101FT Search Results

Contextual Info: CA-CM-PS-CFTR CAN-Bus PUR Shielded Cable with Terminating Resistor, Page 1 of 1 Description Straight CAN-Bus connector connected to a CAN-Bus right angle connector with a built-in terminating resistor in a PUR polyurethane shielded cable. The 120 ohm terminating resistor is connected across pin 4 and pin 5.

Contextual Info: CA-CFTR-PS-NC CAN-Bus PUR Shielded Cable with Leads and Terminating Resistor, Page 1 of 2 Description CAN-Bus right angle RA connector with PUR (polyurethane) shielded cable and wire leads. This cable has a built-in 120 ohm terminating resistor across pin 4 and pin 5. This cable is typically used to connect a single T7-1CAN to the CANA-232/CANA-485 CAN adapter. The cable may also be used with the RS232 and RS485

EATON CM20A

Abstract: A5 GNE mosfet Hall sensor 44e 402 2N8491 FTG 1087 S TRIAC BCR 10km FEB3T smd transistor marking 352a sharp EIA 577 sharp color tv schematic diagram MP-130 M mh-ce 10268
Contextual Info: Table of Contents N E W A R K E L E C T R O N IC S “Where serving you begins even before you call” Newark Electronics is a UNIQUE broadline distributor of electronic components, dedicated to provid­ ing complete service, fast delivery and in-depth inventory. Our main

Contextual Info: CA-CFTR-PS-NC CAN-bus PUR Shielded Cable with Leads Terminating , Page 1 of 2 Description CAN-Bus right angle (RA) connector with PUR (polyurethane) shielded cable and wire leads. This cable has a built-in 120 ohm terminating resistor across pin 4 and pin 5. This cable is typically used to connect a single T7-1CAN to the CANA-232/CANA-485 CAN adapter. The cable may also be used with the RS232 and RS485

Contextual Info: ThomasiBetts D e s c r ip t io n /A p p lic a t io n FLEXSTRIP Jumpers are multi­ conductor board-to-board interconnect devices, pre-plated and ready to use without wire stripping, cutting to length, or solder preparation. They provide a convenient, reliable alternative to

Contextual Info: Preliminary Information Terminal Voltage ±5V X9CMME E2POT Digitally Controlled Potentiometer FEATURES DESCRIPTION • Compatible with X9MME • Low Power CMOS —Active Current, 3 mA Max —Standby Current, 500 pA Max • 99 Resistive Elements —Temperature Compensated

Contextual Info: CA-CM-PS-CFR CAN-Bus PUR Shielded Cable Page 1 of 1 Description CAN-Bus straight connector connected to a CAN-Bus right angle RA connector via PUR (polyurethane) shielded cable. This cable should be employed between CAN-Bus devices in the middle sections of a daisychained CAN-Bus network; the cable that connects to the last device should employ a CA-CM-PS-CFTR cable

thyristor TAG 8506

Abstract: nais inverter vf 7f operation manual 922AA1Y-A4P optek A400 817 Sprague 513D sprague 926c Sprague 195P Rapa relay 12vdc triac tag 8948 Mascot 719
Contextual Info: TABLE OF CONTENTS Catalog Number 11Q New For 1989! • Over 7,900 New Products • 13 New M anufacturers PRODUCT INDICES tiamp*,'fminei forskSockets ' Solder Equipment endTtfob ] vriHp\< lint Equipment, Panel Meters, Aejulpmant, i A P R E M IE R C o m p an y

inclinometer

Contextual Info: CA-CM-PS-CFR CAN-Bus / RA CAN-Bus PUR Shielded Cable, Page 1 of 1 Description CAN-Bus straight connector connected to a CAN-Bus right angle RA connector via PUR (polyurethane) shielded cable. This cable should be employed between CAN-Bus devices in the middle sections of a daisychained CAN-Bus network; the cable that connects to the last device should employ a CA-CM-PS-CFTR cable

CD4042A

Contextual Info: CD4042A Types COS/MOS Quad Clocked "0" Latch D, The RCA-CD4042A types contain four latch and POLARITY levels defined above are circuits. each strobed by a common clock. present When a CLOCK transition occurs positive for POLARITY = 0 and negative Complementary buffered outputs are available from each circuit. The impedance of the

Contextual Info: CA-CM-PS-CFTR CAN-Bus / RA CAN-Bus PUR Shielded Cable Terminating , Page 1 of 1 Description Straight CAN-Bus connector connected to a CAN-Bus right angle connector with a built-in terminating resistor in a PUR (polyurethane) shielded cable. The 120 ohm terminating resistor is connected across pin 4 and pin 5.

251f

Abstract: ipec101
Contextual Info: IPEC EMI/RFI TF Series CALIFORNIA MICRO DEVICES TAPPED FILTER FOR EMI/RFI NOISE SUPPRESSION Features ♦ ♦ ♦ ♦ Applications Suitable for PCMCIA interface cards inselected packages Stable resistor-capacitor network No signal delays 8 EMI/RFI protection lines/package