C1-4 RESISTOR Search Results

OPA2662

Abstract: BUF601
Contextual Info: MP MP MPC104 C1 0 4 C1 0 4 Wide-Bandwidth 2 x 1 VIDEO MULTIPLEXER FEATURES The MPC104 consists of two identical monolithic, integrated, open-loop buffer amplifiers, which are connected internally at the output. The bipolar complementary buffers form a unidirectional transmission

capacitor 1d3

Abstract: t187 P6182 H8S-2377 t177 T159 T169 RTS232 T129 resistor 4k7
Contextual Info: 3 4 6 5 REV UVCC UVCC 1 100nF 100nF 100nF 2 C12 1 2 C5 C6 2 C4 100nF GROUND 1 UVCC 3V3 5V 2 R2 1 0R 1 GROUND 2 5-C1 5-C2 5-C1 5-C2 5-C1 R1 DNF 1 B 2 UVCC UVCC R15 1 DEVICE PIN # 5-A1 5-A1 C D DEVICE PIN # 1 2 PF7 94 93 91 NC_J1_03 NC_J1_05 3 4 *see note RESn 92

Contextual Info: Æ 7 SGS-THOMSON M54/74HC692 M54/74HC693 *JÆU HC692 DECADE COUNTER/REGISTER 3-STATE HC693 4 BIT BINARY COUNTER/REGISTER (3-STATE) 1 B1N Plastic Package M1 C1 Plastic Chip Carrier Micro Package ORDERING NUMBERS: M74HCXXX C1 M54HCXXX F1 M74HCXXX M1 M74HCXXX B1N

CAT3644

Abstract: MO-220
Contextual Info: CAT3644 4-Channel Ultra High Efficiency Quad-Mode LED Driver Description Applications • • • • LCD Display Backlight Cellular Phones Digital Still Cameras Handheld Devices NC NC GND LED1 1 LED2 C2− LED3 C2+ LED4 C1− RSET C1+ VIN High Efficiency 1.33x Charge Pump

BCR119S

Abstract: VPS05604
Contextual Info: BCR119S NPN Silicon Digital Transistor Array 4
Switching circuit, inverter, interface circuit, 5 6 driver circuit
Two galvanic internal isolated Transistors with good matching in one package
Built in bias resistor (R1=4.7k) 2 3 1 C1 B2 E2 6 5 4 VPS05604

BCR129S

Abstract: VPS05604
Contextual Info: BCR129S NPN Silicon Digital Transistor Array 4
Switching circuit, inverter, interface circuit, 5 6 driver circuit
Two galvanic internal isolated Transistors with good matching in one package
Built in bias resistor (R1=10k) 2 3 1 C1 B2 E2 6 5 4 VPS05604

Contextual Info: DATA SHEET 1/12 1. Scope of Application This data sheet is applied to the LED package, model CL-L430-C1N-A. 2. Part code CL - L430 - C1 N - A - T [1] [2] [3] [4] [1] Part Code [2] Watt class C1: 1 watt class package [3] Chromaticity range N: Corrirated color temperature 5000K

Bus Ducts layout

Contextual Info: fluii C li Application Hint 11 500kHz 30W Off-Line Switching Power Supply by George Hall Circuit Description Q1’s drain voltage to rise above C1 's voltage. IC1 voltage is now supplied from the low impedance winding of T 1 pins 3 and 4 . Line Input Alternating line voltage is rectified by D1 and filtered by C1 to

Contextual Info: DATA SHEET 1/12 1. Scope of Application This data sheet is applied to the LED package, model CL-L430-MC1N1-A. 2. Part code CL - L430 - M C1 N1 - A - T [1] [2] [3] [4] [5] [1] Part Code [2] Special features M : General color rendering index Ra 80 minimum. [3] Watt class C1: 1 watt class package

Contextual Info: DATA SHEET 1/12 1. Scope of Application This data sheet is applied to the LED package, model CL-L430-MC1L1-A. 2. Part code CL - L430 - M C1 L1 - A - T [1] [2] [3] [4] [5] [1] Part Code [2] Special features M : General color rendering index Ra 80 minimum. [3] Watt class C1: 1 watt class package

Bus Ducts layout

Contextual Info: Application Hint 11 500kHz 30W Off-line Switching Power Supply by George Hall Circuit Description Q1 's drain voltage to rise above C1 's voltage. IC1 voltage is now supplied from the low im pedance winding of T1 pins 3 and 4 . Line Input Alternating line voltage is rectified by D1 and filtered by C1 to

DS1229

Abstract: 232E DS229 DS229E DS229EN DS229N DS229S DS229SN 5V and 12V RS-232, 2 Drivers, 2 Receivers rs232 timing DIAGRAM
Contextual Info: DS229 DS229 Triple RS–232 Transmitter/Receiver FEATURES PIN ASSIGNMENT • Compatible with DS1229 C1+ 1 20 VCC V+ 2 19 GND C1– 3 18 T1OUT C2+ 4 17 R1IN C2– 5 16 R1OUT V– 6 15 T1IN • Operate from single +5V power T2OUT 7 14 T2IN • Meets all EIA–232E and V.28 specifications

TN-001

Abstract: signal conditioning circuit 4-20 mA APP-105 Application note TN-001 pressure IC SENSORS TN-001 ic PRESSURE SENSOR 4-20 mA transmitter ic current transmitter 4...20 mA pressure sensor signal conditioning tn001
Contextual Info: Application Notes 4-20 mA Circuit Note: APP-105 Revised: August 1999 Contributors: Richard Markell - Linear Technology INTRODUCTION FREQUENCY RESPONSE A signal conditioning circuit for a two-wire 4 - 20 mA Frequency response may be shaped by capacitors C1, C2 with

SP213

Abstract: SP200 SP204 SP206 SP206B SP207 SP207B SP208 SP211 SP213EA
Contextual Info: SP200/204/206/207/208/211/213 +5V High–Speed RS-232 Transceivers with 0.1µF Capacitors T3OUT 1 20 T4OUT T1OUT 2 19 T5IN T2OUT 3 18 NC T2IN 4 17 SD T1IN 5 16 T5OUT GND 6 15 T4IN VCC 7 14 T3IN C1+ 8 13 V– V+ 9 12 C2– C1– 10 11 C2+ SP200 FEATURES

232E

Abstract: DS1229 DS229 DS229E DS229EN DS229N DS229S DS229SN 5V and 12V RS-232, 2 Drivers, 2 Receivers
Contextual Info: DS229 DS229 Triple RS–232 Transmitter/Receiver FEATURES PIN ASSIGNMENT • Compatible with DS1229 C1+ 1 20 VCC V+ 2 19 GND C1– 3 18 T1OUT C2+ 4 17 R1IN C2– 5 16 R1OUT V– 6 15 T1IN • Operate from single +5V power T2OUT 7 14 T2IN • Meets all EIA–232E and V.28 specifications

Contextual Info: n COPYRIGHT BY TOP CONNECTOR ALL RIGHTS RESERVED. MECHANICAL: r 0.105 - 0.425 - 726ET SERIES MAGNETIC CIRCUIT I DIM A AA o SHIELD C1 = 1000 pF, 2kV CAPACITOR R 1 -R 4 = 75 OHMS, 1 / 1 6W RESISTORS L n R E V IS IO N S DM F /1\ \ / \ ,—0.100 2 4 6 8 —O O Q Q

RS-485

Abstract: C111 C224 SP331 RS232-E TI127
Contextual Info: SP331 Programmable Dual RS-232/RS-485 Transceiver TI4 SEL_B TX4 TX3 VCC TX1 TX2 GND C1+ V+ VDD C2+ C1– C2– V– (VSS) 1 2 3 4 5 6 7 8 9 10 11 12 13 14 SP331 • +5V Only Operation • Software Programmable RS-232 or RS-485 Selection • Four RS-232 Transceivers in RS-232 Mode

VPS05604

Contextual Info: BCR 129S NPN Silicon Digital Transistor Array 4 • Switching circuit, inverter, interface circuit, 5 6 driver circuit • Two galvanic internal isolated Transistors with good matching in one package • Built in bias resistor (R1=10kΩ) 2 3 1 C1 B2 E2

BCR169S

Abstract: VPS05604 marking WSs
Contextual Info: BCR169S PNP Silicon Digital Transistor Array 4
Switching circuit, inverter, interface circuit, 5 6 driver circuit
Two galvanic internal isolated Transistors with good matching in one package
Built in bias resistor (R1=4.7k) 2 3 1 VPS05604 C1 B2 E2

smd resistor 151

Contextual Info: 1/1 Circulators/Isolators SMD CU Series CU1S2702 SHAPES AND DIMENSIONS 27±0.3 8.5±0.5 2x20.8±0.2 3-I/O 1.5±0.1(x0.3) 5.08 0.52 28±0.3 8.4 1.6typ. 4-ø2.8 4-C1 Tolerance: ±0.5 Dimensions in mm GND 1.5 RECOMMENDED PC BOARD PATTERNS LAND SOLDER RESIST

SP332

Abstract: TI-327 C111 C224
Contextual Info: SP332 RS-232/RS-485 Multi-mode SerialTransceiver TI4 SEL_B TX4 TX3 VCC TX1 TX2 GND C1+ V+ C2+ C1– C2– V– 1 2 3 4 5 6 7 8 9 10 11 12 13 14 28 27 26 25 24 23 22 21 20 19 18 17 16 15 SP332 • +5V Only Single Supply Operation • Software Programmable RS-232 or RS-485

BCR133U

Abstract: SC74
Contextual Info: BCR133U NPN Silicon Digital Transistor Array 5
Switching circuit, inverter, interface circuit, 4 6 driver circuit
Two galvanic internal isolated Transistors 3 with good matching in one package 2
Built in bias resistor (R1=10k, R2 =10k) 1 C1 B2 E2

BCR148U

Abstract: SC74
Contextual Info: BCR148U NPN Silicon Digital Transistor Array 5
Switching circuit, inverter, interface circuit, 4 6 driver circuit
Two galvanic internal isolated Transistors 3 with good matching in one package 2
Built in bias resistor (R1=47k, R2=47k) 1 C1 B2 E2

Contextual Info: n COPYRIGHT BY TRP CONNECTOR ALL RIGHTS RESERVED. MECHANICAL: C1 = R 1 -R 4 L 1000 = pF, 2kV CAPACITOR 7 5 OHMS, 1 /1 6 W, RESISTORS n T - BBBSPnOR- — L1R G A ro e — DIM TW O - QL KZ 07APR2013 LOGO CHANGE M ATERIALS: