EXCITATION 10V Search Results

Catalytic Converter

Contextual Info: HIGH CURRENT BRIDGE DRIVER and 4-20mA Transmitter FEATURES DESCRIPTION • SENSOR EXCITATION OF 1W • VARIABLE EXCITATION VOLTAGE: 1.5V to 5.0V The XTR501 contains a high efficiency DC/DC con­ verter and 4-20mA three wire current transmitter. It provides regulated bridge excitation, optional half

DSCA43-01

Abstract: DSCA43-02 DSCA43-03 DSCA43-04 DSCA43-05 DSCA43-06 DSCA43-07 29VDC din rail en 50022 - 35x7.5
Contextual Info: High Performance Signal Conditioners DSCA DSCA43 General Purpose Input Signal Conditioners, with DC Excitation Description Transducer excitation is provided from the module by a stable 10V source. This source is fully isolated, allowing the amplifier inputs to operate over the full range

5 pin relay 12vdc 200 ohm

Abstract: JH4051I JH4051I-AC JH Technology
Contextual Info: JH4051I PLUG-N-PLAY STRAIN GAUGE TRANSMITTER FEATURES • Input Spans as low as 0.4mV/V at 10V excitation • Offset and Nonstandard Ranges Available • Excitation Adjustable from 4 to 12V • Input/Output Isolation is Standard • Quick-Check Red/Green Output LEDs

Contextual Info: Ordering number:EN6106 Thick Film Hybrid IC _ STK740-441 ¡SAfiYOl 3.3V/5A Single Output Separate Excitation Chopper Regulator Overview Package Dimensions The STK740-441 is a separate-excitation step-down chopper regulator hybrid IC for the secondstage circuit

4130

Abstract: Model 4130 Calex 220 ac voltage regulator without transformer Ac bridge specifications transformer 220 volts 60 Hz specifications ac bridge device transformer 220 volts transducer 120 ac voltage regulator without transformer
Contextual Info: Model 4130 AC Powered Bridge Excitation Supply Features ! Rugged Easy to Use Package ! Low drift: 50 ppm/°C; Low Noise: 0.5 mV RMS ! Wide Output Range: 4 - 15 Volts with Trimpot ! High Line and Load Regulation: 0.05% max. ! Bridge Excitation Protected Against Direct

12v schematic of fluorescent lamps

Abstract: 1N4148 HV803 HV8051 HV8053 1mh inductor design
Contextual Info: HV8XX Series Application Note AN-H33 HV803, HV8051, and HV8053 EL Lamp Driver Circuits Introduction frequency of the excitation voltage. With most phosphors, the spectrum of emitted light will tend to shift towards blue with an increase in excitation frequency. Color is usually controlled,

24V to 0-10v POTENTIOMETER

Abstract: DSCA36-03 35x75 DSCA36-02 DSCA36-04 EN50081-1 DSCA36-01 humidity sensor block diagram din rail en 50022 - 35x7.5 DSCA3
Contextual Info: High Performance Signal Conditioners DSCA36 Potentiometer Input Signal Conditioners Description Potentiometer excitation is provided from the module using a precision current source. Lead compensation is achieved by matching two current paths which cancels the effects of lead resistance. The excitation current is small approx.

electrolytic capacitor 2200uF SANYO

Abstract: capacitor 2200uf 25V SANYO capacitor 2200uf stk7404 STK740 bl02rn1-r62 capacitor 2200uf 6.3v 12-pins 12 dc to 8v dc chopper electrical diagrams sanyo SIP 6PIN
Contextual Info: Ordering number:EN6106 Thick Film Hybrid IC STK740-441 3.3V/5A Single Output Separate Excitation Chopper Regulator Overview Package Dimensions The STK740-441 is a separate-excitation step-down chopper regulator hybrid IC for the secondstage circuit and optimal as a 3.3V local power supply for use in logic

Contextual Info: LVM-110 – Voltage Output, LVDT/RVDT OEM Signal Conditioner • • • • • • • • • Low cost OEM signal conditioner Very compact, open PC board design Multiple unipolar and bipolar output options DIP switch selectable gain and excitation 2.5, 5, 8 and 10kHz excitation frequencies

Contextual Info: VSX1850 500A Forward/Reverse Separate Excitation DC Motor Controller Roboteq’s VSX1850 is a high-current controller for Separate Excitation DC motors. The controller is composed of a unidirectional half-bridge capable of up to 500A for the motor’s armature, and a 25A bidirectional power bridge for the motor’s

Voltage to Current Converter dual 4-20mA

Abstract: Catalytic Flammable gas sensor CATALYTIC BEAD SENSOR 12V to 300V dc dc converter step-up pellistor pellistor circuit Voltage to Current Converter dual 4-20mA circuit Wheatstone Bridge amplifier bridge 4-20ma Voltage to Current Converter circuit 4-20mA using
Contextual Info: XTR501 HIGH CURRENT BRIDGE DRIVER and 4-20mA Transmitter FEATURES DESCRIPTION ● SENSOR EXCITATION OF 1W ● VARIABLE EXCITATION VOLTAGE: 1.5V to 5.0V ● SINGLE SUPPLY: 11.4V to 30VDC ● INRUSH CURRENT LIMITING The XTR501 contains a high efficiency DC/DC converter and 4-20mA three wire current transmitter. It

pellistor

Abstract: Wheatstone Bridge amplifier Voltage to Current Converter dual 4-20mA s Voltage to Current Converter dual 4-20mA circuit CATALYTIC BEAD SENSOR methane gas detector Voltage to Current Converter dual 4-20mA pellistor circuit gas detector GAS SENSOR for oxygen
Contextual Info: XTR501 HIGH CURRENT BRIDGE DRIVER and 4-20mA Transmitter FEATURES DESCRIPTION ● SENSOR EXCITATION OF 1W ● VARIABLE EXCITATION VOLTAGE: 1.5V to 5.0V ● SINGLE SUPPLY: 11.4V to 30VDC ● INRUSH CURRENT LIMITING The XTR501 contains a high efficiency DC/DC converter and 4-20mA three wire current transmitter. It

Contextual Info: Lamp Driver Applications HV8XX Series Application Note AN-H33 EL Lamp Driver Circuits Introduction by the type of phosphor used and the frequency of the excitation voltage. With most phosphors, the spectrum of emitted light will tend to shift towards blue with an increase in excitation frequency. Color is usually controlled, however, by

Contextual Info: Isolated, Linearized RTD Input 3B34 FEATURES Isolates, amplifies, linearizes, & protects analog input voltages from a wide variety of two-, three- and four-wire Resistor Temperature Detectors RTDs . Module provides a constant +10V bridge excitation voltage.

STRAIN GAUGE

Abstract: 0-200mV tare "strain gauge" 10VA V430 led digital panel amp volt meter isolated 4 to 20ma analog transmitter circuit visipak ohms meter panel
Contextual Info: VISIPAKTM V434 Bridge/Strain Gauge Input, Digital Indicator Provides a Digital Display from Bridge & Strain Gauge mV Inputs Description Benefits Field Configurable Input Accepts 0-30mV, 0-200mV, + 15mV and +100mV Field Configurable Excitation Source 5V, 10V & 24VDC

Contextual Info: Narrow Bandwidth Strain Gage Input 3B16 FEATURES FUNCTIONAL BLOCK DIAGRAM Interfaces, amplifies, & filters signals from 4-arm full-bridge strain-gage bridges with a resistance from 300Ω to 1 kΩ. Module provides a constant +10V bridge excitation voltage.

AC1310

Abstract: analog devices bridge for rtd LVDT Signal Conditioner 300w power amplifier circuit diagram 3B16 strain gage amplifier 3B16-00 3B16-01
Contextual Info: Narrow Bandwidth Strain Gage Input 3B16 FEATURES FUNCTIONAL BLOCK DIAGRAM Interfaces, amplifies, & filters signals from 4-arm full-bridge strain-gage bridges with a resistance from 300Ω to 1 kΩ. Module provides a constant +10V bridge excitation voltage.

STK73909

Abstract: Transformers SANYO
Contextual Info: Ordering number:ENN5008 Thick Film Hybrid IC STK73903 Self-Excitation Type Feedback Control Switching Regulator 180W Output Overview Package Dimensions The STK73903 incorporates on-chip all the power switching, amplifier, overcurrent protection and driver circuits

STK73909

Abstract: KT- 210w
Contextual Info: Ordering number:ENN5009 Thick Film Hybrid IC STK73904 Self-Excitation Type Feedback Control Switching Regulator 210W Output Overview Package Dimensions The STK73904 incorporates on-chip all the power switching, amplifier, overcurrent protection and driver circuits

Contextual Info: SILICON DESIGNS, INC Model 2265 ANALOG ACCELEROMETER MODULE ! Low-Cost, Accurate, Easy-to-Use Alternative to Piezoresistive Accelerometers ! Sensitivity Insensitive to Variations in Excitation Voltage, Temperature and Cable Resistance ! Frequency Response Insensitive to Temperature

3B20-00

Abstract: 3B20 3B20-01 AC1310
Contextual Info: AC Strain Gage, Torque Transducer Input 3B20 FEATURES Interfaces, amplifies, & filters signals from 4-arm AC bridge transducer signals ranging between 1.5mV rms & 150mV rms. Module provides an AC excitation voltage of 2V rms to 10V rms at frequencies between 1kHz & 10kHz.

Contextual Info: AC Strain Gage, Torque Transducer Input 3B20 FEATURES Interfaces, amplifies, & filters signals from 4-arm AC bridge transducer signals ranging between 1.5mV rms & 150mV rms. Module provides an AC excitation voltage of 2V rms to 10V rms at frequencies between 1kHz & 10kHz.

8010GL

Contextual Info: 1-1-2 Switching Mode Regulator IC SI-8000GL Series Compact, Separate Excitation Step-down Switching Mode Regulator IC •Features ■Absolute Maximum Ratings • DIP 8 pin package • Output current: 1.5A • High efficiency: 91% at VIN = 10V, lO = 1A, VO

Calex

Abstract: potentiometer sensor weighing balance bridge type transducer
Contextual Info: Model 463 Bridgesensor Features ! Complete Strain Gage Bridge Signal Conditioner ! Isolated 10 Volt Output ! Bridge Balance with 80% Tare Offset Capability ! Excitation Supply Capable of Driving Four Load Cells ! AC Powered ! Rugged Epoxy Encapsulated Design