The maximum voltage that can be applied to the input pins is the supply voltage (VCC) + 0.3V. Exceeding this voltage can cause damage to the device.
To prevent oscillation, ensure that the input signals are properly filtered and decoupled, and that the output is properly loaded. Additionally, consider adding hysteresis to the comparator by adding a small amount of positive feedback from the output to the non-inverting input.
The minimum input voltage required for the comparator to function correctly is typically around 1.5V to 2V, depending on the specific application and the desired accuracy. However, the device can operate down to 0V, but with reduced accuracy and speed.
No, the LM339M is a comparator, not a voltage regulator. It is designed to compare two input voltages and output a digital signal indicating which input is higher. It is not designed to regulate voltage and should not be used as a substitute for a voltage regulator.
The pull-up resistor value depends on the specific application and the load connected to the output. A general rule of thumb is to choose a value between 1kΩ and 10kΩ. A higher value will reduce power consumption but may increase the rise time of the output signal.
LM339M datasheet
by Texas Instruments
