909MHZ Search Results

murata SAW

Contextual Info: NSVS1237 Apr. 2013 NewJRC SAW FILTER NSVS1237 Application 909MHz ISM Lower Half-Band Electrical Specification: (Table 1) The device characteristics are measured in the circuit shown in Fig.1. Table 1. Electrical Specifications Item Spec. Typ. Input and Output Impedance

construction of varactor diode

Abstract: MA393 MC12147 MC12147D MC12147SD MC12202 Nippon capacitors
Contextual Info: Order this document by MC12147/D MC12147 Low Power Voltage Controlled Oscillator Buffer The MC12147 is intended for applications requiring high frequency signal generation up to 1300 MHz. An external tank circuit is used to determine the desired frequency of operation. The VCO is realized using an

Contextual Info: Freescale Semiconductor, Inc.Order this document by MC12149/D MC12149 Low Power Voltage Controlled Oscillator Buffer LOW POWER VOLTAGE CONTROLLED OSCILLATOR BUFFER SEMICONDUCTOR TECHNICAL DATA NOTE: The MC12149 is NOT suitable as a crystal oscillator. •

Contextual Info: ML12149 Low Power Voltage Controlled Oscillator Buffer Legacy Device: Motorola MC12149 The ML12149 is intended for applications requiring high frequency signal generation up to 1300 MHz. An external tank circuit is used to determine the desired frequency of operation. The VCO

colpitts oscillator construction for 150 KHz fr

Abstract: 150 KHz colpitts oscillator construction NT2800 NUMA Technologies JTX-4-10T colpitts oscillator construction FR4 1.6mm substrate for microstrip antenna radio frequency signals combiner divider 10 bit Controlled Oscillator CIRCUIT DIAGRAM
Contextual Info: C h ip -M itter - Single Chip FM Transmitter 130-1000 MHz NT2800 FEATURES • • • • • • • • • Wide Bandwidth FM Transmitter Suitable for FM/FSK Modulation Direct-Modulation Scheme On-Chip PLL Synthesizer/VCO 3-wire serial interface 2.7 - 3.3V Operation / Standby Mode

Contextual Info: CMX990 CML Microcircuits COMMUNICATION SEMICONDUCTORS GMSK Packet Data Modem and RF Transceiver D/990/6 April 2008 Provisional Issue Features • Single Chip RF Transceiver and GMSK Modem • 400MHz - 1GHz Radio Data Systems • IF, RF, Control and Synthesizer Stages

construction of varactor diode

Contextual Info: MC12147 Low Power Voltage Controlled Oscillator Buffer The MC12147 is intended for applications requiring high frequency signal generation up to 1300 MHz. An external tank circuit is used to determine the desired frequency of operation. The VCO is realized using an

construction of varactor diode

Abstract: MA393 varactor diode high frequency MC12147 MC12147D MC12202
Contextual Info: Order this document by MC12147/D MC12147 Low Power Voltage Controlled Oscillator Buffer The MC12147 is intended for applications requiring high frequency signal generation up to 1300 MHz. An external tank circuit is used to determine the desired frequency of operation. The VCO is realized using an

Contextual Info: ML12149 Low Power Voltage Controlled Oscillator Buffer Legacy Device: Motorola MC12149 The ML12149 is intended for applications requiring high frequency signal generation up to 1300 MHz. An external tank circuit is used to determine the desired frequency of operation. The VCO

construction of varactor diode

Abstract: varactor diode high frequency MA393 MC12147 MC12147D MC12202
Contextual Info: Freescale Semiconductor, Inc.Order this document by MC12147/D MC12147 Low Power Voltage Controlled Oscillator Buffer LOW POWER VOLTAGE CONTROLLED OSCILLATOR BUFFER SEMICONDUCTOR TECHNICAL DATA DEVICE TO BE PHASED OUT. ARCHIVE INFORMATION Freescale Semiconductor, Inc.

LF-U309D7

Abstract: GSM duplexer GPS LTE filter band 13 lte saw filter tx saw LTE 5760MHZ
Contextual Info: SAW Filter Modules SAW Filter Modules LF-U309D7 Features • Miniature size of 5.0x4.0x1.0mm • SP10T RF Switch, Duplexer BAND1, BAND5+18 GSM Rx BPF 3 Band, GSM Tx LPF Low/ High Band • UMTS1−3 Pin for Duplexer Applications • Frontend for 3G/ LTE Mobile Phone

construction of varactor diode

Contextual Info: M MOTOROLA I. « • - - - i- -■ M C12147 Low Pow er Voltage Controlled O scillator Buffer The MC12147 is intended for applications requiring high frequency signal generation up to 1300 MHz. An external tank circuit is used to determine the desired frequency of operation. The VCO is realized using an

mc12149

Contextual Info: Low Power Voltage Controlled Oscillator Buffer The MC12149 is intended for applications requiring high frequency signal generation up to 1300 MHz. An external tank circuit is used to determine the desired frequency of operation. The VCO is realized using an

k1 M 1208 Q switch

Abstract: mc12149 csr rf construction of varactor diode MA393 MC12149D MC12149SD MC12202 Nippon capacitors
Contextual Info: Order this document by MC12149/D Low Power Voltage Controlled Oscillator Buffer The MC12149 is intended for applications requiring high frequency signal generation up to 1300 MHz. An external tank circuit is used to determine the desired frequency of operation. The VCO is realized using an

Contextual Info: Freescale Semiconductor, Inc.Order this document by MC12147/D MC12147 Low Power Voltage Controlled Oscillator Buffer LOW POWER VOLTAGE CONTROLLED OSCILLATOR BUFFER SEMICONDUCTOR TECHNICAL DATA DEVICE TO BE PHASED OUT. ARCHIVE INFORMATION ARCHIVE INFORMATION

Nippon capacitors

Abstract: MC12149
Contextual Info: MOTOROLA SEMICONDUCTOR TECHNICAL DATA Low Power Voltage Controlled Oscillator Buffer The MC12149 is intended for applications requiring high frequency signal generation up to 1300MHz. An external tank circuit is used to determine the desired frequency of operation. The VCO is realized using

Contextual Info: MOTOROLA SEMICONDUCTOR TECHNICAL DATA Low Power Voltage Controlled Oscillator Buffer The MC12147 is intended for applications requiring high frequency signal generation up to 1300MHz. An external tank circuit is used to determine the desired frequency of operation. The VCO is realized using

Contextual Info: Filter Coils < Pin Type: HR Series> Type: HR-5W Product Description ･11.5x5.9mm Max. L×W , 9.0mm Max. Height. ・Reference operating frequency:859MHz ・In addition to the reference versions of parameters shown here, custom designs are available to meet your exact requirements.

ML12149-5P

Abstract: ML12210 MA393 MC12149 MC12149D ML12149 LT 725
Contextual Info: ML12149 Low Power Voltage Controlled Oscillator Buffer Legacy Device: Motorola MC12149 The ML12149 is intended for applications requiring high frequency signal generation up to 1300 MHz. An external tank circuit is used to determine the desired frequency of operation. The VCO

Qb 742

Abstract: MA393 MC12149 MC12149D MC12202
Contextual Info: Order this document by MC12149/D Low Power Voltage Controlled Oscillator Buffer The MC12149 is intended for applications requiring high frequency signal generation up to 1300 MHz. An external tank circuit is used to determine the desired frequency of operation. The VCO is realized using an

8a033

Contextual Info: SAW Duplexer SD20 Series Balanced Type Features How to Order SD 20 - 1950 R 9 UB Q1 • Small size • High attenuation • High Isolation • Rx Balanced Output Type ① ② ③ ④ ⑤ ⑥ ⑦ ① Type of Product (SAW Duplexer) ② Package Size ③ Nominal Center Frequency

859m

Abstract: helical filter
Contextual Info: Filter Coils < Pin Type: HR Series> Sample submission is forbidden Type: HR-5W Product Description ･11.5x5.9mm Max. L×W , 9.0mm Max. Height. ・Reference operating frequency:859MHz ・In addition to the reference versions of parameters shown here, custom designs are available to meet your exact requirements.

MA393

Abstract: MC12149 MC12149D MC12202 L2B LP LP
Contextual Info: Freescale Semiconductor, Inc.Order this document by MC12149/D MC12149 Low Power Voltage Controlled Oscillator Buffer LOW POWER VOLTAGE CONTROLLED OSCILLATOR BUFFER SEMICONDUCTOR TECHNICAL DATA NOTE: The MC12149 is NOT suitable as a crystal oscillator. •

construction of varactor diode

Abstract: MC12202 motorola varactor
Contextual Info: M M O T O R O L A M CI 2149 Low Pow er Voltage Controlled O scilla to r Buffer The MC12149 is intended for applications requiring high frequency signal generation up to 1300 MHz. An external tank circuit is used to determine the desired frequency of operation. The VCO is realized using an