The SST29EE010-120-4C-EH has a minimum of 100,000 erase cycles per sector, and a minimum of 10,000 erase cycles per block.
The HOLD# pin should be driven low to pause the current operation, and driven high to resume the operation. Note that HOLD# should not be used during erase or program operations.
The recommended power-up sequence is to apply VCC first, followed by VPP (if used), and then the clock signal. The device should be in a standby state during power-up.
The device's status can be determined by polling the RY/BY# pin, which goes low during an erase or program operation and returns high when the operation is complete.
The WP# pin is a write protect pin that prevents writes to the status register. To use it, drive WP# low to enable write protection, and drive it high to disable write protection.
