Part Number
    Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    30NOV200 Search Results

    Documents mentioning 30NOV200

    Document Partial File Text Tags Type PDF
    THIS DRAWING IS COPYRIGHT UNPUBLISHED. 2000
    THIS DRAWING IS COPYRIGHT UNPUBLISHED. 2000 RELEASED BY TYCO ELECTRONICS CORPORATION FOR ALL 2 000 PUBLICATION RIGHTS LOC REV ISIONS D I ST RESERVED. LTR DESCRIPTION DATE RELEASED F-J00 - 1 8 6 5 - 0 0 DWN 30NOV2000 APVD T. H ,S . I5 : A S S HOWN l i v £
    OCR Scan PDF
    f25nm60n
    STB25NM60Nx - STF25NM60N STP25NM60N - STW25NM60N N-channel 600 V, 0.130 Ω , 21 A, MDmesh™ II Power MOSFET TO-220, TO-220FP, I2PAK, D2PAK, TO-247 Features RDS(on) max VDSS (@Tjmax) Type ID 3 3 ) s ( t c u d o ) r s ( P t c e t u e d l o o r s P b e O Application
    Original PDF
    m34c02
    M34C02 2 Kbit Serial I²C Bus EEPROM For DIMM Serial Presence Detect FEATURES SUMMARY ■ Software Data Protection for lower 128 Bytes Two Wire I2C Serial Interface 100kHz and 400kHz Transfer Rates Single Supply Voltage:
    Original PDF
    sprs507f
    OMAP3530/25 Applications Processor www.ti.com SPRS507F – FEBRUARY 2008 – REVISED OCTOBER 2009 1 OMAP3530/25 Applications Processor 1.1 Features • OMAP3530/25 Applications Processor: – OMAP™ 3 Architecture – MPU Subsystem • Up to 720-MHz ARM Cortex™-A8 Core
    Original PDF
    ld1117
    LD1117xx Low drop fixed and adjustable positive voltage regulators Features ■ Low dropout voltage (1 V typ.) ■ 2.85 V device performances are suitable for SCSI-2 active termination ■ Output current up to 800 mA ■ Fixed output voltage of: 1.2 V, 1.8 V, 2.5 V,
    Original PDF
    an2049
    AN2049 Application note Demonstration board user guidelines for the TS4984 low voltage audio power stereo amplifier Introduction This application note applies to the STEVAL-CC003V1 demonstration board, designed to evaluate the low-voltage audio power stereo amplifier TS4984.
    Original PDF
    LM2902 Low-power quad operational amplifier
    LM2902 Low-power quad operational amplifier Features ■ Wide gain bandwidth: 1.3 MHz ■ Input common-mode voltage range includes negative rail ■ Large voltage gain: 100 dB ■ Very low supply current per amplifier: 375 µA ■ Low input bias current: 20 nA
    Original PDF
    501-5841 Qualification Test Report 認定試験報告書 1.
    501-5841 Qualification Test Report 認定試験報告書 1. はじめに 1.1 目 的 18MAY07 Rev. A 本試験は、HDMI コネクタ の、設計目標書 108-78180-2 Rev.A2 に規定された性能必要条件に合致しているか確認す るために行われた。
    Original PDF
      IMPORTANT NOTICE  Dear customer,  As from
      IMPORTANT NOTICE  Dear customer,  As from February 2nd 2009, ST and Ericsson have merged Ericsson Mobile  Platforms and ST‐NXP Wireless into a 50/50 joint venture "ST‐Ericsson".  As a result, the following changes are applicable to the attached 
    Original PDF
    lf147
    LF147/LF347 Wide Bandwidth Quad JFET Input Operational Amplifiers General Description Features The LF147 is a low cost, high speed quad JFET input operational amplifier with an internally trimmed input offset voltage (BI-FET II™ technology). The device requires a low supply
    Original PDF
    LM124/LM224/LM324/LM2902 Low Power Quad
    LM124/LM224/LM324/LM2902 Low Power Quad Operational Amplifiers General Description Advantages The LM124 series consists of four independent, high gain, internally frequency compensated operational amplifiers which were designed specifically to operate from a single
    Original PDF
    CLC449 1.1GHz Ultra Wideband Monolithic Op Amp
    CLC449 1.1GHz Ultra Wideband Monolithic Op Amp General Description Features The CLC449 is an ultra high speed monolithic op amp, with a typical −3dB bandwidth of 1.1GHz at a gain of +2. This wideband op amp supports rise and fall times less than 1ns, settling time of 6ns (to 0.2%) and slew rate of 2500V/µs. The
    Original PDF
    LF444 Quad Low Power JFET Input Operational
    LF444 Quad Low Power JFET Input Operational Amplifier General Description Features The LF444 quad low power operational amplifier provides many of the same AC characteristics as the industry standard LM148 while greatly improving the DC characteristics of the LM148. The amplifier has the same bandwidth, slew
    Original PDF
    stc05ie150hv
    STC05IE150HV Emitter Switched Bipolar Transistor ESBT® 1500 V - 5 A - 0.12 Ω Features PRELIMINARY DATA VCS(ON) IC RCS(ON) 0.6 V 5A 0.12 W ■ High voltage / high current Cascode configuration ■ Low equivalent on resistance ■ Very fast-switch, up to 150 kHZ
    Original PDF
    m25pe80
    M25PE80 8 Mbit, low-voltage, Page-Erasable Serial Flash memory with byte alterability, 50 MHz SPI bus, standard pinout Features ■ SPI bus compatible serial interface ■ 8-Mbit Page-Erasable Flash memory ■ Page size: 256 bytes – Page Write in 11 ms (typical)
    Original PDF
    m34c02-r
    M34C02-R 2 Kbit serial I²C bus EEPROM for DIMM serial presence detect Features ■ Software data protection for lower 128 bytes ■ Two-wire I2C serial interface ■ 400 kHz transfer rates ■ Single supply voltage: – 1.8 V to 5.5 V ■ Byte and Page Write (up to 16 bytes)
    Original PDF
    psd813f2
    PSD813F2/3/4/5, PSD833F2 PSD834F2, PSD853F2, PSD854F2 Flash In-System Programmable (ISP) Peripherals For 8-bit MCUs PRELIMINARY DATA FEATURES SUMMARY ■ 5 V±10% Single Supply Voltage ■ Up to 2Mbit of Primary Flash Memory (8 uniform sectors, 32K x 8) ■
    Original PDF
    68hc16z
    Freescale Semiconductor, Inc. M68HC16Z Series MC68HC16Z1 MC68CK16Z1 MC68CM16Z1 MC68HC16Z2 MC68HC16Z3 MC68HC16Z4 MC68CK16Z4 User’s Manual For More Information On This Product, Go to: www.freescale.com R E Q U I R E D A G R E E M E N T HC16 N O N - D I S C L O S U R E
    Original PDF
    Freescale Semiconductor MPC8349EEC Rev. 5,
    Freescale Semiconductor MPC8349EEC Rev. 5, 10/2005 Technical Data MPC8349E PowerQUICC™ II Pro Integrated Host Processor Hardware Specifications The MPC8349E contains a PowerPC™ processor core with system logic required for networking, storage, and general-purpose embedded applications. For functional
    Original PDF