Part Number
    Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    TRIMPOT DATASHEET BO Search Results

    Documents mentioning TRIMPOT DATASHEET BO

    Document Partial File Text Tags Type PDF
    wld3343
    WLD3393 WLD3343 NOT INCLUDED GENERAL DESCRIPTION: Use the WLD3393 Evaluation Board to rapidly prototype a complete laser diode control system using the cutting edge technology of the WLD3343 Laser Diode Driver. Onboard switches, connectors, and trimpots make
    Original PDF
    pid-1500
    PID-1500 Thermoelectric & Resistive Heater Plug-n-Play Temperature Controller GENERAL DESCRIPTION: The PID-1500 Linear Bipolar, Thermoelectric Temperature Controller provides ultra-stable, low noise temperature control from a single output DC supply. The on-board, 12-turn Temperature
    Original PDF
    sy88953l
    SY88953L Evaluation Board 3.3V, 10.7Gbps CML Limiting Post Amplifier with High-Sensitivity TTL SD General Description The SY88953L evaluation board enables fast and thorough evaluation of the SY88953L post amplifier. The board is an easy to use single supply design
    Original PDF
    post amplifier
    SY88303BL Evaluation Board 3.3V, 3.2Gbps CML Limiting Post Amplifier with Wider Loss-of-Signal Detection Range General Description Features The SY88303BL evaluation board enables fast and thorough evaluation of the SY88303BL CML Lomiting Post Amplifier. The board is an easy-to-use, single
    Original PDF
    SY88149HL Evaulation Board 3.3V 1.25Gbps
    SY88149HL Evaulation Board 3.3V 1.25Gbps Burst-Mode Limiting Amplifier with Ultra-Fast Signal Assert Timing General Description Features The SY88149HL evaluation board enables fast and thorough evaluation of the SY88149HL. The board is an easy-to-use and is designed to be driven by a
    Original PDF
    sy88053al
    SY88053AL Evaluation Board 3.3V, 12.5Gbps CML Limiting Post Amplifier with Crosspoint Adjustment General Description Pre-power-up Configuration The SY88053AL evaluation board enables fast and thorough evaluation of the SY88053AL. The board is an easy-to-use, single supply design, designed to be driven
    Original PDF
    Bourns® Consumer Trimming Potentiometers Short
    Bourns® Consumer Trimming Potentiometers Short Form Brochure t0609_open_frame_sf.indd 1 06/10/16 14:46:53 Applications • Air conditioners • Camcorders • Metal detectors • Breadmakers • Electronics for cameras • Power tools • Coffee/tea makers
    Original PDF
    aat3174
    EV-128 AAT3174 EVAL: High Current, High Efficiency Charge Pump Introduction The AAT3174 EVAL board demonstrates the functionality of the AAT3174 and its application as a high current white LED flash driver. The device consists of a tri-mode charge pump with load switch (1X), fractional (1.5X),
    Original PDF
    SY88307BL Evaluation Board 3.3V, 2.7Gbps PECL
    SY88307BL Evaluation Board 3.3V, 2.7Gbps PECL Limiting Post Amplifier with Wider Loss-of-Signal Detection Range General Description Features The SY88307BL evaluation board enables fast and thorough evaluation of the SY88307BL. The board is an easy-to-use, single supply design, designed to be
    Original PDF
    aat3172
    EV-127 AAT3172 EVAL: High Current LED Flash Driver Charge Pump IC Introduction The AAT3172 EVAL board demonstrates the functionality of the AAT3172 and its application as a high current white LED flash driver. The device consists of a tri-mode charge pump with load switch (1X), fractional (1.5X),
    Original PDF
    ptc500
    DATASHEET AND OPERATING GUIDE PTC5000/PTC10000 PCB-Mount Temperature Controllers FEATURES AND BENEFITS • Drive ±5 or ±10 amps of TEC or heater current Single supply operation: 5 to 30 VDC Small package: 2.32” x 2.15” x 3.85”
    Original PDF
    DN-102 Design Note UCC3972 BiCMOS Cold Cathode
    DN-102 Design Note UCC3972 BiCMOS Cold Cathode Fluorescent Lamp Driver Controller, Evaluation Board and List of Materials By Eddy Wells vided in Table 2. As explained in the text that follows, the board components can be easily modified to implement alternate dimming techniques and to operate with higher voltage lamps.
    Original PDF
    Trimming Potentiometer Application Note Effects
    Trimming Potentiometer Application Note Effects of Setting the Wiper at End Set on Cermet Resistors By Anna Melissa Tiangco Bourns® Trimpot® Division, Application Engineer Introduction Bourns® trimming potentiometers are designed and tested to operate under extreme conditions.
    Original PDF
    pm9607ap
    Application Note: Energy Meter Evaluation Module sames PM9607AP INTRODUCTION meter configurations possible with the SA9607M using the PM9607AP module. Note that the values of the current transformer’s resistor values need to change to make some of the rated conditions possible. This will be covered in the
    Original PDF
    PacMon – Battery Pack Monitor and Charger
    PacMon – Battery Pack Monitor and Charger Interface  Battery supervision. Warning, charged, and critical states. Charge control and balancing. Dashboard status LEDs. Programmable charger voltage and current. +12V Drive and +12V Charge modes.
    Original PDF
    HTC Series Low Profile, Efficient Temperature
    HTC Series Low Profile, Efficient Temperature Controllers GENERAL DESCRIPTION FEATURES The advanced and reliable circuitry of the HTC series achieves 0.0009°C temperature stability. Its small, low profile package is ideal for designs with space constraints. The linear, PI control loop offers
    Original PDF
    ucc3972
    DN-102 Design Note UCC3972 BiCMOS Cold Cathode Fluorescent Lamp Driver Controller, Evaluation Board and List of Materials By Eddy Wells vided in Table 2. As explained in the text that follows, the board components can be easily modified to implement alternate dimming techniques and to operate with higher voltage lamps.
    Original PDF
    User Guide UG:007 Constant Current (CC)
    User Guide UG:007 Constant Current (CC) Demonstration Board Contents Page Introduction 1 Features 2 General 3-7 Test Procedure 8-15 Bill of Material 16 Ordering Info Summary 17 The Constant Current (CC) Demonstration Board described in this document shows how to use a
    Original PDF
    User Guide UG:007 Constant Current (CC)
    User Guide UG:007 Constant Current (CC) Demonstration Board Contents Page Introduction 1 Features 2 General 3-7 Test Procedure 8-15 Bill of Material 16 Ordering Info Summary 17 The Constant Current (CC) Demonstration Board described in this document shows how to use a
    Original PDF
    ad676
    Evaluation Board GENERAL DESCRIPTION The AD676/EB is an evaluation board for the AD676 16-bit sampling ADC. Careful attention to layout and circuit design combined with analog and digital prototyping areas, allows the user to easily and effectively evaluate the AD676 for applica­
    OCR Scan PDF
    MEGATRONICS v3.0 DATASHEET Author Bart Meijer
    MEGATRONICS v3.0 DATASHEET Author Bart Meijer Date 10th of June 2014 Document version 1.2 ReprapWorld.com Megatronics Datasheet – Reprapworld.com 1 PRODUCT OVERVIEW Megatronics is based on many famous open-source products including: Arduino Mega, RAMPS, SD Ramps. Therefor this product is an already proven design. It
    Original PDF