E5052A Search Results

VDUGLD-51M840

Abstract: E5052A 19M440 24M704
Contextual Info: Application Note V-Type, CMOS VCXO Typical Phase Noise Measurements Phase Noise Results Phase noise measurements were performed on an Agilent E5052A signal source analyzer SSA . The E5052A has a phase noise to jitter integration calculation feature and devices were characterized in the

vectron

Abstract: E5052A VTC4-B22E-12M800 vtc4
Contextual Info: Application Note VTC4, Clipped Sine Wave TCXO Typical Phase Noise Measurements Phase Noise Results Phase noise measurements were performed on an Agilent E5052A signal source analyzer SSA . The E5052A has a phase noise to jitter integration calculation feature and devices were characterized in the

Agilent E5052 settling time

Abstract: E5052A E5001A 801 floppy n5507a E5053A E5052A-011 N5507
Contextual Info: Agilent E5052A Signal Source Analyzer 10 MHz to 7, 26.5, or 110 GHz Data Sheet Definitions All specifications apply over a 18 °C to 28 °C range unless otherwise stated and 30 minutes after the instrument has been turned on. All specified and supplemental values for RF input signals are

FSUP26

Contextual Info: reference phase locked translator connectorized MODEL: KFcts800-10 800 MHz fixed frequency FEATURES: ► Ultra-Low Phase Noise ► No Programming Required Phase Noise Measured with Agilent E5052A or R&S FSUP-26/27 -60 -70 Phase Noise (dBc/Hz) -80 -90 -100

E5052A

Abstract: 3 phase soft start Z-Communications IS-136 AN-109 fixture
Contextual Info: VCO Application Note AN-109 Phase Noise Measurement of Z-Communications VCOs Phase noise of ZCOMM VCOs free running can be measured at different offsets, using the test set up and procedure below. Figure AN-109:1- VCO Phase Noise Measurement Setup Procedure using Agilent Technologies E5052A Signal Source Analyzer

FCTS1000-10

Contextual Info: reference phase locked translator surface mount MODEL: Fcts800-10 800 MHz fixed frequency FEATURES: ► Ultra-Low Phase Noise ► No Programming Required Phase Noise Measured with Agilent E5052A or R&S FSUP-26/27 -60 -70 Phase Noise (dBc/Hz) -80 -90 -100

C0413

Abstract: FSUP26 FCTS1000-10
Contextual Info: reference phase locked translator connectorized MODEL: KFcts1000-10 1000 MHz fixed frequency FEATURES: ► Ultra-Low Phase Noise ► No Programming Required Phase Noise Measured with Agilent E5052A or R&S FSUP-26/27 -70 -80 Phase Noise (dBc/Hz) -90 -100

FCTS1000-10

Contextual Info: reference phase locked translator surface mount MODEL: Fcts1000-10 1000 MHz fixed frequency FEATURES: ► Ultra-Low Phase Noise ► No Programming Required Phase Noise Measured with Agilent E5052A or R&S FSUP-26/27 -70 -80 Phase Noise (dBc/Hz) -90 -100

VC-800-LAF-GTJ-19M440

Abstract: VCXO vectron E5052A VC-800 27M000 VC-800-LAF-GTJ-32M768 VECTRON
Contextual Info: Application Note VC-800, CMOS VCXO Typical Phase Noise Measurements Phase Noise Results Phase noise measurements were performed on an Agilent E5052A signal source analyzer SSA . The E5052A has a phase noise to jitter integration calculation feature and devices were characterized in the

VCC6-QAB-156M25

Abstract: VCC6-QCD-250M000 Vectron International E5052A vectron VCC6-QAB-155M52 VCC6-QCB-87M500 Noise VCC6-QAB-74M250 VCC6-QCD-250M00
Contextual Info: Application Note VCC6, LVPECL XO Typical Phase Noise Measurements Phase Noise Results Phase noise measurements were performed on an Agilent E5052A signal source analyzer SSA . The E5052A has a phase noise to jitter integration calculation feature and devices were characterized in the

NB6N11SMNG

Contextual Info: NB6N11S 3.3 V 1:2 AnyLevelE Input to LVDS Fanout Buffer / Translator Description The NB6N11S is a differential 1:2 Clock or Data Receiver and will accept AnyLevel input signals: LVPECL, CML, LVCMOS, LVTTL, or LVDS. These signals will be translated to LVDS and two identical

Contextual Info: CDCM7005 www.ti.com SCAS793B – JUNE 2005 – REVISED OCTOBER 2005 3.3-V HIGH PERFORMANCE CLOCK SYNCHRONIZER AND JITTER CLEANER GND GND GND GND GND GND C VBB GND AVCC AVCC AVCC AVCC AVCC GND STATUS_ REF or PRI_SEC_ CLK STATUS_ D VCXO_IN GND GND GND GND GND

ADF4350

Abstract: ADF4351 ADF4350BCPZ ADF4350BCPZ-RL7 SW 5189 C EVAL-ADF4350EB2Z ADSP-BF527 DB31 E5052A GSM900
Contextual Info: Wideband Synthesizer with Integrated VCO ADF4350 FEATURES GENERAL DESCRIPTION Output frequency range: 137.5 MHz to 4400 MHz Fractional-N synthesizer and integer-N synthesizer Low phase noise VCO Programmable divide-by-1/-2/-4/-8/-16 output Typical rms jitter: <0.4 ps rms

CF5076

Abstract: WF5076
Contextual Info: 5076 series VCXO Module IC with Built-in Varicap OVERVIEW The 5076 series are miniature VCXO ICs that provide a wide frequency pulling range, even when using miniature crystal units for which a wide pulling range is difficult to provide. They employ a recently developed varicap diode fabrication process that provides a wide frequency pulling range and good linearity without any

CDCM7005HFG-V

Abstract: smd y1a
Contextual Info: CDCM7005-SP www.ti.com . SGLS390A – JULY 2009 – REVISED AUGUST 2009 3.3-V HIGH PERFORMANCE RAD-TOLERANT CLASS V, CLOCK SYNCHRONIZER AND

Contextual Info: VV-701 Voltage Controlled Crystal Oscillator Previous Vectron Model VVC1/VVC2 VV-701 Description Vectron’s VV-701 Voltage Controlled Crystal Oscillator VCXO is a quartz stabilized square wave generator with a CMOS output. The VV-701 uses fundamental crystals resulting in low jitter performance and a monolithic IC which improves reliability and reduces cost.

OX36D-S-MR-R

Abstract: dox5 18M08 transistor z7m st z7m Bowei Integrated Circuits oxln50d TXM11 tt 2246 transistor K117
Contextual Info: ABOWEI n r r y /^ B i i ij Products BOWEI IN TEG RA TED C IR C U IT S C O .,LTD 2 0 0 7 .5 A bow ei BOWEI is one ofthe leading RF/microwave solution providers in China. With more than twenty years extensive experience, BOWEI has been engineering and manufacturing

QT228

Abstract: QPDS-0001 Qt101 QT194
Contextual Info: CLASS B+ PRODUCTS HIGH RELIABILITY HYBRID CRYSTAL CLOCK OSCILLATORS 2.5 to 5.0Vdc - 15kHz to 350MHz Q-TECH CORPORATION Features • Made in the USA • ECCN: EAR99 • DFARS 252-225-7014 Compliant: Electronic Component Exemption • Broad frequency range from 15kHz to 350MHz

Contextual Info: FLAT PACK CRYSTAL CLOCK OSCILLATORS -5.2 to -4.5Vdc & 1.8 to 15Vdc - 0.12Hz to 200MHz Q-TECH CORPORATION Description Q-Tech’s flat pack crystal oscillators consist of a source clock square wave generator, logic output buffers and/or logic divider stages, and a round AT highprecision quartz crystal built in an all metal flat

Contextual Info: QT89 SERIES Q-TECH CORPORATION HIGH-RELIABILITY MINIATURE CLOCK OSCILLATORS 1.8 to 5.0Vdc - 15kHz to 160MHz Description Q-Tech’s surface-mount QT89 oscillators consist of an IC 5Vdc, 3.3Vdc, 2.5Vdc, 1.8Vdc clock square wave generator and a round AT high-precision quartz crystal built in a rugged leaded

MCM SERIES Q-TECH OSCILLATOR

Contextual Info: LOW PROFILE QT84 MINIATURE SMD CRYSTAL OSCILLATORS 1.8 to 5.0Vdc - 500kHz to 160MHz Q-TECH CORPORATION Description Q-Tech’s surface mount 7 x 5 mm oscillator series consist of an IC 5Vdc, 3.3Vdc, 2.5Vdc, 1.8Vdc clock square wave generator and a miniature strip AT quartz crystal built in a

a5 gnd

Abstract: a5 gnd 700
Contextual Info: NB3V8312C Ultra-Low Jitter, Low Skew 1:12 LVCMOS/LVTTL Fanout Buffer The NB3V8312C is a high performance, low skew LVCMOS fanout buffer which can distribute 12 ultra−low jitter clocks from an LVCMOS/LVTTL input up to 250 MHz. The 12 LVCMOS output pins drive 50 W series or parallel

128 dual modulus prescaler 2ghz

Abstract: smd transistor code 43 B6 vco 6ghz 3700BL15B100 E5052A STW81102 STW81102AT STW81102ATR VFQFPN28
Contextual Info: STW81102 Multi-band RF frequency synthesizer with integrated VCOs Feature summary • Integer-N Frequency Synthesizer ■ Dual differential integrated VCOs with automatic center frequency calibration: – 3000 - 3620 MHz Direct output – 4000 - 4650 MHz (Direct output)

Contextual Info: 5076 series VCXO Module IC with Built-in Varicap OVERVIEW The 5076 series are miniature VCXO ICs that provide a wide frequency pulling range, even when using miniature crystal units for which a wide pulling range is difficult to provide. They employ a recently developed varicap diode fabrication process that provides a wide frequency pulling range and good linearity without any