8600A Search Results

Contextual Info: WaveMaster 8600A 8500A 8300A Oscilloscopes LEADING FEATURES • 6, 5 or 3 GHz bandwidth • 10 GS/s sample rate/channel • 20 GS/s dual channel mode • All-SiGe front end for high signal fidelity up to 75 ps rise time WaveMaster oscilloscopes are the only scopes that include an all SiGe front end, X-Stream technology;

VCC1

Abstract: VCC1-B3B E5052A VCC1-B3B-10M000 vcc1-b3d-65m536 8600A vectron xo 77m7 VCC1-B3B-51M840 VCC1-B3D-6
Contextual Info: Application Note VCC1, CMOS XO Typical Phase Noise and Jitter Measurements Jitter Results Jitter measurements were performed on a Lecroy Wavemaster 8600A oscilloscope. The measurements were recorded by testing the devices on an evaluation board with an AC coupled output. The evaluation

HMI Software SIMATIC ProTool

Abstract: TD200 display manual book PLC siemens S7-200 TP177B Wiring Diagram s7-200 siemens siemens simatic op17 siemens simatic op7 manual manual repair offline ups 600 va siemens simatic op7 Wiring Diagram s7-300 analog module
Contextual Info: Automation and Drives Human Machine Interface Postfach 4848 90327 NÜRNBERG Germany w w w. s i e m e n s .c o m/ a uto ma t i o n The information provided in this catalog contains descriptions or characteristics of performance which in case of actual use do not always apply as described

49FCT3805D

Abstract: oa1 transistor AN-236 IDT49FCT3805D AN 6754 8600A IDT49FCT3805 HP81 HP81130A
Contextual Info: APPLICATION NOTE AN-236 49FCT3805D JITTER PERFORMANCE APPLICATION NOTE AN-236 49FCT3805D JITTER PERFORMANCE SUMMARY The 49FCT3805D is composed of two banks, A and B. Each bank has five outputs and its own output enable control. The purpose of this test is to observe the jitter when different frequencies are

AP015

Abstract: HFP1500 HFP3500 CP015 HFP1000 AP031 DDA260 PT001 PK104 HFP2500
Contextual Info: ПРОБНИКИ АКТИВНЫЕ ДИФФЕРЕНЦИАЛЬНЫЕ ТОКОВЫЕ ВЫСОКОВОЛЬТНЫЕ ДИФФЕРЕНЦИАЛЬНЫЕ ВЫСОКОЧАСТОТНЫЕ Инженеры используют в своих разработках мно

EATON CM20A

Abstract: A5 GNE mosfet Hall sensor 44e 402 2N8491 FTG 1087 S TRIAC BCR 10km FEB3T smd transistor marking 352a sharp EIA 577 sharp color tv schematic diagram MP-130 M mh-ce 10268
Contextual Info: Table of Contents N E W A R K E L E C T R O N IC S “Where serving you begins even before you call” Newark Electronics is a UNIQUE broadline distributor of electronic components, dedicated to provid­ ing complete service, fast delivery and in-depth inventory. Our main

155m5200

Contextual Info: PS-702 Voltage Controlled SAW Oscillator Former Part Number SO-720 PS-702 Description The PS-702 is a SAW Based Clock Oscillator that achieves low phase noise and very low jitter performance. The PS-702 is housed in an industry standard 6-Pad leadless ceramic package that is hermetically sealed. Packaging options

Contextual Info: VS-720 Voltage Controlled SAW Oscillator VS-720 Voltage Controlled SAW Oscillator Features • Industry Standard Package, 5.0 x 7.5 x 2.0 mm • ASIC Technology For Ultra Low Jitter 0.100 ps-rms typical across 12 kHz to 20 MHz BW 0.120 ps-rms typical across 50 kHz to 80 MHz BW

702 N smd transistor

Abstract: 702 transistor smd 702 smd transistor 702 smd SMD tr 702 transistor 702 smd 155M520000 702 P transistor transistor 702 smd power GR-253-CORE
Contextual Info: PS-702 SAW Based Clock Oscillator Former Part Number SO-720 PS-702 Description The PS-702 is a SAW Based Clock Oscillator that achieves low phase noise and very low jitter performance. The PS-702 is housed in an industry standard 6-Pad leadless ceramic package that is hermetically sealed. Packaging options

gaa 704

Abstract: 901 704 16 08 55 GR-253-CORE OC192 OC48 SO-720 vectron xo
Contextual Info: SO-720 SAW Based Clock Oscillator Features • Industry Standard Package, 5.0 x 7.5 x 2.0 mm • ASIC Technology For Ultra Low Jitter 0.100 ps-rms typical across 12 kHz to 20 MHz BW 0.120 ps-rms typical across 50 kHz to 80 MHz BW • Output Frequencies from 150 MHz to 1 GHz

393 EZ 952

Abstract: AA59466-0017 PM1015
Contextual Info: NEW PRODUCTS * MICRO-SCALE TEST KIT Micro-scale Test Kit accessories are designed to attach to industry standard multimeter test probes or prods. These accessories allow convenient and safe testing on breadboards or printed circuit boards. KT-MS002 includes:

vamp

Abstract: E5052 vectron xo VC-709 VC-709-PCIE2-100M000000
Contextual Info: VC-709-PCIE2-100M000000 HCSL Crystal Oscillator Data Sheet VC-709 Description Vectron’s VC-709 Crystal Oscillator is a quartz stabilized, differential output oscillator, operating off a 2.5 or 3.3 volt supply in a hermetically sealed 5x7 ceramic package.

632-40

Abstract: Simulation Model tl 431 31949 34816
Contextual Info: VCC1 CMOS Crystal Oscillator VCC1 Description Vectron’s VCC1 Crystal Oscillator XO is a quartz stabilized square wave generator with a CMOS output. The VCC1 uses a fundamental or 3rd overtone crystal resulting in very low jitter performance, and a monolithic IC which improves reliability and reduces cost.

Contextual Info: VC-708 LVPECL, LVDS Crystal Oscillator Data Sheet Ultra Low Phase Noise VC-708 Description Vectron’s VC-708 Crystal Oscillator is a quartz stabilized, low phase noise, diferential output oscillator which is hermetically sealed in a 5x7 ceramic package. Features

Contextual Info: VX-700 Voltage Controlled Crystal Oscillator Previous Vectron Model VC-710 VX-700 Description The VX-700 is a Voltage Controlled Crystal Oscillator that operates at the fundamental frequency of the internal HFF crystal. The HFF crystal is a high-Q quartz device that enables the circuit to achieve low phase jitter performance over a wide operating

Contextual Info: VC-708 LVPECL, LVDS Crystal Oscillator Data Sheet Ultra Low Phase Noise VC-708 Description Vectron’s VC-708 Crystal Oscillator is a quartz stabilized, low phase noise, differential output oscillator which is hermetically sealed in a 5x7 ceramic package.

motor torque

Abstract: APT0502
Contextual Info: APTGT580U60D4G Single switch Trench + Field Stop IGBT Power Module VCES = 600V IC = 600A @ Tc = 80°C Application • Welding converters • Switched Mode Power Supplies • Uninterruptible Power Supplies • Motor control 1 3 Features • Trench + Field Stop IGBT Technology

VC-709

Contextual Info: VC-709 HCSL, LVDS, LVPECL Crystal Oscillator Data Sheet VC-709 Description Vectron’s VC-709 Crystal Oscillator is a quartz stabilized, differential output oscillator, operating off a 2.5 or 3.3 volt supply in a hermetically sealed 5x7 ceramic package. Features

Contextual Info: VS-702 Voltage Controlled SAW Oscillator Previous Vectron Model VS-720 VS-702 Description The VS-702 is a SAW Based Voltage Controlled Oscillator that achieves low phase noise and very low jitter performance. The VS702 is housed in an industry standard hermetically sealed LCC package and available in tape and reel.

Contextual Info: WESTCODE An Date:- 14th Dec, 2009 Data Sheet Issue:- 1 IXYS Company Provisional Data Rectifier Diode Types W3082MC420 to W3082MC450 Old part number Wx253MC420-450 Absolute Maximum Ratings VOLTAGE RATINGS MAXIMUM LIMITS UNITS VRRM Repetitive peak reverse voltage, note 1

VX-700

Abstract: VX700
Contextual Info: VX-700 Voltage Controlled Crystal Oscillator Previous Vectron Model VC-710 VX-700 Description The VX-700 is a Voltage Controlled Crystal Oscillator that operates at the fundamental frequency of the internal HFF crystal. The HFF crystal is a high-Q quartz device that enables the circuit to achieve low phase jitter performance over a wide operating

Contextual Info: VX-700 Voltage Controlled Crystal Oscillator Previous Vectron Model VC-710 VX-700 Description The VX-700 is a Voltage Controlled Crystal Oscillator that operates at the fundamental frequency of the internal HFF crystal. The HFF crystal is a high-Q quartz device that enables the circuit to achieve low phase jitter performance over a wide operating

xxmx

Abstract: xxmxx VCC1-B3B-125M000 12K-20MHz 245454
Contextual Info: VCC1 CMOS Crystal Oscillator VCC1 Description Vectron’s VCC1 Crystal Oscillator XO is a quartz stabilized square wave generator with a CMOS output. The VCC1 uses fundamental or 3rd overtone crystals resulting in very low jitter performance, and a monolithic IC which improves reliability and reduces cost.

Contextual Info: VS-720 Voltage Controlled SAW Oscillator PRELIMINARY DATASHEET VS-720 Voltage Controlled SAW Oscillator Features • Industry Standard Package, 5.0 x 7.5 x 2.0 mm • ASIC Technology For Ultra Low Jitter 0.100 ps-rms typical across 12 kHz to 20 MHz BW 0.120 ps-rms typical across 50 kHz to 80 MHz BW