLE CR TIMER/DIVIDER TC5043P is an timer consisting of CR oscillation circuit and frequency division circuit. The oscillation circuit is made up by externally installing one resistor and one capacitor, being able

sot23-6 marking code

Abstract: Sot23-6 marking tp sot23-6 sot23-6 marking code CU Programmable Voltage mark mo sc70 sot23 mark TB sot23-6 marking code 5B SOT23-6 MARKING 5b
Contextual Info: CAT5110, CAT5118, CAT5119 CAT5123, CAT5124, CAT5125 32-Tap MiniPot Digitally Programmable Potentiometers with 2-Wire Interface Features DEscription • 0.3µA Ultra-low standby current ■ Single-supply operation: 2.7V to 5.5V ■ Glitchless switching between resistor taps

Voice Activated Switch

Abstract: "Active Filters" LM4250 LM124 LM146 LM146J LM148 LM246J LM346M
Contextual Info: LM146/LM246/LM346 Programmable Quad Operational Amplifiers General Description Features The LM146 series of quad op amps consists of four independent, high gain, internally compensated, low power, programmable amplifiers. Two external resistors RSET allow

AN-254

Abstract: OP-61
Contextual Info: ANALOG ► DEVICES AN-254 APPLICATION NOTE ONE TECHNOLOGY WAY • P.O. BOX 9106 • NORWOOD, MASSACHUSETTS 02062-9106 • 617/329-4700 Add Programmable Gain, Attenuation by James Wong y adding two resistors to the output-amp feedback loop of a current-output digitalto-analog converter DAC ,

linear potentiometer

Abstract: variable resistor 224 9632 transistor 10k pot variable resistor 50K Linear Taper Potentiometer pin configuration 10K variable resistor code 6A analog devices potentiometer resistor 240 MAX5403 MAX5404
Contextual Info: 19-1934; Rev 0; 1/01 Dual 256-Tap, Low-Drift, Digital Potentiometers in 10-µMAX The MAX5403/MAX5404/MAX5405 is a family of dual linear taper digital potentiometers. Each device has one 3-terminal potentiometer and one 2-terminal variable resistor Figure 1 . The MAX5403/MAX5404/MAX5405

linear potentiometer

Abstract: code 6A analog devices potentiometer "Current to Voltage Converter" 10k pot resistor 10 uMAX 50K 6 pin potentiometer
Contextual Info: 19-1934; Rev 2; 11/05 Dual 256-Tap, Low-Drift, Digital Potentiometers in 10-µMAX The MAX5403/MAX5404/MAX5405 is a family of dual linear taper digital potentiometers. Each device has one 3-terminal potentiometer and one 2-terminal variable resistor Figure 1 . The MAX5403/MAX5404/MAX5405

tp sot23-6

Abstract: L2 SOT23 SOT23 JEDEC standard SOT23-5 VH CA SOT23-5 SOT23-5 MARKING 5B marking tp sot23-6 jedec sot23 SB SOT-23-6 SOT236
Contextual Info: CAT5110, CAT5118, CAT5119 CAT5123, CAT5124, CAT5125 32-Tap MiniPot Digitally Programmable Potentiometers with 2-Wire Interface Features DEscription • 0.3µA Ultra-low standby current ■ Single-supply operation: 2.7V to 5.5V ■ Glitchless switching between resistor taps

Voice Activated Switch

Abstract: LM4250 LM124 LM146 LM146J LM148 LM346M LM346MX state variable filter lm346
Contextual Info: LM146/LM346 Programmable Quad Operational Amplifiers General Description Features The LM146 series of quad op amps consists of four independent, high gain, internally compensated, low power, programmable amplifiers. Two external resistors RSET allow the user to program the gain bandwidth product, slew rate,

CA324A

Abstract: AD7519 AD7S12 AD7528 state variable filter AD644 828n oac oscillator programmable Sine Wave Generator ADS44
Contextual Info: ANALOG DEVICES AN-318 APPLICATION NOTE ONE TECHNOLOGY WAY • P.O. BOX 9106 • NORWOOD, MASSACHUSETTS 02062-9106 • 617/329-4700 AD7528 Dual 8-Bit CMOS DAC Application Note by Paul Toomey and Bill Hunt INTRODUCTION The AD7528 is a monolithic dual 8 -bit CMOS DAC pack­

SOT23 JEDEC standard orientation

Abstract: SOT23-6 L2 L2 SOT23-6 TC* SOT23-6
Contextual Info: CAT5110, CAT5118, CAT5119, CAT5123, CAT5124, CAT5125 32-Tap Digitally Programmable Potentiometers with 2-Wire Interface Description CAT5110/18/19/23/24/25 linear−taper digitally programmable potentiometers perform the same function as a mechanical potentiometer or a variable resistor. These devices consist of a fixed

LM346N

Contextual Info: LM146/LM346 Programmable Quad Operational Amplifiers General Description Features The LM146 series of quad op amps consists of four independent, high gain, internally compensated, low power, programmable amplifiers. Two external resistors RSET allow the user to program the gain bandwidth product, slew rate,

sot23-6 marking code

Abstract: SOT23 JEDEC standard SOT23-5 VH TOP marking sot23-6 L2 SOT23 A1 SOT23 SOT23-6 sot23 mark E coding SOT23-5 MARKING 5B sot-23-5 marking code
Contextual Info: CAT5110, CAT5118, CAT5119 CAT5123, CAT5124, CAT5125 32-Tap MiniPot Digitally Programmable Potentiometers with 2-Wire Interface FEATURES DESCRIPTION 0.3µA Ultra-low standby current Single-supply operation: 2.7V to 5.5V Glitchless switching between resistor taps

Contextual Info: CAT5110, CAT5118, CAT5119 CAT5123, CAT5124, CAT5125 32-Tap MiniPot Digitally Programmable Potentiometers with 2-Wire Interface Features DEscription • 0.3µA Ultra-low standby current ■ Single-supply operation: 2.7V to 5.5V ■ Glitchless switching between resistor taps

CAT32

Abstract: CAT5113 CAT5114 CAT5115 CAT5116 potentiometer resolution define
Contextual Info: AND8412/D Former Catalyst Document Number AB6 DPP to Control LED Brightness Prepared by: Fabien Franc http://onsemi.com ON Semiconductor digitally programmable potentiometer is connected as a 2−terminal variable resistor, as shown in Figure 1. The potentiometer Wiper−to−Low resistor between W and L

GPES215B

Contextual Info: GPES215B Easy-to-use SOUNDPLUS Jan. 05, 2009 Version 1.1 GENERALPLUS TECHNOLOGY INC. reserves the right to change this documentation without prior notice. TECHNOLOGY INC. is believed to be accurate and reliable. Information provided by GENERALPLUS However, GENERALPLUS TECHNOLOGY INC. makes no warranty for any errors which may

GPES212B

Contextual Info: GPES212B Easy-to-use SOUNDPLUS Jan. 05, 2009 Version 1.1 GENERALPLUS TECHNOLOGY INC. reserves the right to change this documentation without prior notice. TECHNOLOGY INC. is believed to be accurate and reliable. Information provided by GENERALPLUS However, GENERALPLUS TECHNOLOGY INC. makes no warranty for any errors which may

20K potentiometer

Abstract: bridged t filter y12 t 134 47K variable resistor AN134 LT1007 LT1097 T1097 X9418 X9C103
Contextual Info: Programmable Tee Networks Application Note May 5, 2005 AN134.0 Author: Chuck Wojslaw The objective of this application note is to 1 illustrate the idea of using digitally controlled potentiometers to form tee networks and (2) provide the design engineer with reference

simplest 3 pin IR receiver

Abstract: GPES203B circuit diagram for simple IR transmitter receiver
Contextual Info: GPES203B Easy-to-use SOUNDPLUS Jan. 05, 2009 Version 1.1 GENERALPLUS TECHNOLOGY INC. reserves the right to change this documentation without prior notice. TECHNOLOGY INC. is believed to be accurate and reliable. Information provided by GENERALPLUS However, GENERALPLUS TECHNOLOGY INC. makes no warranty for any errors which may