THERMISTOR 5 OHM Search Results

NTC Thermistor 100 Ohm

Abstract: NTC 100 Ohm Thermistor 1M1002 thermistor ntc 05 thermistor ntc 22 NTC Thermistor 2,2 Ohm NTC Thermistor body temperature measurement using thermistor Precision Thermistors Probes thermistor ntc characteristic
Contextual Info: Selecting NTC Thermistors Vishay Dale HOW TO SELECT AN NTC THERMISTOR 1. Dissipation Constant D.C. The dissipation constant is the amount of power (expressed in milliwatts) required to self-heat the thermistor suspended by its two inch leads in still air

3DD102

Contextual Info: Description Ketema Rodan NTC Disc thermistors are available in resistances from 1.0 to 200,000 ohms. They are suitable over a range of resistance values and temperature coefficients from relatively low resistances and temperature coefficients to very high values. Resistance toler­

RHODORSIL

Abstract: of thermistor 10K ohms ntc thermistor ntc 10k characteristic thermistor ntc 10k technical characteristics 10k thermistor ntc 100 ND03N00103J ND06M00152J 47V20 temperature to resistance of 10k ntc resistor
Contextual Info: NTC Thermistors General Characteristics 1 – INTRODUCTION NTC thermistors are thermally sensitive resistors made from a mixture of Mn, Ni, Co, Cu, Fe oxides. Sintered ceramic bodies of various sizes can be obtained. Strict conditions of mixing, pressing, sintering and metallization ensure an

thermistor 5k

Abstract: Melcor TEC Driver 10KW 1M1002 HY5630 dale 1m1002 thermistor TEC control circuit TEC
Contextual Info: HY5630 TEC Controller Subminiature Controller for Thermoelectric Coolers Features: Maximum Ratings: Rating Value Supply Voltage VDD +20 Volts DC Supply Voltage 2 Voltage on Pin 12 VS +12 Volts DC IS 2.5 Amperes PMAX 6 Watts TMAX/MIN 100/–20 °C TSTG –65 to +150

Contextual Info: *CESIS001* Cesiwid Inc. Globar Division P.O. Box 339 N iagara Falls, New York 14302 Telephone 716-278-2521 Fax 716-278-6270 Globar Bulk Ceramic Thermistors Product Information Globar bulk ceram ic therm istors are tem perature dependent resistors offered in a wide variety of resistance-temperature

simple temperature controlled fan using thermistor

Abstract: 5V FAN CONTROL BY USING THERMISTOR fan speed control using thermistor 12V FAN CONTROL BY USING THERMISTOR FAN CONTROL BY USING THERMISTOR
Contextual Info: FelGom Semiconductor, Inc. TC620 TC621 5V, DUAL TRIP POINT TEMPERATURE SENSORS FEATURES GENERAL DESCRIPTION • The TC620 and TC621 are programmable logic output temperature detectors designed for use in thermal manage­ ment applications. The TC620 features an on-board tem­

simple temperature controlled fan using thermistor

Abstract: TC620XEPA 5V FAN CONTROL BY USING THERMISTOR 1336K
Contextual Info: XyTelCom ▼ Semiconductor, Inc. TC620 TC621 5V, DUAL TRIP POINT TEMPERATURE SENSORS FEATURES GENERAL DESCRIPTION • The TC620 and TC621 are programmable logic output temperature detectors designed for use in thermal manage­ ment applications. The TC620 features an on-board tem­

thermopile

Abstract: roithner OTC-239 OTC-239-A microwave oven Thermistor lasertechnik 4344 vienna
Contextual Info: OTC-239 THERMOPILE INFRARED SENSOR ▓ Features The thermopile sensor consists of a series of 44 thermoelements, forming a sensitive area of 0.5 x 0.5 mm2. The sensor is hermetically sealed into a TO18 metal housing, with optical filter. This standard filter allows measurements

modulator mach zehnder

Abstract: 10 gb laser diode MACH ZEHNDER modulator MACH ZEHNDER Mach-Zehnder modulator bookham mach zehnder modulator bias control mach zehnder LCM155EW5736-64C57 lcm155ew5736 Peltier heatpump
Contextual Info: Data sheet 10 Gb/s InP Mach Zehnder Modulator with DWDM Laser The 10 Gb/s InP Mach Zehnder Modulator with DWDM Laser, containing the Bookham Technology Strained Layer MQW DFB laser chip and the InP Mach-Zehnder modulator chip, has been designed specifically for use in 10 Gb/s long distance optical

2510 connector

Abstract: Peltier module circuit 2510-AT ir thermo sensor programmable temperature controller PID loop module Keithley 2400 phoenix connector MIL-PRF-28800F class 4 2510 n IEEE488
Contextual Info: TEC SourceMeter Autotuning TEC SourceMeter The Model 2510 and 2510-AT TEC SourceMeter instruments enhance Keithley’s CW test solution for high-speed LIV light-current-voltage testing of laser diode modules. These 50W bipolar instruments were developed in close cooperation with

AN0117

Abstract: AN0142 AN0136 etalon locker LMC10NEH AN0130 mach zehnder interferometer MZ-modulator optical modulator 10Gb/s GR-468
Contextual Info: Data Sheet 10Gb/s Compact InP MZ Modulator with DWDM Laser LMC10NEG Negative Chirp - High Power The LMC10NEG product, containing the Bookham Ultra High Power Strained Layer DFB laser chip and negative chirp InP MZ modulator, has been specifically designed for use in 10

thermistor 10k 3380 0603

Abstract: NTC 15K 3950 of thermistor 4.7K ohms ntc NTC thermistor 100K 3950 NTC 4.7K of thermistor 47K ohms ntc 100k 3950 Data sheet of thermistor 47K ohms ntc 4050 ic datasheet NTC 6,8K
Contextual Info: NTH5G Series NTH5G, reflow soldering available type chip NTC Thermistor, offers high stability in environment and wide resistance range in a constant size by unique inner construction. FEATURES • 0402, 0603, 0805 package available ■ High humidity resistant due to unique inner construction

IC 741 OPAMP DATASHEET

Abstract: datasheet opamp 741 enamelled copper wire swg table IC 741 based colpitts oscillator construction BFR84 BF981 FET BFR84 pin out 741 opamp pictures of lm358 pin configuration transistor BC547 2N2222
Contextual Info: A 10 MHz Reference Oscillator Keith Gooley VK5OQ A quartz crystal oscillator in a temperature stabilised enclosure to be used as a reference for a counter or narrow-band mode receiver or transmitter at UHF/SHF The need for this reference arose in my shack when I was using a 1 GHz counter

Thermopile Sensor Circuit

Abstract: thermopile infrared signal transmission frequency Thermopile Circuit Infrared-Sensor infrared gas sensors
Contextual Info: Thermopile Infrared Sensor TP339
Features The thermopile sensor consists of a series of 116 thermoelements, forming a sensitive region size of 545m diameter . The sensor is hermetically sealed into a TO-5 metal housing, with an optical filter. This standard filter allows measurements to be made in the spectral range above 5

NRZ223

Abstract: OL3311L STM-16 JOG-00837 STM Thermistor
Contextual Info: JOG-00837 OKI Electronics Components OL3311L Rev. 2 [08. 2001] DFB-LD MODULE for OC-48 1. DESCRIPTION The OL3311L Flat Lead type DFB-LD module is a 1310nm, InGaAsP/InP laser diode coupled to a single mode fiber with a pigtail. It is designed for OC-48, STM-16 S-16.1.

pid PWM TEC

Contextual Info: Thermoelectric Cooler Controller ADN8830 FEATURES High Efficiency Small Size: 5 mm ؋ 5 mm LFCSP Low Noise: <0.5% TEC Current Ripple Long-Term Temperature Stability: ؎0.01؇C Temperature Lock Indication Temperature Monitoring Output Oscillator Synchronization with an External Signal

ptc 884 thermistor

Abstract: temperature controller circuit diagram microcontroller
Contextual Info: TC648 FAN SPEED CONTROLLER WITH AUTO-SHUTDOWN FEATURES GENERAL DESCRIPTION • TheT C 648isa sw itch m odefan speed controllerforuse with brushless DC motors. Temperature proportional speed control is accomplished using pulse width modulation PWM . A thermistor (or other voltage output temperature sensor)

MA116CT-ND

Abstract: rx-2 h-bridge FDW2520C-B
Contextual Info: a Thermoelectric Cooler Controller ADN8830 FEATURES High Efficiency Small Size: 5 mm ؋ 5 mm LFCSP Low Noise: < 0.5% TEC Current Ripple Long Term Temperature Stability: ؎0.01؇C Temperature Lock Indication Temperature Monitoring Output Oscillator Synchronization with an External Signal

103AT-2

Abstract: active suspension sensor thermistor 103AT ntc 10KW DS2714 FCX718 Ni-MH charger
Contextual Info: DS2714 Quad Loose Cell NiMH Charger www.maxim-ic.com GENERAL DESCRIPTION FEATURES The DS2714 is ideal for standalone charging of 1 to 4 AA or AAA NiMH “loose” cells. NiCd cells can also be charged. Temperature, voltage and charge time are monitored to provide proper fast charging control

TC620HMJA

Abstract: simple temperature controlled fan using thermistor THERMOSTAT SCHEMATIC ntc TC620 teledyne TC62
Contextual Info: TELEDYNE C O M P O N EN T S 3 bE J> • f i ci l ? b 02 □ 0 0 7 2 fib fi T'-ts-rs WTELEDYNE COMPONENTS TC620 TC621 SOLID STATE TEMPERATURE SENSOR FEATURES GENERAL DESCRIPTION ■ ■ ■ ■ ■ ■ ■ ■ ■ The TC620 and TC621 are solid-state temperature

Contextual Info: 19-0732; Rev 2; 12/10 KIT ATION EVALU E L B AVAILA Power-Management ICs for Single-Cell, Li+ Battery-Operated Devices Maxim’s Smart Power Selector SPS safely distributes power between an external power source (AC adapter, auto adapter, or USB source), battery, and the

certificate laser

Abstract: LC 155 bookham LC151B-20C28 LC151B-20C34 LC151B-20C57 LC151B-20C59
Contextual Info: Data sheet 4 - 155 Mb/s Single-Mode OSC Laser, 1510 nm Features Specifically designed for use as a low speed out of band optical service channel for optical amplifiers. The laser is available in a low-inductance 14-pin butterfly package with single-mode connectorized fiber-optic pigtail with

APC 2010 B

Abstract: dfb laser 1300 nm 10 DFB 1612a THERMAL ELECTRIC COOLER laser DFB 1300 laser DFB 1300 nm EMCORE Corporation
Contextual Info: DATASHEET| FEBRUARY 5, 2010 1612A/B 1310 nm DFB Laser Module The 1612A/B 1310 nm forward path DFB laser modules are designed for both broadcast and narrowcast analog applications. The highly linear, OC-48 pinout compatible devices feature options up to 31 mW of

Contextual Info: Ketema Rodan's solid state over temperature protectors are designed to sense the temperature of power transistors, heat sinks, chassis, etc. Construction consists of a small 0.2” diameter positive temperature coefficient thermistor disc attached to an anodized