TRANSFORMER THOMSON Search Results

PEB2236

Abstract: 431 at PEB2235 STLC5432 TEW5376 TEW5376-1 TEW5376-2 TEW5376-3
Contextual Info: CEPT/T1 TEW5376 is designed to be used either as a transmit or as a receive transformer in the ISDN primary rate access network, for the following devices. Siemens SGS-THOMSON TEW5376 Input/Output Transformer When in transmit mode, connect the two primary windings in

UMEC UT21615

Abstract: ut21615 ut21711 UT21624 ut21521 UT21624-TS UT21816 PSB2086 UT21802 PSB2084
Contextual Info: ISDN SO-INTERFACE TRANSFORMER/MODULE ¡E The SO-interface is used to connect the network termination devices NT’S and consumer terminal equipments(TE'S). ¡E The transmission pulse mask and impedance according to CCITT(ITU-T)I.430. ISDN-IC/SO Interface Transformer Selection

TOPSWITCH AN-17

Abstract: AN-17 topswitch nec2501 THREE PHASE AC EI ISOLATION TRANSFORMER TURNS DETAIL TOPSwitch 11 pin flyback transformer CIRCULAR flyback transformer design nec2501-h TOP202 flyback transformer lg
Contextual Info: Flyback Transformer Design For TOPSwitch® Power Supplies Application Note AN-17 When developing TOPSwitch flyback power supplies, transformer design is usually the biggest stumbling block. Flyback transformers are not designed or used like normal transformers. Energy is stored in the core. The core must be

G002

Abstract: datasheet for central tapped transformer T636 MT8930 PEB2080 ST5420 T5035 T7903 TP3420 Pulse Transformer DC resistance
Contextual Info: ISDN S-INTERFACE TRANSFORMER Through Hole, Single, 3000 Vrms ! NEW Meets the pulse waveform template of CCITT I.430 when recommended transformer and chip pair are used Industry standard footprint 3 KV, reinforced to IEC950 and certified by BABT 5 mA ∆ Idc - Ideal for NT1 applications

PE-67501

Abstract: ST5420 t636 MT8930 PEB2080 T5035 T7903 TP3420 ka 2186 Pulse T5035
Contextual Info: ISDN S-INTERFACE TRANSFORMER Through Hole, Single, 3000Vrms Meets the pulse waveform template of CCITT I.430 when recommended transformer and chip pair are used Industry standard footprint 5mA ΔIdc - Ideal for NT1 applications Electrical Specifications @ 25°C — Operating Temperature 0°C to 70°C

SD5411

Abstract: PEB2091 TPW4670 TPW4670-1 transformer Thomson
Contextual Info: ISDN U-BUS Input/Output Transformer The TPW4670 transformer is designed to interface with the subscribers premises NT and the 2- wire line side of the Central Office Equipment (LT) in the ISDN Network. TPW4670 TPW4670 meets the electrical specifications of ANSI TI.6011988 and is approved for the

T-13219G

Abstract: 850C 13219g
Contextual Info: U Interface Transformer 2B1Q Coding Applications Designed for use with SGS-Thomson SD 5411 Turns Ratio ( + 3 % ) (Line : Chip) 1.50 : 1 REINFORCED INSULATION PARAMETER MIN. MAX. UNITS Primary Inductance (Line Side) 14.1 15.9 mH Primary DC Resistance 16 ohms

T-13219

Abstract: 13219 2b1q transformers 850C
Contextual Info: U Interface Transformer 2B1Q Coding Applications Designed for use with SGS-Thomson SD 5411 Turns Ratio ( + 3 % ) (Line : Chip) 1.50 : 1 PARAMETER MIN. MAX. UNITS Primary Inductance (Line Side) 14.1 15.9 mH REINFORCED INSULATION Primary DC Resistance 16 ohms

AN406/0591

Abstract: 2018a TEA2018A TEA2019 an086
Contextual Info: SGS-THOMSON iy TEA 2018A CURRENT MODE SWITCHING POWER SUPPLY CONTROL CIRCUIT > DIRECT DRIVE OF THE EXTERNAL SWITCHING TRANSISTOR ' POSITIVE AND NEGATIVE OUTPUT CUR­ RENTS UP TO 0.5 A ' CURRENT LIMITATION ' TRANSFORMER DEMAGNETIZATION SENSING FULL OVERLOAD AND SHORT-CIRCUIT

T-13210G

Abstract: 850C
Contextual Info: U Interface Transformer 2B1Q Coding Applications Designed for use with SGS-Thomson SD 5411 Turns Ratio ( + 3 % ) (Line : Chip) 1.50 : 1 PARAMETER MIN. MAX. UNITS Primary Inductance (Line Side) 14.1 15.9 mH Primary DC Resistance 16 ohms Secondary DC Resistance

T-13210

Abstract: 13210 850C
Contextual Info: U Interface Transformer 2B1Q Coding Applications Designed for use with SGS-Thomson SD 5411 Turns Ratio ( + 3 % ) (Line : Chip) 1.50 : 1 PARAMETER MIN. MAX. UNITS Primary Inductance (Line Side) 14.1 15.9 mH Primary DC Resistance 16 ohms Secondary DC Resistance

STLC5411

Abstract: 13216 T-13216 850C RESIStance 100 OHMS
Contextual Info: U Interface Transformer 2B1Q Coding Applications Designed for use with SGS-Thomson STLC5411 Turns Ratio ( + 3 % ) (Line : Chip) PARAMETER MIN. MAX. UNITS 32.90 37.10 mH Primary DC Resistance 10.0 ohms Secondary DC Resistance 5.0 ohms Primary Inductance (Line Side) 1

6112

Abstract: MC145472 MC145572 TP3410 6110
Contextual Info: ISDN U-Bus Input / Output Transformer 6110 -6114 6110 series transformers are designed and approved for the following ISDN U-interface devices: • Motorola MC145572 MC145472 6110 6114 • National TP3410 6112 • Thomson SD 5411 6111 MECHANICAL SCHEMATIC A

Contextual Info: SGS-THOMSON TEA2018A CURRENT MODE SWITCHING POWER SUPPLY CONTROL CIRCUIT • DIRECT DRIVE OF THE EXTERNAL SWITCHING TRANSISTOR ■ POSITIVE AND NEGATIVE OUTPUT CUR­ RENTS UP TO 0.5 A ■ CURRENT LIMITATION ■ TRANSFORMER DEMAGNETIZATION SENSING ■ FULL OVERLOAD AND SHORT-CIRCUIT

TD310IN

Contextual Info: SGS-THOMSON TD310 0MDD S [l[LIi®M R!lD®@ TRIPLE IGBT/MOS DRIVER THREE POWER IGBT/MOS AND PULSE TRANSFORMER DRIVERS CURRENT SENSE COMPARATOR WITH 1ms INHIBITION TIME FUNCTION INSTANTANEOUS SIGNAL TRANSMISSION 0.6 Amp PER CHANNEL PEAK OUTPUT CURRENT CAPABILITY

Contextual Info: /T T SGS-THOMSON *7M, HD ilLiOTMOlg® TD310 TRIPLE IGBT/MOS DRIVER • THREE POWER IGBT/MOS AND PULSE TRANSFORMER DRIVERS ■ CURRENT SENSE COMPARATOR WITH 1ms INHIBITION TIME FUNCTION ■ INSTANTANEOUS SIGNAL TRANSMISSION ■ 0.6 Amp PER CHANNEL PEAK OUTPUT

ST5410

Abstract: 13205 T-13205 TP 3410 850C
Contextual Info: U Interface Transformer 2B1Q Coding Applications Designed for use with National TP 3410, SGS-Thomson ST5410 Turns Ratio ( + 3 % ) (Line : Chip) PARAMETER MIN. MAX. UNITS 25.38 28.62 mH Primary DC Resistance 10.0 ohms Secondary DC Resistance 5.0 ohms Primary Inductance (Line Side) 1

Contextual Info: /T T SGS-THOMSON “ ‘J m« TD 3 0 0 15V TRIPLE • THREE POWER IGBT/MOS OR PULSE TRANSFORMER DRIVERS ■ CURRENT SENSE COMPARATOR WITH 1ms INHIBITION TIME FUNCTION ■ INSTANTANEOUS SIGNAL TRANSMISSION ■ 0.6 Amp PER CHANNEL PEAK OUTPUT CURRENT CAPABILITY

TD300IN

Abstract: motor driver two phase SGS-Thomson High voltage power amplifier output voltage range
Contextual Info: SGS-THOMSON ßMDD S [i[LIi®M RDD®@ TD300 15V TRIPLE IGBT/MOS DRIVER • THREE POWER IGBT/MOS OR PULSE TRANSFORMER DRIVERS ■ CURRENT SENSE COMPARATOR WITH 1ms INHIBITION TIME FUNCTION ■ INSTANTANEOUS SIGNAL TRANSMISSION ■ 0.6 Amp PER CHANNEL PEAK OUTPUT

TEA2019

Abstract: NTCC TEA2018A ic 810 pin diagram
Contextual Info: SGS-THOMSON TEA2019 I CURRENT MODE SWITCHING POWER SUPPLY CONTROL CIRCUIT • DIRECT DRIVE OF THE EXTERNAL SWITCH­ ING TRANSISTOR ■ POSITIVE AND NEGATIVE OUTPUT CUR­ RENTS UP TO 0.5A ■ CURRENT LIMITATION ■ TRANSFORMER DEMAGNETIZATION AND POWER TRANSISTOR SATURATION SENS­

AN406/0591

Abstract: TEA2019 TEA2018A
Contextual Info: SGS-THOMSON J T E A 2019 CURRENT MODE SWITCHING POWER SUPPLY CONTROL CIRCUIT • DIRECT DRIVE OF THE EXTERNAL SWITCH­ ING TRANSISTOR ' ■ POSITIVE AND NEGATIVE OUTPUT CUR­ RENTS UP TO 0.5A ■ CURRENT LIMITATION ■ TRANSFORMER DEMAGNETIZATION AND POWER TRANSISTOR SATURATION SENS­

ELECTRONIC TRANSFORMER FOR A 12V HALOGEN LAMP

Abstract: electronic transformer halogen 12v DIAC 220v electronic transformer halogen 12v 50W transformer 220V to 12V BUL38D 220V to 12V transformer 12v electronic transformer RECTIFIER transformer AC 220V to Ac 12V 220V to 12V AC transformer
Contextual Info: f Z 7 SCS-THOMSON * * J M RiilD ii®l!LI©lfi©ffi!lD gS APPLICATION NOTE ELECTRONIC TRANSFORMER FOR A 12V HALOGEN LAMP by P. Fichera, R. Scollo 1. INTRODUCTION Lighting that uses halogen lamps is commonly found in residential environments, where it offers a warm

TD3001

Abstract: motor driver two phase SGS-Thomson THOMSON IGBT TD300IN AN461 TD300 sgs thomson
Contextual Info: SGS-THOMSON TD300 R ilD(g[S@i[L[l(§TnM R!lD(g@ 15V TRIPLE IGBT/MOS DRIVER • THREE POWER IGBT/MOS OR PULSE TRANSFORMER DRIVERS ■ CURRENT SENSE COMPARATOR WITH 1 ms INHIBITION TIME FUNCTION ■ INSTANTANEOUS SIGNAL TRANSMISSION ■ 0.6 Amp PER CHANNEL PEAK OUTPUT

18NL

Abstract: TX3036 PEB 22554 TX1301 t1180nl LXT6155 T1180 T6074 T1095NL t1213
Contextual Info: Telecommunications Products TELECOMMUNICATIONS PRODUCTS Pulse is a leading provider of magnetics for telecom infrastructure equipment, customer premises equipment, audio interface applications, and emerging applications such as VoIP. Our broad portfolio of transformers and integrated transformer modules