AABS Search Results

radiant energy

Abstract: photodiode lumen
Contextual Info: Glossary GLOSSARY - AABSOLUTE MAXIMUM RATINGS Absolute maximum ratings are those limiting values of operating and environmental conditions which should not be exceeded for any device of a specified type, as defined by its published data. ACCEPTANCE ANGLE The maximum angle which a ray

Contextual Info: 47E j> m aaBSbüs 0 0 3 m 2 5 b » s i e g SIEM EN S SI E M EN S A K T I E N G E S E L L S C H A F AM Receiver for AM Stereo TDA 4010 Preliminary Data Bipolar IC Features • • • • • • Internal demodulation Search tuning stop signal Low total harmonic distortion

Contextual Info: pu TAI WAN L I T O N E L E C T R O N I C 4 ^ E ]> aaBsb^s a o o B a f l fl t t T b t l i t LITEMïl FEATURES • 0 .2 & 0.3 IN C H 5 .0 8 m m /7 .6 m m H E IG H T C H A R ­ A C T E R R E D C O LO R . • C O M M O N C A T H O D E , M U L T IP L E X P IN O U T A R E

400L

Contextual Info: Filename: tfs 400l.doc Version 1.2 VI TELEFILTER 08.02.2006 Filter specification TFS 400L 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: Input: Output: 23 °C dBm 200 Ω 200 Ω Characteristics Remark: The reference level for the absolute attenuation aabs of the TFS 400L is the attenuation at nominal frequency. This value is defined as the insertion loss

diode sv 03

Abstract: po83 BUZ18 C67078-A1601-A2 145 diode BUZ18 Siemens
Contextual Info: ûflD » • aaBSbQS 0014412 T « S I E Û 88D 14492 D BUZ 18 SIEMENS AKTIENGESELLSCHAF - — N-Channel Main ratings Drain-source voltage Continuous drain current Drain-source on-resistance Description Case / d = 50 V = 37 A ^ D S o n a 0,03 a

2SC4445

Contextual Info: JMnic Product Specification 2SC4445 Silicon NPN Power Transistors DESCRIPTION ・With TO-3PML package ・High voltage. ・High speed switching APPLICATIONS ・For switching regulator and general purpose applications PINNING PIN DESCRIPTION 1 Base 2 Collector

LX8213-00ISE

Abstract: SOT 23 MOSFET 5-PIN MARKING AK LX8213-12ISE LX8213-33ISE LDO MARKING
Contextual Info: PRODUCTION DATASHEET 300mA Low Noise CMOS LDO Regulator TM DESCRIPTION KEY FEATURES The LX8213 also exhibits low output noise with only 60uVRMS over a 100kHz bandwidth. Power supply rejection exceeds 65dB at 100Hz. Other features of LX8213 include an active low shutdown input with a 3MΩ

fn521

Abstract: 24C164 Q67100-H3232 Q67100-H3500 Q67100-H3501 Q67100-H3505 Q67100-H3506
Contextual Info: Û235b05 OCHÖTIÖ 553 S IE M E N S 16 K bit 2048 x 8 bit Serial C M O S E E P R O M s, I 2C S yn ch ro no u s 2-W ire Bus S L x 24C 164 Preliminary Features > Data EEPROM internally organized as 2048 bytes and 128 pages x 16 bytes • Low power CMOS • Vcc = 2.7 to 5.5 V operation

MAX6365

Abstract: MAX6366 MAX6367 MAX6368 MAX6367PKA44 aabp marking code aaaM AABW marking code AABJ
Contextual Info: 19-1658; Rev 4; 5/09 SOT23, Low-Power µP Supervisory Circuits with Battery Backup and Chip-Enable Gating Features The MAX6365–MAX6368 supervisory circuits simplify power-supply monitoring, battery-backup control functions, and memory write protection in microprocessor

BFT65

Abstract: transistor bft65 f451 61 SIEMENS 25813
Contextual Info: SIEMENS BFT 65 NPN Silicon RF Transistor • For low-distortion broadband amplifiers up to 1 GHz at collector currents from 10 mA to 30 mA. ESD: Electrostatic discharge sensitive device, observe handling precautions! Type BFT 65 Marking BFT 65 Pin Configuration

Contextual Info: Filename: tfs 1370.doc Version 1.2 Vectron International 07.01.2014 Filter specification TFS 1370 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: Input: Output: 23 °C dBm 50 50 Ω Ω Characteristics Remark: The maximum attenuation in the pass band is defined as the insertion loss ae. The nominal frequency fN is fixed at 1370 MHz without any tolerance or limit.

Contextual Info: Filename: TFS482.doc Version 2.0 Vectron International 07.05.2014 Filter specification TFS 482 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: Input: Output: 23 °C dBm 50 50 Ω Ω Characteristics Remark: The maximum attenuation within passband 1 is defined as the insertion loss ae. The nominal frequency fN is fixed at 482 MHz without any tolerance or limit.

Contextual Info: Filename: tfs 1188.doc Version 2.0 VI TELEFILTER 26.07.2009 Filter specification TFS 1188 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: Input: Output: 23 °C dBm 50 50 Ω Ω Characteristics Remark: The maximum attenuation in the pass band is defined as the insertion loss ae. The nominal frequency fN is fixed at 1188,8 MHz without any tolerance or

Contextual Info: Filename: tfs 1204a.doc Version 2.0 VI TELEFILTER 26.07.2009 Filter specification TFS 1204A 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: Input: Output: 23 °C dBm 50 50 Ω Ω Characteristics Remark: The maximum attenuation in the pass band is defined as the insertion loss ae. The nominal frequency fN is fixed at 1204,53 MHz without any tolerance or

Contextual Info: Filename: tfs 1575t.doc Version 2.0 Vectron International 15.06.2009 Filter specification TFS 1575T 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: * Input: Output: 23 °C dBm 50 Ω | 0 pF 50 Ω | 0 pF Characteristics

Contextual Info: Filename: tfs 1068a.doc Version 3.0 Vectron International 18.03.2011 Filter specification TFS 1068A 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: Input: Output: 23 °C dBm 50 50 Ω Ω Characteristics Remark: The maximum attenuation in the pass band is defined as the insertion loss ae. The nominal frequency fN is fixed at 1068 MHz without any tolerance or limit.

Contextual Info: Filename: tfs 1238.doc Version 1.3 Vectron International 18.04.2014 Filter specification TFS 1238 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: Input: Output: 23 °C dBm 49 Ω | -1.4 pF 49 Ω | -1.4 pF Characteristics

Contextual Info: Filename: tfs 1575ag.doc Version 1.1 Vectron International 28.01.2014 Filter specification TFS 1575AG 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: Input: Output: 23 °C dBm 50 50 Ω Ω Characteristics Remark: The maximum attenuation in the pass band is defined as the insertion loss ae. The nominal frequency fN is fixed at 1575MHz without any tolerance or limit.

Contextual Info: Filename: tfs 1227.doc Version 1.2 VI TELEFILTER 6.7.2009 Filter specification TFS 1227 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: Input: Output: 23 °C dBm 50 50 Ω Ω Characteristics Remark: The maximum attenuation in the pass band is defined as the insertion loss ae. The nominal frequency fN is fixed at 1227,6 MHz without any tolerance or

Contextual Info: Filename: tfs 1960.doc Version 2.2 Vectron International 11.12.2013 Filter specification TFS 1960 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: Input: Output: 23 °C dBm 50 50 Ω Ω Characteristics Remark: The maximum attenuation in the pass band is defined as the insertion loss ae. The nominal frequency fN is fixed at 1960 MHz without any tolerance or limit.

Contextual Info: Filename: tfs 1255.doc Version 1.2 Vectron International 07.01.2014 Filter specification TFS 1255 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: Input: Output: 23 °C dBm 50 50 Ω Ω Characteristics Remark: The maximum attenuation in the pass band is defined as the insertion loss ae. The nominal frequency fN is fixed at 1255.0 MHz without any tolerance or limit.

Contextual Info: Filename: tfs 1040.doc Version 2.0 Vectron International 29.05.2012 Filter specification TFS 1040 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: Input: Output: 23 °C dBm 50 Ω 50 Ω Characteristics Remark: The nominal frequency fN is fixed at 1040 MHz. The insertion loss ae is defined as loss value determined at fN. All specified data are met within the

rx1 1240

Contextual Info: Filename: tdx 1176.doc Version 2.0 VI TELEFILTER 26.07.2009 Filter specification TDX 1176 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: * source: load: 23 °C dBm 50 Ohm 50 Ohm Characteristics Remark: The maximum attenuation in the pass bands is defined as the insertion loss ae. The nominal frequency fNRX1 is fixed at 1176,45 MHz and the nominal

TFS1643A

Contextual Info: Filename: TFS1643A.doc Version 4.0 Vectron International 09.12.2011 Filter specification TFS 1643A 1/5 Measurement condition Ambient temperature: Input power level: Terminating impedance: Input: Output: 23 °C dBm 50 50 Ω Ω Characteristics Remark: The maximum attenuation in the passband is defined as the insertion loss ae. The nominal frequency fN is fixed at 1643,5 MHz without any tolerance or limit.