22OCT2010 Search Results

marking w0 sot-23

Abstract: D771 REF02 TI
Contextual Info: D AC 7 512 DAC7571 www.ti.com SLAS374C – FEBRUARY 2003 – REVISED MAY 2006 +2.7 V to +5.5 V, I2C INTERFACE RECEIVE ONLY , VOLTAGE OUTPUT, 12-BIT DIGITAL-TO-ANALOG CONVERTER FEATURES DESCRIPTION • • • • • • • The DAC7571 is a low-power, single channel, 12-bit

Contextual Info: SN54LV07A, SN74LV07A HEX BUFFERS/DRIVERS WITH OPEN-DRAIN OUTPUTS SCES337J − MAY 2000 − REVISED OCTOBER 2010 D 2-V to 5.5-V VCC Operation D Typical VOLP Output Ground Bounce D D D D <0.8 V at VCC = 3.3 V, TA = 25°C Typical VOHV (Output VOH Undershoot)

AN3027

Abstract: 100w SMPS PFC 100W zener diode L6563 L6563H L6563S STF7NM50N smps transformer design calculations for pwm for pfc
Contextual Info: AN3027 Application note How to design a transition-mode PFC pre-regulator with the L6563S and L6563H Introduction The transition-mode TM technique is widely used for power factor correction in low and middle power applications such as lamp ballasts, high-end adapters, flatscreen TVs and

Contextual Info: SN54LV07A, SN74LV07A HEX BUFFERS/DRIVERS WITH OPEN-DRAIN OUTPUTS SCES337J − MAY 2000 − REVISED OCTOBER 2010 D 2-V to 5.5-V VCC Operation D Typical VOLP Output Ground Bounce D D D D <0.8 V at VCC = 3.3 V, TA = 25°C Typical VOHV (Output VOH Undershoot)

Contextual Info: SN54LV07A, SN74LV07A HEX BUFFERS/DRIVERS WITH OPEN-DRAIN OUTPUTS SCES337J − MAY 2000 − REVISED OCTOBER 2010 D 2-V to 5.5-V VCC Operation D Typical VOLP Output Ground Bounce D D D D <0.8 V at VCC = 3.3 V, TA = 25°C Typical VOHV (Output VOH Undershoot)

SOT23 JEDEC

Abstract: R1 SOT23
Contextual Info: TLV2401, TLV2402, TLV2404 FAMILY OF 880-nA/Ch RAIL-TO-RAIL INPUT/OUTPUT OPERATIONAL AMPLIFIERS WITH REVERSE BATTERY PROTECTION SLOS244B – FEBRUARY 2000 – REVISED NOVEMBER 2000 D D D D D D D Micro-Power Operation . . . < 1 µA/Channel Input Common-Mode Range Exceeds the

l6563

Abstract: AN3027 emi calculation excel sheet smps Power Supply Schematic Diagram L6563H AN-3027-6 L6563S STF7NM50N L4981 PFC L6563S-TM
Contextual Info: AN3027 Application note How to design a transition-mode PFC pre-regulator with the L6563S and L6563H Introduction The transition-mode TM technique is widely used for power factor correction in low and middle power applications such as lamp ballasts, high-end adapters, flatscreen TVs and

st marking c4 diode DO-214AB

Abstract: 1N4007 SMB l3lx 1N4007 definitions 1N4007 tvs SMC MARKING ipc SMB SMC LNBTVS3-220U LNBTVS4-220S LNBTVS4-222S
Contextual Info: LNBTVS Transil for low noise block protection Features • Peak pulse power: – up to 3 kW 10/1000 µs – up to 22.5 kW (8/20 µs) ■ Breakdown voltage range: from 23.1 V to 30 V ■ Low clamping factor ■ Unidirectional with low VF (VF = 1.2 V at 3 A)

Contextual Info: TLV2401, TLV2402, TLV2404 FAMILY OF 880-nA/Ch RAIL-TO-RAIL INPUT/OUTPUT OPERATIONAL AMPLIFIERS WITH REVERSE BATTERY PROTECTION SLOS244B – FEBRUARY 2000 – REVISED NOVEMBER 2000 D D D D D D D Micro-Power Operation . . . < 1 µA/Channel Input Common-Mode Range Exceeds the

LPDDR 8Gb

Abstract: PowerVR sgx 545 DM3725CBP100 ARMv7 neon CBC 548 A 4AA6 DM3730 PO22
Contextual Info: DM3730, DM3725 www.ti.com SPRS685B – AUGUST 2010 – REVISED OCTOBER 2010 DM3730, DM3725 Digital Media Processors Check for Samples: DM3730, DM3725 1 DM3730, DM3725 Digital Media Processors 1.1 Features 123456 • DM3730/25 Digital Media Processors: – Compatible with OMAP 3 Architecture

Contextual Info: BurrĆBrown Products from Texas Instruments ADS7866 ADS7867 ADS7868 SLAS465 – JUNE 2005 1.2-V, 12-/10-/8-BIT, 200-KSPS/100-KSPS, MICRO-POWER, MINIATURE ANALOG-TO-DIGITAL CONVERTER WITH SERIAL INTERFACE FEATURES • • • • • • • • • • •

N25Q064A13ESE40F

Abstract: N25Q064A13 N25Q064 N25Q064A13ESE N25Q064a numonyx N25Q064A13ESE40 N25Q N25Q064A13EF640E 3A0F
Contextual Info: N25Q064 64-Mbit 3 V, multiple I/O, 4-Kbyte subsector erase, XiP enabled, serial flash memory with 108 MHz SPI bus interface Features „ SPI-compatible serial bus interface „ 108 MHz maximum clock frequency „ 2.7 V to 3.6 V single supply voltage „ Supports legacy SPI protocol and new Quad

Contextual Info: DAC6571 www.ti.com SLAS406B – DECEMBER 2003 – REVISED AUGUST 2005 +2.7 V to +5.5 V, I2C INTERFACE, VOLTAGE OUTPUT, 10-BIT DIGITAL-TO-ANALOG CONVERTER FEATURES DESCRIPTION • • • • • • • The DAC6571 is a low-power, single-channel, 10-bit buffered voltage output digital-to-analog converter

Contextual Info: ST6-EPB ST6 EPROM programmers Data brief Features • Programming of ST6 devices with EPROM or OTP memory ■ Dedicated EPB for each ST6 microcontroller family with support for all corresponding packages ■ In-situ programming ■ Parallel or serial connection to host PC

A67Y

Contextual Info: BurrĆBrown Products from Texas Instruments ADS7866 ADS7867 ADS7868 SLAS465 – JUNE 2005 1.2-V, 12-/10-/8-BIT, 200-KSPS/100-KSPS, MICRO-POWER, MINIATURE ANALOG-TO-DIGITAL CONVERTER WITH SERIAL INTERFACE FEATURES • • • • • • • • • • •

IRF9350

Abstract: Tachometer circuit 2011 H2920 2N3904 2N3906 IRF532 UC1625 UC2625 UC3625 brushless motor 10kW
Contextual Info: UC1625 UC2625 UC3625 www.ti.com SLUS353B – NOVEMBER 2003 – REVISED APRIL 2007 Brushless DC Motor Controller FEATURES • • • • • • • • • • • DESCRIPTION Drives Power MOSFETs or Power Darlingtons Directly 50-V Open Collector High-Side Drivers

QFN-48

Abstract: TLV320AIC3106 TLV320AIC3106IRGZR TLV320AIC3106IZQE TLV320AIC3106IZQER
Contextual Info: TLV320AIC3106 www.ti.com. SLAS509E – DECEMBER 2006 – REVISED DECEMBER 2008 LOW-POWER STEREO AUDIO CODEC FOR PORTABLE AUDIO/TELEPHONY

DRV8801RTYR

Abstract: DRV8800 DRV8800RTYR DRV8800RTYT DRV8801
Contextual Info: DRV8800 DRV8801 www.ti.com SLVS855E – JULY 2008 – REVISED OCTOBER 2010 DMOS FULL-BRIDGE MOTOR DRIVERS Check for Samples: DRV8800, DRV8801 FEATURES • • 1 • • • • • • • • 2 Low ON-Resistance [Rds ON ] Outputs Overcurrent Protection Motor Lead Short-to-Supply Protection

INA211

Abstract: INA220 INA209 INA210 INA212 INA213 MSOP-10 INA220BIDGS 399F
Contextual Info: INA220 www.ti.com SBOS459D – JUNE 2009 – REVISED SEPTEMBER 2010 High or Low Side, Bi-Directional CURRENT/POWER MONITOR with Two-Wire Interface Check for Samples: INA220 FEATURES DESCRIPTION • • • • • The INA220 is a current shunt and power monitor

Contextual Info: DAC6571 www.ti.com SLAS406B – DECEMBER 2003 – REVISED AUGUST 2005 +2.7 V to +5.5 V, I2C INTERFACE, VOLTAGE OUTPUT, 10-BIT DIGITAL-TO-ANALOG CONVERTER FEATURES DESCRIPTION • • • • • • • The DAC6571 is a low-power, single-channel, 10-bit buffered voltage output digital-to-analog converter

Contextual Info: TS3DS26227 www.ti.com SCDS224B – JUNE 2008 – REVISED OCTOBER 2010 HIGH-BANDWIDTH DUAL SPDT DIFFERENTIAL SIGNAL SWITCH WITH INPUT LOGIC TRANSLATION Check for Samples: TS3DS26227 FEATURES APPLICATIONS • • • • • • • • • • • • • •

scl0

Contextual Info: PCA9518 www.ti.com SCPS132B – JUNE 2006 – REVISED OCTOBER 2010 2 EXPANDABLE FIVE-CHANNEL I C HUB Check for Samples: PCA9518 FEATURES 1 • • • • • • • • • Expandable Five-Channel Bidirectional Buffer 400-kHz Fast I2C Bus Operating VCC Range of 3 V to 3.6 V

TRANSISTOR SMD MARKING CODE SAW

Abstract: 2F2 SMD Transistor
Contextual Info: ADS5400-SP www.ti.com SLAS669 – SEPTEMBER 2010 12-Bit, 1-GSPS Analog-to-Digital Converter Check for Samples: ADS5400-SP FEATURES • 1 • • • • • • • • • • • 1-GSPS Sample Rate 12-Bit Resolution 2.1 GHz Input Bandwidth SFDR = 65 dBc at 1.2 GHz

Contextual Info: bq24351 www.ti.com SLUSA62A – OCTOBER 2010 – REVISED NOVEMBER 2010 Over-Voltage and Over-Current Charger Protection IC With Integrated Charging FET and LDO Mode Check for Samples: bq24351 FEATURES 1 • 2 • • • • Robust Protection – Input Over-Voltage Protection